Anomalous variations of OFF-State leakage current in poly-Si TFTunder static stress

Studies the anomalous variations of the OFF-state leakage current (I_OFF) in n-channel poly-Si thin-film transistors (TFTs) under static stress. The dominant mechanisms for the anomalous I_OFF can be attributed to (1) I_OFF increases due to channel hot electrons trapping at the gate oxide/channel interface and silicon grain boundaries and (2) I_OFF decreases due to hot holes accumulated/trapped near the channel/bottom oxide interface near the source region. Under the stress of high drain bias, serious impact ionization effect will occur to generate hot electrons and hot holes near the drain region. Some of holes will be injected into the gate oxide due to the vertical field (~(V_Gstress V_Dstress)/T _OX) near the drain and the others will be migrated from drain to source along the channel due to lateral electric field (~V_Dstress/L_CH)     

含油废水处理

在水量水质调查的基础上，本文提出了以出水回用为目的的含油废水隔油调节沉淀－混凝沉淀－砂滤处理工艺，动态模型试验表明，废水中油和ＣＯＤ的去除率分别达到９５％和９０％，出水浊度低于２，此水质完全可回用于有关生产车间。     

10MeV中子引起的~（238）U，~（209）Bi，Fe和~9Be的次级中子

１０ＭｅＶ中子引起的￣（２３８）Ｕ，￣（２０９）Ｂｉ，Ｆｅ和￣９Ｂｅ的次级中子双微分截面测量祁步嘉，唐洪庆，周祖英，周陈维，沈冠仁，柯尊建，孙振强，夏海鸿（中国原子能科学研究院核物理所，北京２７５－４６信箱，１０２４１３）次级中子双微分截面是核工程设...     

Preparation and properties of close-packed composite materials

Monodisperse silica particles of about 0.3m diameter are suspended in methacrylate monomer using a carefully selected dispersant. Many steric dispersants are hydrocarbon chains with a reactive end-group. These are not effective as dispersants for silica in moderately polar solvents, such as esters and the methacrylate monomers. Good dispersion was obtained with a methacrylate polymer terminated by a chlorosilane end group. Settling or centrifugation of these unagglomerated dispersions gives well-packed particle beds. Polymerization of the surrounding monomer produces composite materials with high packing fractions and a high degree of regularity. Moduli and strengths of these composites are reported.     

电动车制动能量再生反馈控制研究

研究了电动汽车制动过程中的能量回馈，设计了混合励磁无刷电动机在汽车制动过程的能量再生反馈控制系统。以脉宽调制调压调速系统为例，研究各种制动态下的能量回馈过程。并将其安装在EV6600电动汽车上进行试验，结果表明：该控制系统可达到10%左右的能量回收效率。     

碱土金属在萃取剂与树脂间反应平衡常数的测定

研究了碱土金属离子在Ｄ００１树脂与８－羟基喹啉三氯甲烷溶液间的平衡常数Ｏ－ｔＫ的测定。其值依Ｍｇ、Ｃａ、Ｓｒ、Ｂａ次序减小。并得出萃取剂浓度［ＨＡ］。与金属离子在两相分配的关系。     

乳白玻璃条纹解决方案

对乳白玻璃瓶表面产生条纹的原因进行分析,通过耐火材料选用、稳定熔制工艺、工作池中层取料和供料道加搅拌的方法消除条纹缺陷。     

Formation Mechanisms of Platelet Sr3Ti2O7 Crystals Synthesized by the Molten Salt Synthesis Method

The molten salt synthesis (MSS) method is utilized to synthesize the anisotropic platelet Sr₃Ti₂O₇ (S3T2) single-crystal particles. The aim of this study is to identify the essence of platelet Sr₃Ti₂O₇ crystal growth and guide the synthesis of anisotropic platelet SrTiO₃ crystals as well as various technologically important materials. Based on the results of X-ray diffraction, scanning electron microscopy, and high-resolution transmission electron microscopy, the formation mechanism of platelet Sr₃Ti₂O₇ crystals conforms to a nucleation–structure rearrangement–dissolution–diffusion in situ epitaxial growth mechanism model. First, SrCO₃ reacts with TiO₂ to form submicrometer SrTiO₃ nuclei. Then, most of the nuclei surrounded by salt ions aggregate and rearrange to form a large SrTiO₃ matrix. The structural rearrangement and the subsequent in situ epitaxial growth processes control the morphology, composition, and size of the final Sr₃Ti₂O₇ crystals. In the synthesis process, the conversion between SrTiO₃ and Sr₃Ti₂O₇ is as follows: and the crystallographic orientation relationship between Sr₃Ti₂O₇ and SrTiO₃ in the interface is (100)_S3T2//{100}_ST, (010)_S3T2//{010}_ST, and (001)_S3T2//{001}_ST.     

Fabrication and amplification of Rhodamine B‐doped step‐index polymer optical fiber

A step‐index polymer optical fiber (SI POF) containing Rhodamine B in poly(methyl methacrylate) (PMMA) has been fabricated by a preform technique. Fluorescence of different fiber lengths were observed and discussed. A high gain (23 dB) for a SI POF with 60‐cm length, 400‐μm diameter was obtained. The Rhodamine B content of the doped SI POF is 5 ppm‐wt. The signal wavelength providing the highest gain for a 60 cm SI POF is around 630 nm, and the optimum fiber length is about 60 cm at 10 kW launched pump power. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 93: 681–685, 2004