Olfactometric characterization of aroma active compounds in fermented fish paste in comparison with fish sauce,fermented soy paste and sauce products

Aroma active compounds in commercial fermented fish meat paste product (fish miso), fermented soy paste (soy miso), fish sauce and soy sauces were characterized by using a dynamic headspace method for volatile isolation and GC olfactometry for odor perception. A total of 123 volatile compounds consisting mainly of aldehydes, alcohols, esters, ketones, furans, sulfur and nitrogen-containing compounds, aromatics and acids were consistently identified. A major 16 odor-active compounds were distinguished to contribute as key aroma compounds for the miso and sauce products. Olfactometric and sensory findings clearly differentiated miso products with caramelic, fruity aroma notes, whereas fish sauce products were characterized by ammoniacal, fishy, nutty and cheesy odor note. Soy sauce products, however, were dominated by nutty and cheese aroma. Use of koji for fish miso production was found effective to enhance sweet aroma to the product with a reduction of nutty, meaty and rancid nuance. Principal component analysis employed for statistical interpretations clearly elucidated the relationship among different types of fermented products.     

Preparation method for supported metal catalysts using w/o microemulsion: Study on immobilization conditions of metal particles by hydrolysis of alkoxide

It was previously found that the silica-supported rhodium catalyst prepared using water-in-oil microemulsion had rhodium particles partly, or wholly, embedded in silica. In this work, consequently, we investigated the effect of hydrolysis conditions of tetraethylorthosilicate, employed as the source of silica, on the atomic ratio of surface rhodium in contact with the gas phase, to total surface rhodium of nanoparticles. This ratio is denoted as R in this paper. R became higher when the catalyst was prepared under the following hydrolysis conditions: a shorter hydrolysis time and a smaller amount of tetraethylorthosilicate. On the other hand, R showed the minimum value when the water content in the preparation solution was 33 vol%. From these results, it is demonstrated that it was important to form silica as early as possible in hydrolysis of TEOS in order to increase R values. In addition, the effect of R on the catalytic behavior in CO hydrogenation was investigated. At R values below 30%, the turnover frequencies increased with a decrease in R.     

A geometric method of sector decomposition

We propose a new geometric method of IR factorization in sector decomposition. The problem is converted into a set of problems in convex geometry. The latter problems are solved using algorithms in combinatorial geometry. This method provides a deterministic algorithm and never falls into an infinite loop. The number of resulting sectors depends on the algorithm of triangulation. Our test implementation shows smaller number of sectors comparing with other existing methods with iterations.     

Enhancement of turbulent jet diffusion flame blowout limits by annular counterflow

The effects of a proposed combustion technique, named as annular counterflow, on the enhancement of jet diffusion flame blowout limits were investigated by a series of experiments conducted for the present study. Annular counterflow was formed in a concentric annulus, in which fuel jet was ejected from a nozzle and air was sucked into an outer cylinder encompassing the nozzle. Three fuel nozzles and outer cylinders of different sizes were utilized to perform the experiments. Schlieren technique and normal video filming were employed for the visualization of diverse flame morphologies triggered by the said flow. Gas samplings were taken and scrutinized by the use of a gas chromatograph. Results showed that the blowout limits can be enhanced dramatically by an increase in volume flow rates of air‐suction. Mixing enhancement is achieved with frequent and strong outward ejection of fluids from the cold jet when this technique is applied. The blowout limits are further extended when the diameter of outer cylinders becomes smaller and/or that of the fuel nozzle becomes larger. The base widths of lifted flames were found to be narrower in the interim of annular counterflow application. The rates of increase in flame lift‐off heights and base widths along with an increase in fuel flow velocities become sluggish when the volume flow rates of air are increased. The amount of fuel that was sucked into the outer cylinder was found to be negligible and trivial. A model based on annular and coaxial jet was developed to predict the lifted flame base width and blowout limits. The coincidence between the prediction and experimental results unambiguously validates that the momentum of air‐suction dominates the beneficial effect. Copyright © 2001 John Wiley & Sons, Ltd.     

Coal liquefaction mechanism using a tritium tracer method

To determine the behavior of hydrogen in tetralin, the reaction of tetralin with tritiated gaseous hydrogen was studied in a flow reactor at 400–450°C, 2.5–9.8 MPa for various residence times. The amount of hydrogen exchange between tetralin and tritiated hydrogen was estimated from the balance of hydrogen and tritium. Although yields of methylindan and naphthalene, and the hydrogen-exchange ratio (HER) of tetralin increased monotonously with residence time, these values were scarcely influenced by the reaction pressure at every temperature. It was thought that the formation of tetralyl radicals in this system would be the rate-determining step for both the conversions of tetralin into methylindan and naphthalene, and the hydrogen exchange of tetralin. Conversions of tetralin into methylindan and naphthalene, and the hydrogen-exchange reaction using the autoclave were very close to those using the flow reactor.     

Two-phase eutectic cell growth modles and extension to off-mono-variant region

Abstract

CoTe and CoTe₂ nanorods with average diameter of 100 nm were synthesized by a simple hydrothermal process, and different CoTe₂ nanostructures were obtained by changing the NaOH concentration. CoTe nanorods exhibit weak ferromagnetism while CoTe₂ nanorods present paramagnetic behavior. Different magnetic behaviors occur in the other CoTe₂ nanostructures due to Na⁺ entrance into CoTe₂ crystals. A first-principles study on Na-doped CoTe₂ confirms the magnetic characteristics.     

Pulsed Laser Processing of Carbon and Silicon Clusters and Thin Films

Abstract

Several new processes have been developed for the preparation of fullerenes and thin films by using a pulsed excimer laser. The irradiation of a pulsed KrF excimer laser beam onto a C₆₀ powder target produced single phase C₆₀ thin films when the laser energy fluence was in the range between 40 and 50mJ/cm². By atomic force microscopy, the laser-deposited C₆₀ thin film was verified to have a surface far smoother that the surfaces of films produced by the conventional evaporation method. The stainless steel rods coated with this film exhibited an excellent tribological property. Cluster formation from SiC and other carbides MC_n(M=Ti,W,B) was investigated by laser desorption time-of-flight mass spectrometry. No clear indication was observed for the production of such clusters as (SiC)₆₀ and (M_xC_60-x) from the sintered targets directly as well as from the films laser deposited from the targets. However, C₆₀ and C₇₀ were found to exists in the laser-deposited films, indicating a new applicability of pulsed laser processing for segregative cluster synthesis from solid solution. Preliminiary results on thin film deposition via pulsed ablation of (Ba,Na)_xSi₄₆ clathrate were also presented.     

Prospective predictors of posttraumatic stress disorder symptoms: Direct and mediated relations.

This study assessed the relations between pretrauma risk (neuroticism, negative affect, prior distress) and protective (self-esteem, optimism) factors and posttraumatic stress disorder (PTSD) symptoms and potential mediators (subjective event-related distress, unsupportive social interactions, perceived control) of those relations. Students (N = 1,528) at four U.S. universities completed online surveys assessing pretrauma risk and protective factors at Time 1 (T1); 84% (N = 1,281) completed a survey 2 months later (T2). PTSD symptoms and the three potential mediators were assessed among those who experienced potentially traumatic events between T1 and T2 (n = 264). PTSD symptoms related to prior traumas were controlled in all analyses. In structural equation modeling (SEM) analyses, the relation between risk factors and PTSD symptoms was mediated by unsupportive social interactions. Protective factors did not independently predict PTSD symptoms when risk factors also were included in the SEM models. Implications for research and practice are discussed. (PsycINFO Database Record (c) 2011 APA, all rights reserved)