Photonic A/D conversion using low-temperature-grown GaAs MSM switches integrated with Si-CMOS

By linking the unique capabilities of photonic devices with the signal processing power of electronics, photonically sampled analog-to-digital (A/D) conversion systems have demonstrated the potential for superior performance over all-electrical A/D conversion systems. We adopt a photonic A/D conversion scheme using low-temperature (LT)-grown GaAs metal-semiconductor-metal (MSM) photoconductive switches integrated with Si-CMOS A/D converters. The large bandwidth of the LT GaAs switches and the low timing jitter and short width of mode-locked laser pulses are combined to accurately sample input frequencies up to several tens of gigahertz. CMOS A/D converters perform back-end digitization, and time-interleaving is used to increase the total sampling rate of the system. In this paper, we outline the development of this system, from optimization of the LT GaAs material, speed and responsivity measurements of the switches, bandwidth and linearity characterization of the first-stage optoelectronic sample-and-hold, to integration of the switches with CMOS chips. As a final proof-of-principle demonstration, a two-channel system was fabricated with LT GaAs MSM switches flip-chip bonded to CMOS A/D converters. When operated at an aggregate sampling rate of 160 megasamples/s, the prototype system exhibits /spl sim/3.5 effective number of bits (ENOB) of resolution for input signals up to 40 GHz.     

Quantum-confined stark effect and ultrafast absorption dynamics in bilayer inas quantum dot waveguide

A Stark shift of 40 nm at 1340 nm in a bilayer InAs/GaAs quantum dot ridge waveguide is reported. Time-resolved measurements indicate absorption recovery times of 7 ps at -8 V. Such favourable properties are desirable for intensity and phase modulators     

A New Algorithm for the Elimination of Common Subexpressions in Hardware Implementation of Digital Filters by Using Genetic Programming

A new algorithm based on Genetic Programming (GP) for the problem of optimization of Multiple constant Multiplication (MCM) by Common Subexpression Elimination(CSE) is developed. This method is used for hardware optimization for DSP systems. A solution based on Genetic Programming is shown in this paper. The performance of the technique is demonstrated in one- and multi-dimensional digital filters with constant coefficients.     

MobileNAT: A New Technique for Mobility Across Heterogeneous Address Spaces

We propose a new network layer mobility architecture called Mobile NAT to efficiently support micro and macro-mobility in and across heterogeneous address spaces common in emerging public networks. The key ideas in this architecture are as follows: (1) Use of two IP addresses – an invariant virtual IP address for host identification at the application layer and an actual routable address at the network layer that changes due to mobility. Since physical address has routing significance only within a domain, it can be a private address and therefore, does not deplete the public IP address resource. (2) New DHCP enhancements to distribute the two addresses. (3) A new signaling element called Mobility Manager (MM) that uses Middlebox Communication (MIDCOM) framework to signal the changes in packet processing rules to the Network Address Translators (NATs) in the event of node mobility. Our proposal does not require any modifications to the access networks and can seamlessly co-exist with the existing Mobile IP mechanisms and therefore, can be used to provide seamless mobility across heterogeneous wireline and wireless networks. We report implementation details of a subset of our ideas in a testbed with Windows XP clients and Linux based NATs. Milind M. Buddhikot is a Member of Technical Staff in the Center for Networking Research at Lucent Bell Labs, Holmdel, NJ. Milind holds a Doctor of Science (D. Sc.) in computer science (July 1998) from Washington University in St. Louis, and a Master of Technology (M.Tech.) in communication engineering (December 1988) from the Indian Institute of Technology (I.I.T), Bombay. His current research interests are in the areas of systems and protocols for integrated public wireless networks, authentication and dynamic key exchange protocols, Voice-over-IP (VOIP) networks, and sensor and ad-hoc networks. He has authored over 26 research papers and 9 patent submissions in the areas of design of multimedia systems and protocols, layer-4 packet classification, MPLS path routing, authentication and dynamic key exchange, and 802.11/3G integration. Milind currently serves as the Associate Editor of the IEEE/ACM Transactions on Networking. He also served as a co-guest-editor of IEEE Network magazine’s March 2001 Special issue on Fast IP Packet forwarding and Classification for Next Generation Internet Services. He has served in the capacity of a tutorial chair for IEEE LCN 94, 95, as a publicity chair for NOSSDAV97, and as a program committee member for MMCN 2001, 2003, IEEE ICNP2002, 2003 and IEEE LCN 93-2000 conferences. Adiseshu Hari received a Doctorate in Computer Science from Washington University in St. Louis in 1999, and has since been at Bell Labs, Lucent Technologies, where he’s worked on projects related to network design and optimization. He’s currently looking at design issues in large scale SIP based VoIP networks. Kundan N. Singh received a B.E.(Hons) degree in Computer Science from Birla Institute of Technology and Science in India, M.S. in Computer Science from Columbia University, and is continuing his studies towards Ph.D. degree in the same field at Columbia University in New York City. As a research assistant in the Internet Real-Time Lab at Columbia University, he is doing research on Internet telephony, SIP-H.323 signaling gateway, unified messaging systems and multimedia conferencing. Scott Miller is the Director of the High Speed Mobile Data Research department at Bell Labs in Holmdel, New Jersey. He has B.S. and M.S. degrees in electrical engineering from Cooper Union in New York City. His current research involves the integration of 802.11 and 3G wireless data service and the related mobile networking issues concerning seamless mobility, authentication, security, roaming, and accounting. Prior to his work on 802.11/3G integration, Scott has led several systems research efforts in wireless applications, implementing novel systems for wireless messaging, speech-driven directory services, wireless instant messaging, carrier-based content billing, and multi-media content adaptation.This revised version was published online in August 2005 with a corrected cover date.     

