水平切片解释方法在焦作井田构造复杂区的应用

河南焦作某矿地处焦作煤田东部,该矿东三盘区地质构造复杂,主采的2号煤层底板与L_8灰岩平均间距仅20m,与奥灰顶界面平均间距约100m,因此断层的存在极易导通奥灰水,形成较大的水患事故。故查明区内构造分布情况十分必要。本文重点介绍了用三维地震常规解释方法结合偏移及方差数据体水平切片解释方法在构造复杂区的应用情况,具有一定的推广意义。     

Engineering all-aromatic polyamide surface from hydrophilic to superhydrophobic and the accelerated strategy

Being a new kind of nanomaterials, aromatic polyamide nanofibers (ANF) have been much highlighted in recent studies. We here demonstrate an isopropyl alcohol (IPA) accelerated chemical cleavage on poly (p-phenylene terephthalamide) chopped fibers, which provides an efficient preparation method of ANF. The comprehensive study on the processes accelerated by different alcohols revealed that the preparation time of ANF in the mixed medium of dimethyl sulfoxide (DMSO)-alcohol (20:1 in volume) was shorten to 45 min and 75 min for methanol (ethanol) and isopropanol, respectively. However, the nanofibers prepared in DMSO-IPA exhibited the minimum in axial and radial dimensions, providing the finest and most uniform diameter of 16 nm. The corresponding ANF films through vacuum assisted filtration also showed the highest tensile strength of 150 MPa, in comparison with those of the ANF films prepared using other alcohols, which were about 110 MPa. Furthermore, ANF/silicon hybrid films were prepared by the ionic ring-opening reaction followed by the alkoxysilane condensation and nanoparticle fabrication. By changing the organo functional groups in the alkoxysilane, the surface of the films were adjustable in a wide contact angle range from 56° (hydrophilic) to 150° (superhydrophobic), suggesting the amendable interfacial properties potential applicable to composite fabrication with most of the resin matrix.     

The effects of carbon content in steel on the diffusion rate of chromium

Conclusions Thermal diffusion chromizing in metallic chromium under vacuum promotes impregnation and produces a thicker layer than in chromizing by means of a powder mixture only in steel with a maximum content of 0.2% C at 1100°C and higher.     

微震定位系统中拾震器布阵研究

对微震监测中拾震器阵列进行科学有效的布置是保证微震定位系统能有效运行的一个关键条件,设计了4种拾震器阵列布设方案,使煤矿中微震定位监测系统运行得更加科学有效.首先建立复杂地质模型,利用微变网格射线追踪正演模拟出微震源起震到拾震器阵列接收信号的过程,然后在施加随机扰动的情况下,利用粒子群-神经网络算法(PSO-BP)反演推算出震源位置,最后通过震源位置的误差来分析各个布阵方案的特点,同时分析了阵列中拾震器数量的合理值.研究结果表明,在微震监测系统中拾震器利用率最高的情况下,可以给出准确、合理、有效的拾震器布阵方案.     

基于奇异谱分析的DGPS浮标海面高测量误差研究

在高度计绝对定标实验中,利用差分GPS(Differential GPS,DGPS)浮标进行现场海面高测量得到的海面高(Sea Surface Height,SSH)序列之中,除了包含有由风浪引起的高频噪声外,还包括了仪器误差造成的影响。前者可通过低通滤波方式消除,而后者由于是全频段的白噪声,不能通过低通滤波的方式消除。通过研究奇异谱分析(Singular Spectrum Analysis,SSA)的方法,确定了嵌入维数和截断长度的选取准则,并对其进行仿真,验证了该方法在消除海面高序列的仪器误差噪声中的有效性,同时也验证了嵌入维数和截断长度选取准则的有效性。最后,利用该方法处理了某次DGPS浮标实验获得的海面高序列,处理结果与原始序列相比较为平滑,且在精度上有一定的改善,验证了奇异谱分析方法的有效性。     

MEMS-IMU/GPS/GPRS组合导航方案设计与实现

针对日益增长的低成本导航定位需求,提出了一个MEMS-IMU/GPS/GPRS组合导航方案,以MEMS-IMU模块和SIM908单板机为载体,以GPRS为通讯手段,实时获取GPS/IMU位姿信息.并编写程序分别对GPS和IMU数据进行预处理并以松组合方式进行组合导航数据融合.为验证系统的可靠性和精度,进行了实际静态试验和车载实验,事后数据处理分析结果表明,提出的低成本组合导航系统具有一定的可靠性,导航定位精度达到分米级.     

Generation of GHZ states with invariant-based shortcuts

A scheme is proposed to generate three-atom GHZ states by applying the inversely engineered control method on the basis of Lewis–Riesenfeld invariants. In the proposal, three atoms that have different configurations are trapped in a bimodal cavity. Numerical simulations indicate that our protocol has an obvious improvement of speed for the generation of GHZ states. Moreover, the present scheme is robust against both parameter fluctuations and dissipation.     

Quantum walk in terms of quantum Bernoulli noises

Quantum Bernoulli noises are the family of annihilation and creation operators acting on Bernoulli functionals, which satisfy a canonical anti-commutation relation in equal time. In this paper, we first present some new results concerning quantum Bernoulli noises, which themselves are interesting. Then, based on these new results, we construct a time-dependent quantum walk with infinitely many degrees of freedom. We prove that the walk has a unitary representation and hence belongs to the category of the so-called unitary quantum walks. We examine its distribution property at the vacuum initial state and some other initial states and find that it has the same limit distribution as the classical random walk, which contrasts sharply with the case of the usual quantum walks with finite degrees of freedom.     

Designing a supply network artifact for data,process, and people integration

E-procurement and supplier-relationship management systems have helped to substantially advance process execution in supply management. However, current supply network systems still face challenges of high data integration efforts, as well as the decoupling of structured data and processes from the growing amount of digitalized unstructured interactions of supply management professionals. Inspired by the room for improvement posed by this challenges, our research proposes a design for a supply network artifact in supplier qualification that addresses these problems by enabling holistic integration of data, processes, and people. The artifact is developed following an action design research approach. Building on a set of meta-requirements derived from literature and practice explorations, we conceptualize two design principles and derive corresponding design decisions that have been implemented in an software artifact. Finally, we formulate testable hypotheses and evaluate the artifact and its design in the context of supplier qualification. Our results show that the proposed design reduces mental effort of supply management professionals and significantly increases efficiency when performing typical supply network tasks such as supplier qualification.