A 1.5-V full-swing bootstrapped CMOS large capacitive-load drivercircuit suitable for low-voltage CMOS VLSI

This paper reports a 1.5-V full-swing bootstrapped CMOS large capacitive-load driver circuit using two bootstrap capacitors to enhance the switching speed for low-voltage CMOS VLSI. For a supply voltage of 1.5 V, the full-swing bootstrapped CMOS driver circuit shows a 2.2 times improvement in switching speed in driving a capacitive load of 10 pF as compared to the conventional CMOS driver circuit. Even for a supply voltage of 1 V, this full-swing bootstrapped CMOS large capacitive-load driver circuit is still advantageous     

A BiCMOS dynamic carry lookahead adder circuit for VLSIimplementation of high-speed arithmetic unit

A BiCMOS dynamic carry lookahead circuit that is free from race problems is presented. A 16 b full-adder test circuit, which has been designed based on a 2 μm BiCMOS technology, shows a more than five times improvement in speed as compared to the CMOS Manchester carry lookahead (MCLA) circuit. The speed advantage of the BiCMOS dynamic carry lookahead circuit is even greater in a 32- or 64-b adder     

Periodontal management of gingival overgrowth in the heart transplant patient: a case report

Heart transplant patients take several medications that could affect their periodontal health. Gingival overgrowth associated with cyclosporin (immunosuppressant agent) and nifedipine (calcium channel blocker) is well documented. Candidal infections often develop because of immune suppression. This report describes the clinical and histopathological changes in the gingival tissues of a heart transplant patient and their management. The gingival tissues exhibited pronounced enlargement. The gingivae were lobulated, and the surface of the lobulations was pebbly and granular. Biopsies showed lobules of fibrous connective tissue covered by stratified squamous epithelium. The outer surfaces were dotted with numerous smaller papillations. Candidal hyphae were present in the superficial layers of the epithelium. The extensive papillary lesions appear to be related to candidiasis and constitute a condition which is best designated as papillary stomatitis. Hyperplastic gingival tissues were excised, and the patient was placed on periodic maintenance. One-year postoperative follow-up showed minor gingival growth.     

Influence of mass transfer and surface ligand heterogeneity on quantitative BIAcore binding data. Analysis of the interaction of NC10 Fab with an anti-idiotype Fab'

The interaction of monovalent Fab fragments of NC10, an antiviral neuraminidase antibody, and the anti-idiotype antibody 3-2G12 has been used as a model system to demonstrate experimentally the influence of non-ideal binding effects on BIAcore binding data. Because the association rate constant for these two molecules was found to be relatively high (about 5 x 10(5) M-1 S-1), mass transfer was recognised as a potential source of error in the analysis of the interaction kinetics. By manipulation of the flow rate and the surface density of the immobilised ligand, however, the magnitude to this error was minimised. In addition, the application of site-specific immobilisation procedures was found to improve considerably the correlation of experimental binding data to the ideal 1:1 kinetic model such that the discrepancy between experimental and fitted curves was within the noise range of the instrument. Experiments performed to measure the equilibrium constant (KD) in solution resulted in a value of similar magnitude to those obtained from the ratio of the kinetic rate constants, even those measured with a heterogeneous ligand or with a significant mass transfer component. For this system, the experimental complexities introduced by covalent immobilisation did not lead to large errors in the KD values obtained using the BIAcore.     

Cluster analysis in industrial market segmentation through artificial neural network

Market segmentation has commonly applied cluster analysis. This study intends to make the comparison of conventional two-stage method with proposed two-stage method through the simulated data. The proposed two-stage method is the combination of self-organizing feature maps and K-means method. The simulation results show that the proposed scheme is better than the conventional two-stage method based on the rate of misclassification.     

