脂肪醇聚氧乙烯醚的厌氧与好氧生物降解性

以脂肪醇聚氧乙烯醚(AEO)为目标污染物，在等同条件下做厌氧消化污泥和好氧活性污泥对其生物降解性能的对比实验，得出了同一系列AEO分子中聚氧乙烯基与整个分子的降解难易程度的关系。表明：①污泥会对AEO分子产生吸附一脱附作用而出现假降解率，克服假降解率的干扰是准确测定AEO生物降解性的关键因素；②厌氧和好氧条件下，AEO均可降解，但厌氧降解要稍优于好氧降解；③AEO中聚氧乙烯基的单元数(n)是影响其生物降解的重要因素，相同碳链的直链烷基，生物降解率随n的增加而明显降低。     

施工项目管理与贯标工作相融合的探索与实践

由于建筑工程施工的单件性、复杂性，在工程项目实施过程中贯标工作与工程项目管理工作通常不太融合，有时甚至形成“两层皮”现象。因此，针对这一现象，在承建410t／h锅炉工程中，借贯彻2000版ISO9001标准的有力时机，进行了工程项目管理与贯标工作融合性的探索与实践，取得了较好的效果。     

竹材丙酮法木质素高效分离技术研究

在一定的温度、压力条件下,利用丙酮提取竹材中的木质素,丙酮通过蒸馏回收后,可以反复利用;而通过蒸馏,得到的高纯度的木质素是重要的化工原料,整个过程形成一个封闭循环系统,基本上无三废排放;研究结果表明:当丙酮浓度为80%,液固比为10∶1,在最高反应温度160℃下保温3h,降解木质素的效果最佳;为解决制浆造纸行业废水对环境的污染问题提出了一条新的途径。     

普钙产品转化率的数值计算方法

对影响普钙产品转化率的各种因素进行了分析,利用MATLAB 软件包得到了转化率的计算公式,提出了确定未分解磷矿的比例和由倍半氧化物引起的有效磷退化幅度的方法,为生产系统的预测和调整提供了一种途径。     

HT-730改性酚醛-丁腈胶粘剂的研制

对酚醛-丁腈胶粘剂进行改性，添加5．0％的硅烷偶联剂，改善了酚醛-丁腈胶粘剂的工艺性能，提高了粘接强度，特别是降低了酚醛-丁腈胶对环境湿度的敏感性。研制的HT-730胶在环境湿度90％时仍有很高的粘接强度，同时老化性能和适用期并没有受到影响。     

大型常压锥顶贮罐的设计

以工程实例为依据，论述国内以往较少采用的大型梁柱式支承锥顶贮罐的结构，介绍了国内外相关设计标准，给出了贮罐的典型结构－斜椽，横梁和立柱的计算公式，并用Excel电子表格编制了计算书。     

Study of different effect on foaming process of biodegradable bionolle in supercritical carbon dioxide

Microcellular foaming of biodegradable Bionolle in supercritical CO₂ has been produced. The effects of a series of variable factors, such as saturation temperature, saturation pressure, and depressurization time and step on the foam structures and density, were studied through measurement of density and SEM observation. The experimental results show that higher saturation temperatures lead to an increase in bulk densities; and different depressurization time and step result in different product cell morphology. In addition, at some saturation temperature, the orientation of the cells can be found in the product morphology. XRD experimental results show that the foaming treatment with SC CO₂ increased the crystallinity of Bionolle. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 2901–2906, 2006     

A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

Nanobubble generation and its applications in froth flotation (part Ⅲ): specially designed laboratory scale column flotation of phosphate

Froth flotation is used widely for upgrading raw phosphate. The flotation recovery of coarse phosphate (-1.18+0.425 mm) is much lower than that achieved on the -0.425+0.15 mm size fraction. Enhanced recovery of coarse phosphate particles is of great economic and environmental importance for phosphate industry. In this investigation, four different phosphate samples were aquired, characterized and tested in a specially designed laboratory-scale flotation column. Significant recovery improvement of coarse phosphate flotation was achieved using cavitation-generated nanobubble though its effects differ among the four testing phosphate samples. The laboratory-scale flotation column test results indicate that nanobubble increased P2O5 recovery by up to 10%-30% for a given Acid Insoluble (A.I.) rejection, depending on the characteristic of phosphate samples. The improvement ef-fect of nanobubble on the hard-to-float particles was more significant than that on easy-to-float particles, especially at lower col-lector dosages. Nanobubbles reduced the collector dosage by 1/3 to 1/2. Nanobubbles almost doubled the coarse phosphate flotation rate constant and increased the flotation selectivity index by up to 25%.     

OFDM快速频偏估计方法

提出一种基于前导符号为L等分结构的OFDM快速频偏估计的新方法,该方法只需一个OFDM符号作为前导符号,数据开销较小.接收端先用相关求相角的方法完成细频偏估计,再对经过细频偏补偿后的前导数据进行符号重构,然后对重构符号采用L点FFT运算,通过寻找频域信号峰值,对剩余频偏进行估计,从而完成粗频偏估计.为进一步降低系统的计算开销,采用了多级判决方式.计算机仿真表明,该方案具有计算复杂度低,估计性能较高的优点.