On the Feasibility of Growing Pb[(Zn1/3Nb2/3)0.91Ti0.09]O3 Single Crystals

Pb[(Zn_1/3Nb_2/3)_0.91Ti_0.09]O₃ (PZNT91/9) single crystals were grown by two methods: from solution using PbO as a self‐fluxing agent (SC method) and directly from the melt without fluxing (MC method). In both growth methods, an allomeric Pb[(Mg_1/3‐Nb_2/3)_0.69Ti_0.31]O₃ (PMNT69/31) single crystal was used as a seed. X‐ray diffraction patterns of ground crystals showed that phase‐pure perovskite PZNT91/9 single crystals were successfully fabricated by the above two methods. The composition of the crystals obtained by both the SC and MC methods was analyzed using X‐ray fluorescence, which confirmed that the crystal composition is close to the nominal value, although volatilization of PbO and segregation during crystal growth are inevitable. The MC PZNT91/9 crystals exhibit excellent piezoelectric properties, with the piezoelectric constant, d₃₃, in the range of 1800–2200 pC N^–1. This value is comparable to that of the SC crystals. However, the MC crystals show an abnormal dielectric behavior. In contrast with the SC crystals, in the MC crystals a much broader dielectric peak appears in the dielectric response curves, accompanied by a much lower peak temperature of around 105 °C. Furthermore, frequency dispersion is apparent over a much wider temperature range (even more apparent than in pure relaxors), where a large, i.e., about 70 °C, full width at half maximum (FWHM) for the dielectric peaks is observed in the dielectric response. It is speculated that such an unusual phenomenon correlates with defects, microinhomogeneities, and polar regions in the as‐grown MC crystals. The origins of this abnormality have not been interpreted in detail until now. However, optical observation of the domain structure confirms that both the SC and MC crystals possess complex structural states.     

Routing Correlated Data with Fusion Cost in Wireless Sensor Networks

In this paper, we propose a routing algorithm called minimum fusion Steiner tree (MFST) for energy efficient data gathering with aggregation (fusion) in wireless sensor networks. Different from existing schemes, MFST not only optimizes over the data transmission cost, but also incorporates the cost for data fusion, which can be significant for emerging sensor networks with vectorial data and/or security requirements. By employing a randomized algorithm that allows fusion points to be chosen according to the nodes' data amounts, MFST achieves an approximation ratio of 5/4log(k + 1), where k denotes the number of source nodes, to the optimal solution for extremely general system setups, provided that fusion cost and data aggregation are nondecreasing against the total input data. Consequently, in contrast to algorithms that only excel in full or nonaggregation scenarios without considering fusion cost, MFST can thrive in a wide range of applications     

基于C6711处理器cdma2000 1X系统前向信道信号的处理

在cdma20001x前向信道中,要对一段信号进行传送,一般选用QPSK调制,因为QPSK调制比QAM更适合噪音环境。采用TI6000系列的TMS320C6711芯片处理前向信道信号,可以对复杂性和实时性较高的信号做采集、量化、编码、调制等实时处理,主要功能通过软件编程实现,从而使系统具有结构灵活、可靠性高、可扩展等优点。     

IGCT 综合型电荷控制 模型的建立和仿真

以电荷控制方程而建立的IGCT综合型电荷控制模型，经关键性的关断电流和关断电压进行了仿真分析，所得结果与实际结果吻合。因此该模型是有效的，可用于IGCT的开关特性分析和集成门极电路设计。     

地震数据采集系统延迟时间研究与分析

文章分析了影响地震采集系统延迟时间的因素,并根据系统延迟的理论对产生的原因进行了论证.同时对实际生产中的测试方法进行了阐述研究和分析,提出了新的测试方法,并结合实际生产提出了合理性建议.     

Preparation, patterning and luminescent properties of nanocrystalline Gd2O3:A (A=Eu, Dy, Sm, Er) phosphor films via Pechini sol–gel soft lithography

Nanocrystalline Gd₂O₃:A (A=Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺) phosphor films and their patterning were fabricated by a Pechini sol–gel process combined with a soft lithography. X-ray diffraction (XRD), atomic force microscopy (AFM), scanning electron microscopy (SEM) and optical microscopy, UV/vis transmission and photoluminescence (PL) spectra as well as lifetimes were used to characterize the resulting films. The results of XRD indicated that the films began to crystallize at 500 °C and that the crystallinity increased with the elevation of annealing temperatures. Uniform and crack free non-patterned phosphor films were obtained by optimizing the composition of the coating sol, which mainly consisted of grains with an average size of 70 nm and a thickness of 550 nm. Using micro-molding in capillaries technique, we obtained homogeneous and defects-free patterned gel and crystalline phosphor films with different stripe widths (5, 10, 20 and 50 μm). Significant shrinkage (50%) was observed in the patterned films during the heat treatment process. The doped rare earth ions (A) showed their characteristic emission in crystalline Gd₂O₃ phosphor films due to an efficient energy transfer from Gd₂O₃ host to them. Both the lifetimes and PL intensity of the rare earth ions increased with increasing the annealing temperature from 500 to 900 °C, and the optimum concentrations for Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺ were determined to be 5, 0.25, 1 and 1.5 mol% of Gd³⁺ in Gd₂O₃ films, respectively.     

宽工作电压范围单电源CMOS误差放大器

采用0.8μm标准数字CMOS工艺(VTN0=0.836V,VTP0=0.930V),设计并流片验证了具有宽工作电压范围(3～6V),可作SOC系统动态电源管理芯片内部误差放大器应用的单电源CMOS运算放大器。该误差放大器芯核同时具有适合低电压工作,并对工艺参数变化不敏感的优点。对于相同的负载情况,在3V的工作电压下,开环电压增益AD=83.1dB,单位增益带宽GB=2.4MHz,相位裕量Φ=85.2°,电源抑制比PSRR=154.0dB,转换速率Sr=2.2V/μs;在6V工作电压下,AD=85.1dB,GB=2.4MHz,Φ=85.4°,PSRR=145.3dB,Sr=3.4V/μs。     

计算机网络安全系统设计

分析了现代计算机网络所面临的威胁和各种安全问题,同时提出了在设计一个有关网络系统时应该考虑的一些安全问题,如网络安全策略与技术、网络的访问控制、网络数据加密技术、信息隐藏技术等安全问题。     

大规模定制环境下 ERP 的发展

ERP─EnterpriseResourcePlanning企业资源计划系统 ,是指建立在信息技术基础上 ,以系统化的管理思想 ,为现代企业决策层及员工提供决策运行手段的管理平台。从竞争环境的角度出发 ,提出了大规模定制已经逐渐成熟并最终取代大规模生产成为新的生产经营模式的观点 ,同时 ,分析了在大规模定制下传统ERP的局限 ,从管理和技术的角度探讨新一代ERP的特点及发展。     

加油站油品损耗的管理问题分析及解决办法

针对加油站在油品进、销、存方面因管理和人为作弊而产生的损耗大问题，提出了解决办法：各环节交接手续要严密完备；发货方实施保量运输，选择信誉好的承运方；在销售、储存方面应加强管理，推行加油站计量员、账务员集中管理，主要账表电子表格化，及时上报主管部门，执行责任追究制并与效益工资挂钩。