二甲基亚砜一步法碳纤维用聚丙烯腈原丝生产工艺

叙述了二甲基亚砜一步法（高转化）高强碳纤维用聚丙烯腈原丝生产的工艺流程。着重讨论了聚合、纺丝的工艺控制。以及工艺控制对聚丙烯腈原丝和最终碳纤维性能的影响。按此工艺生产的聚丙烯腈原丝的质量完全符合高强碳纤维生产的需要。     

甲苯稀释对AlCl3-EMIC型离子液体电镀铝工艺氢脆性的影响

采用甲苯作为AlCl3-EMIC(1-乙基-3-甲基咪唑)型离子液体的稀释剂,其中纯态离子液体由物质的量比为2∶1的无水AlCl3和EMIC组成。对比了纯态和按稀释剂与离子液体体积比为1∶1稀释后电镀铝的外观、微观形貌和氢脆性。结果表明,采用甲苯稀释离子液体虽然可以降低镀液的黏度,改善镀层外观和微观形貌,但对离子液体电镀铝工艺的氢脆性有负面影响。     

磷酸铁锂锂离子电池正极材料的研究

锂离子电池是绿色高能可充电池，具有工作电压高、比能量大、自放电小、循环寿命长、无记忆效应、无环境污染等突出优点。本文从磷酸铁锂的结构与性能、材料的制备方法、改性、粒径控制等几方面综述了近年来对橄榄石型磷酸铁锂（LiFePO4）锂离子电池正极材料的研究进展。材料的粒度大小及其分布、离子和电子的传导能力对产品的电化学性能影响很大。在制备时，采用惰性气氛、掺杂导电材料和控制晶粒生长制备粉体是获得性能优良的LiFePO4的有效方法。     

基于特征融合的调制识别增强与迁移演化

针对调制识别中单一图像的特征信息不足,区分度不够高,识别范围受限的问题。本文提出了一种基于时频图和星座图特征融合的调制识别特征增强方法,利用深度学习神经网络提取信号图像的特征,构建特征空间,通过多维特征融合,挖掘和整合不同特征的优势,增强模型算法的鲁棒性。此外运用了模型迁移的方法,仅需对分类器进行训练,大幅节约了训练时间和资源,具有很强的实时性和实用性。仿真结果显示,在0db左右的条件下,相比于单一特征图像,采用特征融合增强的方法能将信号的平均识别率提高约25%,通过模型迁移,省去了卷积神经网络的训练,所需的训练时间约为迁移前的9.6%,消耗内存约为迁移前的7.3%,同时模型的识别率损失控制在了5%以内。     

Enhanced Thermal Stability of Zinc-Based Titanate (Dielectric) Ceramics Prepared by the Modified Sol–gel Route

A multi-component substitution of Co and Ni was incorporated into ZnTiO₃ to form pure hexagonal Zn_{1− x} (Co_1/2Ni_1/2) _x TiO₃ ( x =0,0.8,0.9,1.0) dielectric ceramic powders by a modified sol–gel route, following heat treatments at 600°C for 3 h and at 800°C for 6 h. Differential scanning calorimetry measurements revealed that the order of increasing thermal stability of solid solution compound Zn_{1− x} (Co_1/2Ni_1/2) _x TiO₃ was ZnTiO₃ (945°C), Zn_0.1Ni_0.9TiO₃ (1346°C), Zn_0.1(Co_1/2Ni_1/2)_0.9TiO₃ (1390°C), and Zn_0.1Co_0.9TiO₃ (>1400°C). Both the dielectric constant and loss tangent reached a maximum at x =0.8 and then decreased with solubility, x , and measurement frequency.     

基于遗传算法优化的OCSVM双轮廓模型异常检测算法

针对Modbus工业总线协议的特殊性及工控数据样本的不均衡性,利用单类支持向量机（OCSVM）分别构建正常OCSVM模型和异常OCSVM模型,即双轮廓模态来模拟系统通信的正常模式和异常模式,从而实现工控系统异常检测。同时将遗传算法优化自变量降维应用于工控网络入侵检测场景,实现对输入自变量的降维压缩处理,防止OCSVM模型出现过拟合现象及分类准确率低的问题,提高异常检测的精度,缩减建模时间。通过仿真验证了该算法对工控网络异常检测的有效性。     

用人工神经网络预测混杂复合材料混杂效应

本研究建立一个二输入单输出的BP人工神经网络模型，并用QBASIC语言编制了相应的软件。利用该神经网络模型对混杂效应与混杂比及分散度系数间关系进行了预测。研究结果表明，网络经过61223次的迭代，预潮值误差为0．12％，具有很高的预测精度，可用于混杂复合材料混杂效应的预测。     

甲苯二异氰酸酯（TDI）的市场开拓

甲苯二异氰酸酯(TDI)是合成聚氨酯高聚物的主要原料之一,本文简要地论述了该产品的国内外发展与现状,从当前国内市场出发,认为开发面广,量大和价廉的新制品是我国TDI市场的开拓方向和当务之急,并提出了5项具体的开发项目,以有助于该产品的迅速发展。     

Pozzolanic properties of reject fly ash in blended cement pastes

Low-grade fly ash (reject fly ash, r-FA), a significant portion of the pulverized fuel ash (PFA) produced from coal-fired power plants and rejected from the ash classifying process, has remained unused due to its high carbon content and large particle size. But it may be used in certain areas, such as in solidification and stabilization processes of hazardous waste and materials for road base or subbase construction, which require relatively lower strength and reactivity. It is therefore necessary to extend research on the properties of r-FA and explore its possible applications. This paper presents experimental results of a study on the mechanical and hydration properties of cementitious materials prepared by blending r-FA with ordinary Portland cement (OPC). Parallel mixes were also prepared with the good ash [i.e., classified fine fly ash (f-FA)] for comparison. Selective chemical activators were added to the mix to study the effects of the activators on the properties of the blend system. The results show that r-FA generally has a lower rate of hydration than f-FA particularly at the early stage of hydration. Adding Ca(OH)₂ alone almost had no effect on accelerating the hydration of r-FA. But adding a small quantity of Na₂SO₄ or K₂SO₄ together with Ca(OH)₂ significantly accelerated the hydration reaction. The results of the compressive strength measurement correlated nicely with the degree of hydration results. It was also found that water-to-binder ratio (w/b) was an important factor in affecting the strength development and the hydration degree of r-FA pastes.     

重组人干扰素α2b栓剂的检定及其临床疗效

目的对重组人干扰素α2b栓剂进行质量检定及临床疗效观察。方法连续试制3批样品,进行各项质控指标的检定及宫颈糜烂的临床疗效观察。结果本品各项检定指标均符合质量要求。治疗组宫颈糜烂的有效率为74·8%,对照组的有效率为60·0%。治疗组和对照组的副反应发生率分别为9·1%和8·3%。结论重组人干扰素α2b栓剂质量稳定,安全性好,疗效确切。