Measurement of interfacial area concentration in subcooled liquid-vapour flow

In two-fluid modelling, accurate prediction of the interfacial transport of mass, momentum and energy is required. Experiments were carried out to obtain a database for the development of interfacial transport models, or correlations, for subcooled water-steam flow in vertical conduits. The experimental data of interest included the interfacial area concentration, interfacial condensation heat transfer and bubble relative velocity. This paper focuses on the interfacial area concentration. The interfacial area concentration was obtained by measuring the distributions of bubble volume and surface area as well as the area-averaged void fraction at various axial locations in subcooled water-steam condensing vertical upward flow under low flow rate and low pressure conditions. The bubble size and surface area were determined using high-speed photography and digital image processing techniques. The area-averaged void fraction was measured by a single-beam gamma densitometer. The results were compared with existing correlations, which were developed on the basis of data obtained for air-water adiabatic flows. Poor agreement between the present data and the existing correlations was obtained. Accordingly, new correlations suitable for subcooled liquid-vapour bubbly flow are proposed.     

Synthesis and characterization of tungsten disulphide films grown by pulsed-laser deposition

The synthesis and characterization of tungsten disulphide (WS₂) films grown on 440C stainless steel substrates using the 248 nm line from a KrF excimer laser are reported. Film properties could be adjusted by controlling substrate temperature and by laser or thermal anneals. X-ray photoelectron spectroscopy, glancing angle XRD, Raman spectroscopy and high-resolution scanning electron microscopy were used to evaluate film chemistry, crystallinity and morphology. Films grown at room temperature were amorphous, near stoichiometric, and had a multiplicity of chemical states. Local order and bonding were improved most dramatically through post-deposition laser anneals. Crystallite size could be increased by raising the substrate temperature during deposition and, to a lesser degree, by post-deposition thermal anneals. Local disorder was observed within the larger crystallites compared to those that were laser annealed. Crystallinity was induced in amorphous films by mechanical rubbing at room temperature under conditions where frictional heating was negligible. The degree of control over film properties provided by PLD demonstrates its value for growing/designing tribological coatings.     

Sub-100 fs Kerr lens modelocked Cr4+:YAG laser

Sub-100 fs pulse generation from a Kerr lens modelocked Cr⁴⁺ :YAG laser has been demonstrated for the first time, yielding femtosecond pulses tunable from 1.49 to 1.56 μm with pulses as short as 90 fs obtained at 1.53 μm     

A forward-looking system for planning and monitoring metrological support to an organization

The ARM-Uchet computerized system is considered, which is intended for accounting, planning, and monitoring for metrological support to an organization and has been implemented on an IBM PC AT. Schemes are given for the basic modes of operation and for the software suites, as well as the database structure.Translated from Izmeritel'naya Tekhnika, No. 7, pp. 70–71, July, 1994.     

High performance concentrators and superconcentrators usingmultiplexing schemes

Concentrators are used to interface and combine together low speed communication channels onto higher speed transmission links to alleviate transmission costs. They are also used to construct more powerful switching fabrics such as permutation and broadcast networks. Using an adaptive binary sorting network model, this paper constructs new concentrators and superconcentrators. Unlike the previously reported concentrators and superconcentrators, these new constructions are fast, and ran easily be implemented using simple switching devices. More specifically, for n inputs, they can be constructed with O(n lg lg n) constant fanin bit-level multiplexers and demultiplexers, and can be routed in O(lg² n) bit-level time     

Equal-power coordinated transmission for HDSL

In a two-channel transmission system, the signal-to-noise ratio (SNR) at the receiver can in general be different for the channels. Normally, performance will be dominated by the channel with the worst SNR, but it is possible to do much better. The general scheme proposed provides optimum performance when the SNR varies between the channels and/or when the interference is correlated, without varying the transmitted power for each channel. Simplified schemes attain nearly optimum performance under certain channel conditions     

Conditional associative learning is impaired in cerebellar disease in humans.

Eight patients with lesions restricted to the cerebellum were compared with a total of 25 age-matched controls on an reaction time (RT) task allowing the recording of simple and choice RTs as well as RTs to abstract visual patterns signifying the particular movement to be performed. In all conditions the actual movements required (either a left or a right button press) remained the same, but the cognitive requirements of the task varied. In the abstract patterns condition, the significance of the various patterns with regard to the required movement had to be learned by the Ss. The patients with cerebellar lesions were particularly impaired in this condition. It is concluded that the cerebellum is involved not just in the timing of movements but also in the decision process as to which movement should be performed under particular circumstances. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

A boost-type converter for DC-supply of fluorescent lamps

A boost type converter is described that is suitable for low-voltage DC-supply of fluorescent lamps. It has inherent lamp current limitation (ballast action) and provides the high voltage pulses and electrode heating that are required for igniting the lamp. The proposed circuit is applicable in automotive, emergency, and portable light sources.<>     

Enhanced high-frequency performance in a GaAs, self-aligned, n-JFETusing a carbon buried p-implant

C ion implantation has been employed, for the first time, to form the buried p-layer in GaAs, self-aligned, ion implanted JFETs. Comparable DC performance was seen for JFETs with C or Mg implants; however, C-backside JFETs showed superior high-frequency performance. High dose C-backside devices had a f_t of 28.3 GHz and a f_max of 43.2 GHz for a 0.5 μm gate length that were 28% and 46% higher, respectively, than comparable Mg-implanted JFETs. This enhancement is a result of the lower C_gs in the C-backside device resulting from he inherently low activation of the implanted C below the channel while the C still effectively compensated the tail of the Si-channel implant. This approach relaxes the trade-off between optimizing the DC and the AC performance for the buried p-implant in GaAs JFETs and MESFET's     

Growth trends in wide-area TCP connections

A recently completed single-site study has yielded information about how Internet traffic will evolve, as new users discover the Internet and existing users find new ways to incorporate the Internet into their work patterns. The author reviews existing statistics and studies of network growth, which show that network traffic generally grows exponentially with time, at least until the network carrying capacity is reached. He then describes how he captured and reduced the data used in this study. The following points are also addressed: the overall growth in the site's wide-area traffic; the appearance of periodic traffic; the growth in network use by individual computers or users; and the changing geographic profile of the traffic. The implications and limitations of the results are also summarizes