高性能LCoS虚拟显示器的光学特性

本文叙述一种用于LCoS双瞳虚拟显示器的新型光路结构,它首次达到或超过了pSi(多晶硅)头戴装置的性能36°的视场,801的对比度,无需IPD调节(12mm出射光瞳),并且整个电-光模件的封装配合并不比奥林巴斯EyeTrek和索尼Glasstron的工业标准更复杂.     

Estimation of co-channel signals with linear complexity

To increase wireless system capacity using co-channel signals and multiple receiver antennas, we develop the partitioned Viterbi algorithm (PVA). The PVA estimation complexity increases linearly with each additional co-channel signal rather than exponentially as it does with joint maximum-likelihood sequence estimation (MLSE). The estimation problem involves multiple signals simultaneously transmitted and observed through slow-fading, frequency-selective channels. Although transmission is assumed to be in bursts according to a time-division multiple-access scheme, more than one signal can occupy the same time and frequency slot (these signals are referred to as “co-channel” signals). Separation and estimation of the symbol bursts is accomplished by exploiting channel differences, PVA estimation consists of a set of Viterbi detectors, one per signal, that operate in parallel with cross-coupling to allow approximate interference cancellation by means of tentative decisions. The forward filter of a decision feedback equalizer (DFE) is used to “prefilter” received signals prior to PVA estimation. Prefiltering delays the energy of interfering signals so that tentative decisions become reliable enough to use. Simulation results show PVA performance remains near-optimal with respect to the performance of joint MLSE     

Comparison of sensory characteristics and fatty acid composition between Wagyu crossbred and Angus steers

Angus (n = 10) and crossbred (3/4 and 7/8) Wagyu (n = 10) steers were fed a diet according to typical Japanese standards for 552 days. The steers were fed to gain approximately 0·90 kg/head/day. Fatty acid composition was determined for subcutaneous and intramuscular adipose tissue, and M. longissimus dorsi muscle. Trained sensory evaluation and a consumer triangle test were performed on M. longissimus dorsi muscle steaks. For subcutaneous and intramuscular tissue. Wagyu adipose tissue possessed higher (P < 0·05) percentages of 14:1, 16:1 and 18:1 and a lower (P < 0·05) percentage of 16:0 and 18:0 than corresponding tissues from Angus steers. Trained sensory panel analysis revealed no differences (P < 0·05) in any of the sensory traits between steaks from Wagyu crossbred and Angus steers. However, a consumer triangle test indicated that consumers can detect a difference between breeds.     