Quasi-saturation capacitance behavior of a DMOS device

This paper reports a simulation study on the capacitance characteristics of a double-diffused metal-oxide semiconductor (DMOS) device operating in the quasi-saturation region. From the analysis, the capacitance effect of the gate oxide upon the drift region cannot be modeled as an overlap capacitance, because the drain-gate/source-gate capacitances of the DMOS device may exceed the gate-oxide capacitance due to the larger voltage drop over the gate oxide than the change in the imposed gate bias when entering the quasi-saturation region. This effect can be the explanation for the plateau behavior in the gate charge plot during turn-on and turn-off of the DMOS device. Based on the small-signal equivalent capacitance model, the accumulated charge in the drift region below the gate oxide may thoroughly associate with the drain terminal in the prequasi-saturation region and with the source terminal in the quasi-saturation region     

More investigations of leakage and nonleakage conductor-backedcoplanar waveguide

Through rigorous full-wave analysis, the effective dielectric constant, normalized attenuation constant, characteristic impedance, and radiation pattern of two types of conductor-backed coplanar waveguides are obtained. The analytic results show that the leakage effect is not only controlled by the thickness and dielectric constant of the substrate but also by the slot width. The leakage power transforms to a radiation space wave and a surface wave, the transverse electric field diagrams in the substrate and the far-zone radiation pattern verify the leakage phenomenon. The first structure has the maximum radiation intensity in the endfire direction, while the second one which has more leaky waves radiates into the air, is better served as a radiating device. For both structures under the nonleakage condition, the characteristic impedance is sensitive to the change of the strip width but not the slot width. Using these properties, the nonleaky and leaky circuits can exist on the same circuit board by choosing appropriate circuit dimensions     

Protection against adoptive transfer of autoimmune diabetes mediated through very late antigen-4 integrin

The very late antigen-4 (VLA-4) integrin expressed on the surface of lymphocytes and macrophages can regulate their migration to inflammatory sites as well as control cellular activation. The role of VLA-4 in the establishment of autoimmune diabetes is not easily predicted given the multiplicity of adhesion pathways and their differential use by various cell types. The contribution of VLA-4 to insulin-dependent diabetes mellitus was investigated by administration of VLA-4-specific monoclonal antibodies (MoAb) in an adoptive transfer model of disease in NOD mice. This study shows that VLA-4-specific MoAbs profoundly inhibit the development of diabetes with protection sustained by repeated MoAb exposure. Insulitis was completely inhibited during treatment and progressed to a severe degree once MoAb treatment was suspended, yet approximately 40% of treated recipients failed to become diabetic during 1-2 months post-treatment. Although we cannot rule out depletion of a relatively minor subpopulation of cells by prolonged anti-VLA-4 MoAb exposure, this inhibition of diabetes onset by treatment with MoAbs to VLA-4 supports a dependence on VLA-4 for cellular functions leading to diabetes and demonstrates that a significant disease modifying effect can be mediated by targeting the VLA-4 integrin.     

Flows in rectangular microchannels driven by capillary force and gravity

Capillary phenomena was studied and discussed by the scholars about 200 years ago, but the progress was slow due to the limited equipment and manufacture precision of the microchannel. In recent years, because of the rapid development of MEMS and micromachining, many applications of the capillary flow is widely developing in some modern processes, such as underfilling of flip chip, flow in microfluidic chip or biochip, and a variety of other fields.     

A compact LTCC branch-line coupler UsingModified-T equivalent-circuit modelfor transmission line

In this letter, a compact branch-line coupler is proposed by making good use of the three-dimensional layout capability of the low-temperature co-fired ceramic (LTCC) substrate. This branch-line coupler is accomplished by using lumped-inductors and lumped-capacitors to realize the modified-T equivalent-circuit model for the transmission line so that the circuit size may drastically be reduced. Specifically, a very compact LTCC branch-line coupler with a size of 0.079/spl lambda//spl times/0.0717/spl lambda/ is implemented and carefully examined, where /spl lambda/ is the wavelength of the multilayer structure at the operating frequency f/sub 0/.