Evaluation of drainage system around a lined pilot cavern for underground cryogenic LNG storage

A lined pilot cavern for underground cryogenic LNG (liquefied natural gas) storage was constructed in granite in Daejeon, Korea in 2003 and commissioned in 2004. As the hydrostatic pressure of groundwater and thermal stress due to the formation of ice lenses may damage the containment system, rock drainage around the pilot cavern is needed to maintain the stability of the containment system. Once the drainage works were completed, the level of groundwater around the pilot cavern was controlled using drainage holes to form an ice ring as a second barrier to prevent the leakage of LNG from the cavern. In order to establish the drainage system for the pilot cavern, 15 boreholes were drilled into the rock. Fractures in the rock mass around the pilot cavern were characterized to determine the most appropriate orientation for the drainage holes. The major joints acting as conduits for inflow water were designed for efficient drainage. After the 15 drainage holes were drilled and their efficiency tested during the dry season in April 2003, it was found that there was a problem with the inflow of water through the main joint along the right-hand wall of the cavern, indicating the system was less efficient on the right-hand side. Hence, three more boreholes were drilled in the correct direction on the right-hand wall of the cavern. A second drainage test was conducted during the rainy season in August. This showed some seepage into the bottom of the pilot cavern. In order to reduce this seepage, two more additional drainage holes were drilled and grouted below the concrete invert. Although the drainage system was very efficient, weak points in the system were found by testing and changes were made to the system to improve its efficiency.     

Analysis of bacterial diversity in river biofilms using 16S rDNA PCR-DGGE: methodological settings and fingerprints interpretation

Reliability of bacterial diversity assessment using polymerase chain reaction (PCR) denaturing gradient gel electrophoresis (DGGE) analysis of 16S rDNA fragments was evaluated for a particular complex microbial assemblage: river epilithic biofilm. By comparing 3 routine protocols on replicates of one river biofilm sample, we found that common DNA extraction procedures gave comparable diversity (from 28.0 to 30.7 bands detected) and community composition (> 75% of homology) despite differences in the total amount of extracted DNA (from 0.9 to 4.2 microg). Therefore methodological improvements only concerned electrophoretic separation of DNA fragments (range of denaturing gradient from 35% to 70% and migration time=18h) and standardisation of DNA amounts used (PCR-template=50 ng, gel loading=700 ng). Using such a standardised methodology we found a good reproducibility of all steps of the procedure. When an Escherichia coli strain was introduced as a contaminant in a biofilm sample, we were able to recover ribotypes from the strain. As concerns fields sampling, a satisfactory repeatability of banding patterns from neighbouring pebbles (sampling point) allowed discriminating between the biofilm intrasite variability (various points from a cross-profile). These trials confirmed that PCR-DGGE is suitable to assess a reliable genetic fingerprint of epilithic biofilms in the river. Phylogenetic analysis of 40 partial sequences of 16S rDNA from DGGE gels of two sets of river biofilms samples proved evidences for the retrieval of DNA fragments related to phototroph Eukarya. However, in both cases plastidial 16S rDNA represented less than 25% of the analysed operational taxonomic units. Taking into account that Cyanobacteria, as members of the Bacteria, were also detected, sequence analysis of relevant bands from the pattern is required to target "bacteria", i.e. the functional group of prokaryotic microorganisms to which one commonly refers as a key component in sustaining the nutrient turnover.     

Control of gold surface diffusion on si nanowires

Silicon nanowires (NW) were grown by the vapor-liquid-solid mechanism using gold as the catalyst and silane as the precursor. Gold from the catalyst particle can diffuse over the wire sidewalls, resulting in gold clusters decorating the wire sidewalls. The presence or absence of gold clusters was observed either by high angle annular darkfield scanning transmission electron microscopy images or by scanning electron microscopy. We find that the gold surface diffusion can be controlled by two growth parameters, the silane partial pressure and the growth temperature, and that the wire diameter also affects gold diffusion. Gold clusters are not present on the NW side walls for high silane partial pressure, low temperature, and small NW diameters. The absence or presence of gold on the NW sidewall has an effect on the sidewall morphology. Different models are qualitatively discussed. The main physical effect governing gold diffusion seems to be the adsorption of silane on the NW sidewalls.     

Particle sizing with a fast polar nephelometer

We reported previously the design of a polar nephelometer that uses a rotational confocal imaging setup to enable fast scanning of the scattering phase function within a field of view of 55 degrees . The full dynamic range of the detection system can be used by increasing the signal-to-noise ratio by means of averaging successive scans. The calibration of the angular response of the instrument is achieved by obtaining the transfer function of the optical detection system using Rayleigh scatterers. Accurate particle sizing of individual polystyrene spheres (ranging from 1.5 to 9 micro m in diameter) in aqueous suspension is achieved by maximizing a correlation coefficient between precalculated tables of Mie phase functions and data obtained from the polar nephelometer. Good correlation is achieved between experimental and theoretical data, proving the functioning of the instrument as a fast and convenient particle sizer.     

