Penetration and stainability of modified Sato's lead staining solution.

The penetration and stainability of modified Sato's lead staining solution containing calcined lead citrate were studied. Modified Sato's lead solution was preserved for 1 week and for 2 years, each at room temperature and at 4 degrees C. Specimens were stained with these solutions to measure the stainability. After 2-min staining, specimens were stained to the depth of 1.0-1.2 microns even when there had been 2-year preservation of the staining solution. This modified solution could be preserved for a long time and good penetration and stainability could still be obtained. This solution is also suitable for the observation of semithin sections.     

Signal Detection Performance of Overlapped FFT Scheme with Additional Frames Consisting of Non-continuous Samples in Indoor Environment

Overlapped FFT has been proposed as a signal detection scheme in dynamic spectrum access to reduce the variance of the noise and improve the detection probability. However, the improvement of the detection probability in the conventional overlapped FFT is bounded with the upper limit of the overlap ratio. This paper proposes a new overlapped FFT scheme using additional frames. In the proposed scheme, in addition to the original FFT frames, new frames that consist of multiple subframes with non-continuous samples are constructed and included. It can realize the increase of the number of the FFT frames and the improvement of the detection probability compared with the conventional scheme. Numerical results through computer simulation show that the proposed scheme improves the detection probability by up to 0.07. On indoor channel models the proposed scheme also improves the detection probability. In addition, it is clarified that as the delay spread increases the detection probability reduces due to the correlation between the frames.     

A 54×54-b regularly structured tree multiplier

A 54-b×54-b parallel multiplier was implemented in 0.88-μm CMOS using the new, regularly structured tree (RST) design approach. The circuit is basically a Wallace tree, but the tree and the set of partial-product-bit generators are combined into a recurring block which generates seven partial-product bits and compresses them to a pair of bits for the sum and carry signals. This block is used repeatedly to construct an RST block in which even wiring among blocks included in wire shifters is designed as recurring units. By using recurring wire shifters, the authors can expand the level of repeated blocks to cover the entire adder tree, which simplifies the complicated Wallace tree wiring scheme. In addition, to design time savings, layout density is increased by 70% to 6400 transistors/mm², and the multiplication time is decreased by 30% to 13 ns     

Stimulated Raman amplification of 1.6-μm-band pulsed light inoptical fibers

A synchronous Raman fiber amplifier is proposed which is pumped at a wavelength around 1.55 μm by output pulses from an erbium-doped fiber amplifier. This arrangement achieves an output optical peak power exceeding 200 mW and a 3-dB net gain bandwidth of 33 nm around 1.66 μm. The Raman fiber amplifier is useful for 1.6-μm-band OTDR as it can be used in live maintenance of optical transmission networks     

Performance of handoff algorithm based on distance and RSSI measurements

The performance of a proposed handoff algorithm based on both the distance of a mobile station to neighboring base stations and the relative signal strength measurements is evaluated. The algorithm performs handoff when the measured distance from the serving base station exceeds that from the candidate base station by a given threshold and if the measured signal strength of the adjacent base station exceeds that of the serving base station by a given hysteresis level. The average handoff delay and average number of handoffs are used as criteria for performance. Numerical results are presented to demonstrate the feasibility of the distance-based handoff algorithm, including results for an additional criterion based on relative signal strength. The proposed algorithm is compared with an algorithm based on absolute and relative signal strength measurements and with a solely distance-based algorithm. It is found that the proposed handoff algorithm performs well in a log-normal fading environment when the distance estimate error is modeled by wide-sense stationary additive white Gaussian noise.     

A Power-Efficient Distributed TDMA Scheduling Algorithm with Distance-Measurement for Wireless Sensor Networks

This paper describes a power-efficient distributed TDMA slot scheduling algorithm which the slot allocation priority is controlled by distance measurement information in details. In our former proposed scheme, L-DRAND+, an extension of Lamport’s bakery algorithm for prioritized slot allocation based on the distance measurement information between nodes and a packet-based transmission power control had been applied. In this paper, we propose its enhanced scheme with a weighted rule control and state machines refinements of L-DRAND+, named L-DRAND++. This aims at the achievement of media access control methods which can construct a local wireless network practically by limiting the scope, and eliminate the redundant power consumption in the network. The proposed scheme can be shown as a possible replacement of DRAND algorithm for Z-MAC scheme in a distance-measurement-oriented manner. In addition, to evaluate the ordered node sequence determined by the algorithm, node sequence metric is proposed. By using the metric, we can evaluate protocol behaviors according to the environmental situation around the node.     

