High-field dielectric properties of polyethylene in the high-temperature region

Nonpolar polymers such as polyethylene or polypropylene are widely used as insulation materials, often under conditions involving strong electric fields and high temperatures. Under these conditions, the conduction loss due to DC-like carrier transport may give rise to a high-field AC dissipation factor (tan δ). This paper describes the high-field dielectric properties of polyethylene films at frequencies from 50 to 400 Hz and temperatures from room temperature to 100°C, as measured with a new type electrode design developed by the authors. In the high-temperature region, the AC dissipation current waveform at 50 Hz was also measured. At room temperature, the electric-field dependence of tan δ is almost unaffected by the frequency of the applied field. But at high temperatures and strong electric fields, tan δ tends to have a large field dependence and to be almost inversely proportional to the frequency. Thus the AC conductivity becomes independent of the frequency of the applied field in the region of strong fields and high temperatures. A theoretical analysis shows that the high-field dielectric loss is governed by two processes, namely, the dielectric relaxation loss inherent to the AC field and the DC-like carrier transport loss that becomes prominent in the high-temperature region, where AC dissipation current waveform becomes significantly nonsinusoidal.     

Kinetics of aspartame precursor synthesis catalysed by Pseudomonas aeruginosa elastase

Elastase isolated from Pseudomonas aeruginosa IFO 3455 was found to be an efficient protease to catalyse the synthesis of N-benzyloxycarbonyl-aspartyl-phenylalanine methyl ester, the precursor of the dipeptide sweetener, aspartame. The influence of methanol as a cosolvent in this synthetic reaction was investigated. It was found that the synthesis of the dipeptide precursor was most efficient in 25% (v/v) methanol, pH 7·0 at about 25°C for a reaction time of about 3 h. However, the activity of the enzyme was greatly reduced in 90% methanol. The values of K and k₂ for N-benzyloxycarbonyl-aspartic acid were 0·17 mol dm^?3 and 11·9 mol dm^?3 s^?1 respectively.     

Capability of Utilizing CYP3A5 Polymorphisms to Predict Therapeutic Dosage of Tacrolimus at Early Stage Post-Renal Transplantation

While CYP3A5 polymorphisms are used to predict the initial dosage of tacrolimus therapy, the predictive capability of genetic information for dosing at early stage post-renal transplantation is unknown. We investigated the influence of polymorphisms over time. An initial oral dose of modified-release once-daily tacrolimus formulation (0.20 mg/kg) was administered to 50 Japanese renal transplant patients every 24 h. Stepwise multiple linear regression analysis for tacrolimus dosing was performed each week to determine the effect of patient clinical characteristics. The dose-adjusted trough concentration was approximately 70% higher for patients with the CYP3A5*3/*3 than patients with the CYP3A5*1 allele before the second pre-transplantation tacrolimus dose (0.97 (0.78–1.17) vs. 0.59 (0.45–0.87) ng/mL/mg; p < 0.001). The contribution of genetic factors (CYP3A5*1 or *3) for tacrolimus dosing showed increased variation from Day 14 to Day 28 after transplantation: 7.2%, 18.4% and 19.5% on Days 14, 21 and 28, respectively. The influence of CYP3A5 polymorphisms on the tacrolimus maintenance dosage became evident after Day 14 post-transplantation, although the tacrolimus dosage was determined based only on patient body weight for the first three days after surgery. Tacrolimus dosage starting with the initial administration should be individualized using the CYP3A5 genotype information.     

Respirometer by a piezo device and its application to triage

In this paper, we present a novel respirometer using the effect of piezo devices and show its application to triage. We found that blowing on the piezo device generated several 100 mV voltage and also synchronizes with the respiration. Our detailed investigations of the phenomena showed that it was caused by the pyroelectric effect. In general, the piezo device when used as a sensing device generates output voltage in a batteryless manner and also functions as a buzzer, which can lead to a compact, simple and low-power respirometer. Here, the piezo device was used as a base of respirometer and not only as a respirometer, but also as an alarm sound generator. Thus, the proposed respirometer was realized only by one piezo device and a low-powered microprocessor driven by a small battery. We applied the respirometer to triage and realized a triage sensing system. In the system, we employed the triage priority determination procedure defined as an international standard. The triage sensing system set in a mask detects respiration and displays its condition by turning an LED on and off, synchronizing the respiration and also generating the alarm sound when the respiration falls into the pre-specified ill conditions.     

