铝合金牺牲阳极电流效率损耗的微观分析

探针（EPMA）和能谱分析技术(EDAX)，考察了铝合金牺牲阳极的显微结构和腐蚀后的边缘形貌，讨论了电流效率和显微组织之间的关系.结果表明：晶界腐蚀引起的晶粒脱落是铝合金牺牲阳极电流效率损耗的重要原因.      

EFFECT OF COMPOSITION ON HYDROGEN EMBRITTLEMENT IN Ni-Fe FCC ALLOYS

The ductility loss and threshold stress intensity,K_(IH)during hydrogen charging were measuredfor pure Ni and four Ni-Fe fcc alloys.The results show that ductility loss in 40Ni60Fe alloyand K_(IH)a 50Ni50Fe alloy have a minimum value.The variations of the amounts of hydride,hydrogen evolution and dislocation structure with composition have been investigated.The va-riation of hydrogen embrittlement susceptibility with composition measured by ductility lossand by K_(IH)or K_(IH)/K_C can be explained by means of the synthetical effects of amount ofhydride,solutionized hydrogen and the extent of dislocation planarity on hydrogenembrittlement susceptibility.     

高纯Fe中氢损伤规律的研究

本文采用正电子湮没技术研究了高纯Fe中的氢损伤规律,实验结果表明,在0.5mol/L H_2SO_4溶液中不加毒化剂电解充氢时,产生氢损伤的临界电流密度为20 mA/cm~2;而在0.5mol/L H_2SO_4溶液中加少量As_2O_3作为毒化剂电解充氢时,即使很小的电流密度也会产生氢损伤,配合慢拉伸试验,还发现试样内部产生氢损伤以后,它将控制随后的形变和断裂过程     

EFFECT OF ALLOY ELEMENTS ON QUASIEQUILIBRIUM MICROSTRUCTURE IN Fe-Mn-Ni-Cr STEELS

The microstructures of Fe-Mn-Ni-Cr steels with medium carbon and the effect of alloy ele-ments on them have been investigated by means of X-ray diffraction quantitative phase ana-lyses,metallography and hardness tests.The volume fraction of martensite in steels quenchedat 1100℃ can be expressed as:f_M~(1100)=162.643-15.482Mn-7.36Ni-4.286(Cr+Mo+V)Based on this expression,the quasi-equilibrium microstructure diagram has been obtained.Itis shown that the effect of Mn on the austenite stability is greater than that of Ni.The equiva-lent [Ni]=2.104Mn+Ni and equivalent [Cr]=Cr+Mo+V.The driving force for martensite transformation at M_s point has been calculated to hedrastically decreased by element Mn.     

(Ⅰ+Ⅱ)复合型氢致开裂的研究

本文研究了30CrMnSiA高强钢在纯Ⅰ型、纯Ⅱ型和(Ⅰ+Ⅱ)复合型加载条件下的氢致开裂。实验表明,在1NH_2SO_4溶液中预充氢的试件在上述加载条件下均表现出氢致脆性。纯Ⅱ型氢致开裂门槛值K_(ⅡH)/K_(ⅡX)=0.27,与纯Ⅰ型门槛值K_(ⅠH)/K_(ⅠX)=0.29基本相同,而在K_Ⅱ/K_Ⅰ比值为0.27,0.4和0.81时,(Ⅰ+Ⅱ)复合型氢致开裂门槛值分别为0.36,0.41和0.37,表明纯Ⅰ型和纯Ⅱ型具有更高的氢脆敏感性。最后用自Ⅰ型加载向Ⅱ型过渡时,三轴张力和塑性变形程度这二个矛盾因素对氢致开裂的共同作用解释了上述实验结果。     

ELECTRON MICROANALYSIS FOR LASER MELTED ZONE IN 45 STEEL WITH Fe-Ni-Cr COATING

The Fe-Ni-Cr coating laver has been alloyed with 45 steel base metal by transverse.flow typeCO_2 gas laser of maximum output 5kW.The characteristics of the melted zone and the es-sence of the“bright band”has been investigated using the electron microscopy.The resultsshow that the“bright band”belongs to the melted zone and is a vertical section of the planecrystal,The width of the“bright band”equals the height of the plane crystal,which decreaseswith the increase of laser beam scanning rate and the decrease of laser power.This has beenexplained in terms of constitutional supercooling G/R.     

QUASI-EQUILIBRIUM MICROSTRUCTURES AND EFFECT OF ALLOY ELEMENTS IN Fe-Mn-Ni-Cr STEELS

本文利用X射线定量相分析及金相观察和硬度测试,考察了中碳Fe-Mn-Ni-Cr钢的组织及合金元素的作用。建立了经1100℃淬火后的马氏体体积分数与合金成分的定量关系式; f_M~(1100)=162.643-15.482Mn-7.36Ni-4.286(Cr+Mo+V)并在此基础上给出了亚平衡组织图。结果表明,Mn稳定奥氏体的作用大于Ni的作用。Ni和Cr当量分别以[Ni]=2.104Mn+Ni,[Cr]=Cr+Mo+V表示。计算了M_S点处的马氏体相变驱动力,指出Mn具有强烈降低相变驱动力的作用。     

共晶自生复合材料的晶形转变

自生复合材料的晶形转变受到成分过冷与曲面过冷两个因素的控制.非金属相具有较大的熔化熵且易形成小平面是改变领先相的因素,而领先相的改变则可能是晶形转变的根本原因.     

CERTAIN CRITERION FOR THE FORMATION OF AMORPHOUS SOLIDS

<正> 根据成核理论,当仅考虑均匀核化时,在过冷熔体中结晶成核率可用下式表示: I=N_v~°kT/(3πα_°~3η)exp(-16πα~3β/3T_rΔT_r~2) (1)其中α=(N_v~°)~(1/3)σ/ΔH_m,β=1ΔH_m/RT_m=T/T_m, ΔT_r=T_m-T/T_m.各参量分别表示:I,成核率(cm~(-3)·s~(-1);N_v~°单位体积中的分子数(cm~(-3);η,粘滞系数(P);σ,比表面能(cal·cm~(-2));ΔH_m,熔化时的焓变(cal·mol~(-1));N,阿佛加德罗常数;v,克分子体积;T,熔体温度(K);T_m,熔点(K);k,玻尔兹曼常数;R,气体常数;α_0,分子直径。     

球墨铸铁凝固过程微观组织模拟

根据热力学和凝固原理等，建立了凝固过程中热传递、溶质传递和石墨球、奥氏体形核、生长的数学物理模型，以能量最小原理为基础，考虑体积自由能和界面能的定量影响，对奥氏体晶粒的形核和生长进行了摸拟。根据所建立的模型。采用了Microsoft Visualc 6．0开发平台开发了相应的三维模似计算程序和二维动态显示程序。