Laboratory millimeter wave measurements of atmospheric aerosols

Measurements made in an untuned resonator by Fourier Transform Spectroscopy of atmospheric aerosols are explained by a pumped phonon model due to Fröhlich.     

Block acknowledgment: redesigning the window protocol

A window protocol based on the block acknowledgment method, in which acknowledgment message has two numbers, m and n, to acknowledge the reception of all data messages with sequence numbers ranging from m to n, is discussed. In the window protocol, message sequence numbers are taken from a finite domain and both message disorder and loss can be tolerated. An initial version of the protocol that uses a simplified timeout action and unbounded sequence numbers is presented, the simplified timeout action in the protocol is replaced by a sophisticated one without disturbing the protocol's correctness, and the unbounded sequence numbers are replaced by bounded ones while preserving the protocol's correctness. Remarks concerning other variations of the protocol are also presented     

DATING AND CORRELATION OF THE BALUTI FORMATION,KURDISTAN, IRAQ: Implications for the regional recognition of a Carnian “marker dolomite”, and a review of the Triassic to Early Jurassic sequence stratigraphy of the Arabian Plate

The Baluti Formation is a lithostratigraphic unit defined at outcrop in the Zagros foldbelt in Kurdistan, North Iraq, where it consists of a thin, shale‐dominated interval between the thick carbonates of the overlying Sarki and the underlying Kurra Chine Formations. New biostratigraphic results presented in this study confirm that firstly, the Baluti shale marks the top of the Carnian at outcrop; and secondly, that the correlative subsurface shale occurs well above the base of the subsurface‐defined Butmah Formation. As such, the Butmah is not directly correlative to the Sarki as has previously been assumed, and its definition overlaps that of the Baluti and Kurra Chine Formations. These results have regional implications. A distinctive low Gamma Ray dolostone unit in the Kurra Chine A can be correlated across Kurdistan. Similar dolostones are recognised widely across the Arabian Plate and have been considered to be correlative by some workers, but not by others. This study establishes the age of this “Marker Dolomite” as late Carnian on the basis of its position below the Baluti Formation and confirms its regional development. Correlation is demonstrated to the Sefidar Dolomite (Iran), the “Muss”/Mulussa D (Syria), the upper Abu Ruweis Formation (Jordan), the Jilh Formation (Kuwait, Saudi Arabia, Oman), and the upper Gulailah Formation (UAE). Regional sequence stratigraphic studies have assigned the Marker Dolomite to different sequences in different areas. The recognition that it represents a single, regionally‐correlatable event provides the starting point for a sequence stratigraphic review based on regional log correlation and published dating. An updated sequence stratigraphic framework is presented for the Triassic to Early Jurassic, defining additional sequences (e.g. Tr55, Tr90, Tr100, J01, J05) and recognising that significant depositional breaks are associated with SBs Tr60, Tr70, Tr80, Tr100 and J01. The hiatus below Tr80 reflects a Carnian–Ladinian regional high in the Southern Gulf. This represents the barrier between the open Neo‐Tethys and the saltern in which the Carnian evaporites accumulated. The implications for petroleum exploration are discussed in the light of these revisions. There are two established Triassic plays in Iraq and Syria: firstly, in fractured carbonate reservoirs sealed by evaporites and shales, which is productive in both countries; and secondly, in fluvial sandstones sealed by interbedded shales, which is productive in Syria. A key observation regarding the carbonate play is that the main Triassic exploration target in Iraq has been the Kurra Chine B fractured carbonates, located above the main Carnian evaporites; whereas in the Syrian Palmyrides, the main discoveries are generally located below the Carnian evaporites. The sub‐evaporite fractured carbonate play is underexplored in Iraq. With regard to the clastic play, the correlations presented in this study indicate that the Mulussa F and Minjur represent a single clastic pulse, and equivalent sandstones are likely to be developed in the Sarki Formation in Central‐South Iraq which remains largely untested. Sequence correlations indicate regionally developed source rock potential at the levels of the Kurra Chine B Member and Geli Khana Formation.