Development of ultra-deep HDS catalyst for production of clean diesel fuels

Cosmo Oil has successfully developed a new CoMo HDS catalyst, C-606A, for production of ultra-low sulfur diesel fuels. This catalyst was prepared by an impregnation method using a solution containing Co, Mo, P, and citric acid on a HY-Al₂O₃. The resulting catalyst air-dried only without calcination. The HDS activity was measured with straight-run light gas oil feedstocks under industrial hydrotreating conditions. C-606A had a three times higher HDS activity compared with the conventional CoMoP/Al₂O₃ catalyst. Commercial operation with C-606A has successfully demonstrated high performance. This catalyst has superior activity, which enables <10-ppm sulfur content in products in a commercial hydrotreater designed to produce 500-ppm sulfur diesel fuels.     

Colour and Constitution of 1,4-Naphthoquinonoid Dyes - Modified PPP MO Calculations and Substituent Effects

Calculation of the n-electron excitation energies of naphthoquinonoid dyes has been carried out by means of the Pariser—Parr—Pople (PPP) method using the variable, β,γ-approximation. A good linear correlation between the observed and calculated values for the first π-π* excitation was found for a new series of naphthoquinonoid dyes. The effect of substituents on the colour of different dyes was studied on the basis of these calculated results, i.e. HOMO—LUMO energy levels and π-electron-density changes accompanying the excitation. The intramolecular charge-transfer character of the π-π* transition was shown to be the same as occurs in some anthraquinonoid dyes.     

Sintering Behavior of Pt Metal Particles Supported on Silica-Coated Alumina Surface

The sintering behavior of Pt metal particles was studied by supporting them on silica-coated alumina. Silica coating was found to be effective for the retention of a large surface area of alumina even after calcination at elevated temperatures. Before sintering, the size of Pt metal particles on all the silica-coated aluminas, including the uncoated alumina, was identical, while the particle size was larger on silica than on alumina. After sintering the Pt catalyst at 1073 K, the particle size increased on uncoated alumina as well as on alumina coated with thicker silica layers, especially on the supports previously calcined at >1473 K. On the other hand, the size of Pt metal particles did not increase much on alumina coated with monolayer silica. The observed suppression of sintering of Pt metal particles resulted from the retention of a large surface area of alumina with a thinner silica layer. In the case of a thicker silica layer, although a large surface area was maintained after calcination at elevated temperatures, the existence of a bulk silica-like property of the support did not favor the suppression of sintering of Pt metal particles.     

Ultrastructure of Paneth cells in the intestine of various mammals

Paneth cells in the following species were observed under an electron microscope: human, rhesus monkey, hare, guinea pig, rat, nude rat, mouse, golden hamster, and insect feeder bat. Secretory granules containing homogeneous electron-dense materials were observed in the Paneth cells of humans, monkeys, hares, guinea pigs, and bats; mouse Paneth-cell granules were bipartite (central core and peripheral halo), and the Paneth cells in rats and golden hamsters had secretory granules showing various electron densities. In humans, monkeys, and bats, immature granules near the Golgi apparatus sometimes showed bipartite substructure. The number and size of secretory granules were also diverse among various animal species. Some lysosome-like bodies were commonly observed in peri- or supranuclear regions, though the size and shape of the bodies differed from cell to cell. In apical cytoplasm, small clear vesicles (100–200 nm diameter) were more-or-less observed in all species examined, and it was especially note that rat Paneth cells contained many clear vesicles. Small dense-cored vesicles (150–200 nm diameter) were rare. It is unlikely that the various ultrastructural features of Paneth cells correlate with the phylogenetical classification.     

Layer-by-layer assembly of imogolite nanotubes and polyelectrolytes into core-shell particles and their conversion to hierarchically porous spheres

Core-shell particles were prepared by the layer-by-layer (LbL) assembly of imogolite (IMO) nanotubes and poly(sodium 4-styrenesulfonate) (PSS) on polystyrene particles (diameter: 800 nm) coated preliminarily with poly(diallyldimethylammonium chloride) (PDDA). PSS and imogolite were alternately adsorbed on the particles to form core-shell particles with one to three bilayers of PSS/IMO. Macroporous hollow spheres were formed by removing polystyrene cores via heat treatment or extraction when the number of bilayers was 2 or 3. The sample formed by extraction (the number of bilayer was 3) showed only macroporosity and PSS remained in the shell, whereas the heat-treated sample showed hierarchical micro- and macroporosities. When the diameter of polystyrene particles decreased from 800 nm to 300 or 100 nm, hollow spheres were deformed because of the increase in the relative length of imogolite nanotubes against the size of polystyrene particles. Imogolite is a promising building block of hierarchically porous materials with core-shell morphologies using LbL assembly.