Structural,magnetic and magnetostrictive properties of Co1-xLixFe2O4 synthesized by cathode materials of spent Li-ion batteries

In this study, we investigated the effects of substituting Li⁺ for Co²⁺ at the B sites of the spinel lattice on the structural, magnetic and magnetostrictive properties of cobalt ferrites. The Li⁺ substituted cobalt ferrites, Co_1-xLi_xFe₂O₄, with x varying from 0 to 0.7 in 0.1 increments, were synthesized with a sol-gel auto-combustion method using the cathode materials of spent Li-ion batteries. X-ray diffraction analysis revealed that all the Co_1-xLi_xFe₂O₄ nanopowders had a single-phase spinel structure and the lattice parameters decreased with increasing Li⁺ content, which can be proved by slight shifts towards higher diffraction angle values of the (311) peak. Field emission scanning electron microscopy was used to observe the fractured inner surface of the sintered cylindrical rods and the increased porosity resulted in a decreased magnetostriction. The oxidation states of Co and Fe in the cobalt ferrite samples were examined by X-ray photoelectron spectroscopy. High resolution transmission electron microscopy micrographs showed that most particles were roughly spherical and with sizes of 25–35?nm. Li⁺ substitution had a strong effect on the saturation magnetization and coercivity, which were characterized with a vibrating sample magnetometer. The Curie temperature was reduced due to the decrease in magnetic cations and the weakening of the exchange interactions. The magnetostrictive properties were influenced by the incorporation of Li⁺ at the B sites of the spinel structure and correlated with the changes in porosity, magnetocrystalline anisotropy and the cation distribution.     

Nonlinear system identification using BBO-based multilayer perceptron network method

Microsystem Technologies - Recently, nonlinear system identification has received increasingly more attention due to its promising applications in engineering fields. It has become a challenging...     

Tensor Q-rank: new data dependent definition of tensor rank

Machine Learning - Recently, the $${ Tensor}~{ Nuclear}~{ Norm}~{ (TNN)}$$ regularization based on t-SVD has been widely used in various low tubal-rank tensor recovery tasks. However, these models...     

Flame Front Deformation Instabilities of Filtration Combustion for Initial Thermal Perturbation

The flame front deformation instability of low-velocity filtration combustion within an inert packed bed is studied based on the initial preheating non-uniformity. Based on the experimental phenomena, an initial thermal perturbation model is numerically proposed so as to predict the deformation behaviors of the flame front instabilities. The numerical prediction indicates that the assumption of an initial thermal perturbation is a feasible explanation as the cause of the flame front inclination instability. As the initial thermal perturbation increases, the phenomena of the flame front break and shrinking instabilities could easily occur at high filtration velocity or low equivalence ratio. Moreover, the evolutions of the flame front break rate and the shrinking rate are quantitatively analyzed.     

Sol-Gel Preparation and Luminescence Properties of BaMgAl10O17∶Eu2+ Phosphors

The synthesis of BaMgAl10O17∶ Eu2 (BAM) phosphors using the sol-gel method and their luminescence properties were reported. The blue-light emitting BAM was synthesized using citric acid and ethylene glycol as chelating materials. Emission of blue-light was obtained from these phosphors. The luminescent intensity increases as the temperature of heat treatment is increased. This study investigated the effects of the molar ratio of ethylene glycol to citric acid (Φ value), with respect to the phase formation and luminescence properties of BAM. The variation of the Φ value resulted in the change of the sol-gel reaction mechanism and the microstructures of the resultant powders. An increase in Φ value leads to an increase in the rate of BAM phase formation. The photoluminescent intensity of the prepared phosphors increases with heating temperatures because of enhanced crystallization.     

基于AD9851的高频高压脉冲发生器设计

当前脉冲发生器里的脉冲形成器件,大部分是用火花气隙（spark gap）和高压电子开关（high voltageswitch）.采用火花气隙充当脉冲形成器件有很多弊病：（1）火花气隙在低于1kV时,在机械和电气上不稳定,所以对低于2kV的试验电压要通过分压器来得到.     

Performance study of iSCSI-based storage subsystems

iISCSI is emerging as an end-to-end protocol for transporting storage I/O block data over IP networks. By exploiting the ubiquitous Internet infrastructure, iSCSI greatly facilitates remote storage, remote backup, and data mirroring. This article evaluates the performance of two typical iSCSI storage subsystems by measuring and analyzing block-level I/O access performance and file-level access performance. In the file-level performance study, we compare file access performance in an NAS scheme with that in an iSCSI-based SAN scheme. Our test results show that Gigabit Ethernet-based iSCSI can reach very high bandwidth, close to that of a direct FC disk access in block I/O access. However, when the iSCSI traverses through longer distance, throughput relies heavily on the available bandwidth between the initiator and the target. On the other hand, the file-level performance shows that iSCSI-based file access (SAN scheme) provides higher performance than using NFS protocol in Linux and SMB protocol in Windows (NAS scheme). However, the advantage of using iSCSI-based file accesses decreases as the file size increases. The obtained experimental results shed some light on the performance of applications based on iSCSI storage.     

有植被的河道水流紊动特性模型试验研究

通过物理模型试验,研究了有植被的河道水流紊动特性.试验结果表明,在复式断面河道滩地种植柔性植被后,滩地糙率增大,水流紊动更为剧烈,河道水流紊动强度峰值由原先的滩槽交界区转移到滩地区.滩地的水流紊动强度沿程递减;滩槽交界区的水流紊动强度沿程不断增大;主槽的水流紊动强度主要与床面糙率有关,滩地植被影响了滩地水流的归槽时间,使主槽水流流速沿程增大.     

Nd:YVO4/KTP全固化倍频激光器的研究

介绍了两种腔型结构不同的Nd:YVO4/KTP全固化倍频绿光激光器,对腔结构参数进行了优化计算;在相同的实验条件下,对这两种腔的输出和稳定性等特性进行了比较和深入分析,在此基础上得出结论,提出改进措施。该折叠腔方案已进入产品化阶段。     

渤海湾盆地济阳——临清东部煤系烃源岩形成环境

钻井、地震、测井及测试资料综合研究认为:渤海湾盆地济阳—临清东部地区石炭—二叠系主要发育一套浅海碳酸盐岩台地相灰岩、障壁—潟湖、潮坪、沼泽及三角洲相陆源碎屑岩和煤层.从纵向发育的沉积特征来看,上石炭统本溪组发育浅海台地相碳酸盐岩和浅海陆棚相(陆表海)砂泥岩,太原组主要发育障壁—潟湖、潮坪、沼泽相碳酸盐岩、陆源碎屑岩和煤的混合沉积;二叠系山西组主要发育三角洲相和三角洲平原沼泽相砂泥岩及煤,下石盒子组和上石盒子组则以发育近海陆相碎屑岩沉积为主,局部有河流沼泽的泥炭和煤发育.沉积环境总体具有自下而上、由南向北由浅海相、海陆交互相逐步过渡为陆相的基本特点.成煤环境以晚石炭世—早二叠世太原、山西期潮坪、潟湖过渡带之潮坪沼泽环境及三角洲平原沼泽环境为最佳.