Mechanism of Ca2+ increase in myoblasts derived from chicken embryos

The mechanism of intracellular calcium ions (Ca(2+)) increase in chicken myoblasts was studied using histological, immunohistochemical, immunoblotting and Ca(2+) imaging techniques. Mononuclear myoblasts at embryonic day 12 (E12) contained myofibrils in the peripheral cytoplasm, and the sarcoplasmic reticulum was observed in the cytoplasm. Several Ca(2+)-related receptors, namely acetylcholine (ACh) receptors, dihydropyridine receptors (DHPRs) and ryanodine receptors (RyRs), were detected in the tissue as early as E12. Western blotting analyses detected one band corresponding to RyR subtype 3 (RyR3) at E12 and two bands corresponding to RyR1 and RyR3 after E13. Ca(2+) imaging of mononuclear myoblasts in vitro revealed an intense Ca(2+)-increase response to ACh stimulation, and this effect was abolished after EGTA addition to the culture medium. Nifedipine treatment also led to a lack of Ca(2+) increase in response to ACh stimulation, while ryanodine treatment led to a weak Ca(2+)-increase response. On the other hand, multinuclear myoblasts showed a Ca(2+)-increase response to ACh stimulation in the presence of not only EGTA but also nifedipine, although ryanodine treatment led to a lack of Ca(2+) increase. These results suggest that the mechanism of Ca(2+) increase in mononuclear myoblasts involves extracellular Ca(2+) entry through DHPRs, which is amplified by Ca(2+) release from the cytoplasmic Ca(2+) store, while multinuclear myoblasts mainly depend on Ca(2+) release from the cytoplasmic Ca(2+) store.     

Evaluation of both image resolution and contrast-to-noise ratio in scanning electron microscopy

The contrast-to-gradient (CG) resolution has been defined as a weighted harmonic mean of the local resolution, i.e. the length defining the object's local fine structure at each pixel position. The newly defined resolution Res is defined as 2 sigma/ sqrt 2, where 2 sigma is a sharpness factor of the image pattern obtained by the conversion 2 sigma = ARCG + B using default constants A and B. In the present study, we have extended the algorithm to change the constants from default values to calibrated ones using standard images that are same in both pattern and contrast-to-noise ratio (CNR) as the original SEM image to be evaluated. The calibrated image resolution with a weak noise dependency is evaluated with the CNR as a given parameter.     

Application of focused ion beam techniques and transmission electron microscopy to thin-film transistor failure analysis

The locations of process-induced defects in hydrogenated amorphous silicon thin-film transistors (a-Si:H TFTs), which are used as elements of active-matrix liquid crystal displays, were investigated by combining focused ion beam techniques with cross-sectional transmission electron microscopy (X-TEM). The FIB technique is applied to TFT failure analysis problems, which require considerable localised etching without inducing mechanical stress or damage at fragile failure locations. We demonstrate the manner in which these techniques are used to characterise TFT defects such as pinholes and portions of the multilayer damaged by mechanical stress. A dramatic improvement brought about by the FIB technique is the increase in temporal efficiency of sample preparations. X-TEM observations also lead to identification of the fault and analysis of its cause, which in turn lead to a marked yield improvement.     

Recovery of 80 GHz optical clock from 160 Gbit/s data using regeneratively modelocked laser diode

An 80 GHz optical clock signal was successfully recovered from a 160 Gbit/s data stream using a regeneratively modelocking scheme of a semiconductor modelocked laser (MLLD). To handle an 80 GHz electrical signal, the MLLD integrated with a high-mesa electroabsorption modulator and a W-band UTC-PD module are used in this scheme.