Estimation of polyvinyl alcohol cryogel mechanical properties with four ultrasound elastography methods and comparison with gold standard testings

Tissue-mimicking phantoms are very useful in the field of tissue characterization and essential in elastography for the purpose of validating motion estimators. This study is dedicated to the characterization of polyvinyl alcohol cryogel (PVA-C) for these types of applications. A strict fabrication procedure was defined to optimize the reproducibility of phantoms having a similar elasticity. Following mechanical stretching tests, the phantoms were used to compare the accuracy of four different elastography methods. The four methods were based on a one-dimensional (1-D) scaling factor estimation, on two different implementations of a 2-D Lagrangian speckle model estimator (quasistatic elastography methods), and on a 1-D shear wave transient elastography technique (dynamic method). Young's modulus was investigated as a function of the number of freeze-thaw cycles of PVA-C, and of the concentration of acoustic scatterers. Other mechanical and acoustic parameters-such as the speed of sound, shear wave velocity, mass density, and Poisson's ratio-also were assessed. The Poisson's ratio was estimated with good precision at 0.499 for all samples, and the Young's moduli varied in a range of 20 kPa for one freeze-thaw cycle to 600 kPa for 10 cycles. Nevertheless, above six freeze-thaw cycles, the results were less reliable because of sample geometry artifacts. However, for the samples that underwent less than seven freeze-thaw cycles, the Young's moduli estimated with the four elastography methods showed good matching with the mechanical tensile tests with a regression coefficient varying from 0.97 to 1.07, and correlations R2 varying from 0.93 to 0.99, depending on the method.     

Hole-vibronic coupling in oligothiophenes: impact of backbone torsional flexibility on relaxation energies

Density functional theory calculations together with highly resolved gas-phase ultraviolet photoelectron spectroscopy have been applied to oligothiophene chains with up to eight thiophene rings. One of the important parameters governing the charge transport properties in the condensed phase is the amount of energy relaxation upon ionization. Here, we investigate the impact on this parameter of the backbone flexibility present in oligothiophenes as a result of inter-ring torsional motions. With respect to oligoacenes that are characterized by a coplanar and rigid backbone, the torsional flexibility in oligothiophenes adds to the relaxation energy and leads to the broadening of the first ionization peak, making its analysis more complex.     

Nuclear Magnetic Resonance of Physisorbed 129Xe Used as a Probe to Investigate Porous Solids

Xenon is an inert gas with a large electronic environment that makes it sensitive to any interaction, even physical. In the case of ¹²⁹Xe isotope (spin 1/2), the resulting electronic perturbation is directly transmitted to the nucleus and, therefore, affects the nuclear magnetic resonance chemical shift. In this review, we report exhaustively up to 1996 the many applications of this technique in both fundamental and applied research in the fields of microporous and mesoporous solids.     

Long-term behavior of oil-based varnishes and paints I. Spectroscopic analysis of curing drying oils

The curing of drying oils at 60°C has been investigated by Fourier transform infrared spectroscopy and Fourier transform Raman analysis of linseed oil and poppyseed oil. In the first step, hydroperoxides are formed (broad vibration band centered around 3425 cm⁻¹) with concomitant conjugation and cis-trans isomerization of the double bonds (disappearance of cis bands at 3011 and 716 cm⁻¹, appearance of trans conjugated and trans nonconjugated bands at 987 and 970 cm⁻¹). The subsequent decomposition of hydroperoxides in the presence of oxygen leads to the formation of alcohols (nitrite band at 779 cm⁻¹ after nitrogen monoxide treatment), aldehydes (bands at 2810 and 2717 cm⁻¹ in gas phase), ketones (saturated and unsaturated at 1720 and 1698 cm⁻¹, respectively), carboxylic acids (saturated and unsaturated acid fluorides identified at 1843 and 1810 cm⁻¹ after SF₄ treatment), and peresters or γ-lactones (near 1770 cm⁻¹). A rapid decrease in the double-bond concentration is recorded when curing continues, and the formation of epoxides, characterized by a vibration band at 885 cm⁻¹, is observed. Thermolysis experiments have suggested the proposal of a reaction of addition of peroxyl radicals on the conjugated double bonds as a probable mechanism. This mechanism explains both the rapid disappearance of conjugated double bonds and the formation of epoxides as intermediate products observed in the initial step of curing.     

Simulated Microgravity Subtlety Changes Monoamine Function across the Rat Brain

Microgravity, one of the conditions faced by astronauts during spaceflights, triggers brain adaptive responses that could have noxious consequences on behaviors. Although monoaminergic systems, which include noradrenaline (NA), dopamine (DA), and serotonin (5-HT), are widespread neuromodulatory systems involved in adaptive behaviors, the influence of microgravity on these systems is poorly documented. Using a model of simulated microgravity (SMG) during a short period in Long Evans male rats, we studied the distribution of monoamines in thirty brain regions belonging to vegetative, mood, motor, and cognitive networks. SMG modified NA and/or DA tissue contents along some brain regions belonging to the vestibular/motor systems (inferior olive, red nucleus, cerebellum, somatosensorily cortex, substantia nigra, and shell of the nucleus accumbens). DA and 5-HT contents were reduced in the prelimbic cortex, the only brain area exhibiting changes for 5-HT content. However, the number of correlations of one index of the 5-HT metabolism (ratio of metabolite and 5-HT) alone or in interaction with the DA metabolism was dramatically increased between brain regions. It is suggested that SMG, by mobilizing vestibular/motor systems, promotes in these systems early, restricted changes of NA and DA functions that are associated with a high reorganization of monoaminergic systems, notably 5-HT.     

Influence of a metallic filler on polyurethane formation

The addition of metallic fillers is recognized to impart improvement of acoustic properties to polyurethane-based materials used for marine applications. The system under consideration was obtained by the reaction of a triisocyanateterminated prepolymer with 1,4-butanediol, in the presence of various concentrations of lead powder. With increasing lead content, gelation time is reduced and an Einstein-type law does not apply. The kinetics of the reaction were determined by Fourier transform infrared spectroscopy. Deviation from the classic second order is observed for the filled systems, and the higher the lead content, the more important the deviation is, showing undoubtedly the catalytic effect of the metallic powder.