Low‐loss TCP/IP header compression for wireless networks

Wireless is becoming a popular way to connect mobile computers to the Internet and other networks. The bandwidth of wireless links will probably always be limited due to properties of the physical medium and regulatory limits on the use of frequencies for radio communication. Therefore, it is necessary for network protocols to utilize the available bandwidth efficiently. Headers of IP packets are growing and the bandwidth required for transmitting headers is increasing. With the coming of IPv6 the address size increases from 4 to 16 bytes and the basic IP header increases from 20 to 40 bytes. Moreover, most mobility schemes tunnel packets addressed to mobile hosts by adding an extra IP header or extra routing information, typically increasing the size of TCP/IPv4 headers to 60 bytes and TCP/IPv6 headers to 100 bytes. In this paper, we provide new header compression schemes for UDP/IP and TCP/IP protocols. We show how to reduce the size of UDP/IP headers by an order of magnitude, down to four to five bytes. Our method works over simplex links, lossy links, multi‐access links, and supports multicast communication. We also show how to generalize the most commonly used method for header compression for TCP/IPv4, developed by Jacobson, to IPv6 and multiple IP headers. The resulting scheme unfortunately reduces TCP throughput over lossy links due to unfavorable interaction with TCP's congestion control mechanisms. However, by adding two simple mechanisms the potential gain from header compression can be realized over lossy wireless networks as well as point‐to‐point modem links. This revised version was published online in June 2006 with corrections to the Cover Date.     

Detection and Localization of Delaminations in Thin Carbon Fiber Reinforced Composites with the Ultrasonic Polar Scan

In this paper, the hybrid compliance-stiffness matrix method for simulating wave propagation in (delaminated) multilayered media with viscoelastic anisotropy has been confronted with high-quality amplitude and phase experiments on delaminated composites, obtained using the ultrasonic polar scan setup (UPS) in transmission by considering harmonic as well as pulsed ultrasound. Results are presented for multiple thin carbon/epoxy laminates with an artificial edge delamination induced by a foil insert, showing a good agreement between experimental recording and numerical modeling. The obtained results further reveal the feasibility of the harmonic UPS to detect and even locate the depth-position of multiple delaminations in fiber reinforced composites. Considering that the harmonic UPS method does not rely on the detection of different echoes like the classical C-scan, but rather expounds the conditions for efficient stimulation of guided waves in the solid, the method is found to be highly suited for inspecting thin composite materials for the presence of delaminations.     

Discrete Element Method for the thermal field: Proof of concept and determination of the material parameters

The physical behaviour of materials and complicated components is nowadays numerically predicted by using the Finite Element Method (FEM). Another method, older than the finite element idea, is the Discrete Element Method (DEM), with which it is possible to make continuum-based calculations not only in the mechanical field but also in the thermal field, as will be shown in this paper.One major drawback of the FEM is that continuum-based methods are unable to include the stochastically distributed microscopic effects in the macroscopically oriented calculations. The Discrete Element Method is one method with which these effects can be considered.For making realistic fracture and life time predictions for components at high temperatures, it is important to adapt the DEM for the thermal field. This paper describes the mathematical proof of the 2D Discrete Element Method (or Lattice Model) for the thermal field. It will specifically be shown that the heat flux inside the framework can be transferred to the heat conduction equation. Furthermore, some examples demonstrate how the heat flux can be calculated with this method and how the corresponding material parameters are found and implemented. Also, as will be shown in this paper, anisotropic or orthotropic heat flux effects can be integrated in the DEM model.     

On numerical evaluation of effective material properties for composite structures with rhombic fiber arrangements

This paper deals with unidirectional fiber reinforced composites with rhombic fiber arrangements. It is assumed, that there is a periodic structure on micro level, which can be taken by homogenization as a representative volume element (RVE) for the composite, where the composite phases have isotropic or transversely isotropic material characterizations. A special procedure is developed to handle the primary non-rectangular periodicity with common numerical homogenization techniques based on FE-models. Due to appropriate boundary conditions applied to the RVE elastic effective macroscopic coefficients are derived. Results are listed and compared with other publications and good agreements are shown. Furthermore new results are presented, which exhibit the special orthotropic behavior of such composites caused by the rhombic fiber arrangement.     

Differing haemodynamic and catecholamine responses to exercise in three groups with peripheralautonomic dysfunction: insulin-dependent diabetes mellitus, familial amyloid polyneuropathy and pure autonomic failure

BACKGROUND: The nosological status of postpartum psychoses has remained controversial because of their often 'atypical' symptomatology. A polydiagnostic approach may further clarify this issue. METHODS: In a retrospective study, we applied the ICD-10 and Leonhard's classification to 39 patients with severe postpartum psychiatric disorders. The patients were personally reexamined on average 12.5 years (6-26 years) after the onset of the illness. RESULTS: An acute onset and a polymorphous psychotic symptomatology with rapid changes characterized the majority of our cases. Unipolar depressive disorders (28%) and acute polymorphous psychotic disorders (21%) represented the largest proportions within the ICD-10-classification. Applying Leonhard's classification, over half the patients (54%) suffered from a cycloid psychosis. Among cycloid psychoses, motility psychoses clearly predominated. Schizophrenias occurred rarely (10%) according to both classifications. LIMITATIONS: Due to the unknown prevalence of the various diagnoses among women of child-bearing age, it is impossible to statistically infer a specific association between childbirth and a distinct diagnosis from our data. CONCLUSIONS: Our findings suggest that cycloid psychoses, in particular motility psychoses, account for the majority of postpartum psychoses, and do not support the hypothesis of a nosological independence of postpartum psychoses.     

Sclerosing stromal tumour of the ovary

Two cases of sclerosing stromal tumour of the ovary in young Melanesian females are described and the differential diagnosis is discussed. Sclerosing stromal tumour of the ovary is a rare benign tumour of ovarian stromal origin which is associated with endocrine activity in a few cases. One of the patients presented with signs of precocious puberty and the tumour in this patient was considered as a functioning lesion.     

Consensus statement on the diagnosis of multiple system atrophy

We report the results of a consensus conference on the diagnosis of multiple system atrophy (MSA). We describe the clinical features of the disease, which include four domains: autonomic failure/urinary dysfunction, parkinsonism and cerebellar ataxia, and corticospinal dysfunction. We set criteria to define the relative importance of these features. The diagnosis of possible MSA requires one criterion plus two features from separate other domains. The diagnosis of probable MSA requires the criterion for autonomic failure/urinary dysfunction plus poorly levodopa responsive parkinsonism or cerebellar ataxia. The diagnosis of definite MSA requires pathological confirmation.