Effect of gravity on InGaSb crystal growth

The effect of gravity on dissolution of GaSb in InSb melt and growth of InGaSb was experimentally investigated. Experiments were carried out in a GaSb(seed)/InSb/GaSb(feed) sandwich system under an imposed temperature gradient. In the experiments, the GaSb feed crystal dissolved into the InSb melt to supply the required GaSb component for the growth of In_0.1Ga_0.9Sb crystal. Two parameters were considered: (1) the inclination angle (θ) of the sample for gravity as 0° and 53°, and (2) the sample diameter (D) as 9 mm and 5mm. When θ was 0°, the interface was almost flat, indicating that convection was axisymmetric and stable. Whereas the interface was distorted towards gravitational direction when θ was 53°, indicating that solutal convection was dominant. The decrease of growth temperature and sample diameter reduced the distortion of interface and the dissolution amount of GaSb feed. The homogeneous crystals were grown at the initial growth stage by supplying the GaSb component during growth.     

Avoiding Routing Loops on the Internet

Suppose that some particular link in the Internet is currently congested. A natural solution is to try to make packets bypass that link. This can be done by increasing the cost of that link intentionally, say from a ₁ to a ₂, since the Internet uses shortest-path routing. Unfortunately, however, this often causes temporary loops for packet traveling, called routing loops. In this paper we show that routing loops can be avoided by increasing the cost of the link not directly from a ₁ to a ₂ but through an intermediate value, a ₃, i.e., from a ₁ to a ₃ and then to a ₂. We may need several intermediate values. We show that in this case the greedy strategy, namely, raising the cost as much as possible in each step, is optimal.     

Uniformity of gallium doped zinc oxide thin film prepared by pulsed laser deposition

Recently, transparent conducting oxide thin films have attracted attention for the application to transparent conducting electrodes. In this work, we evaluated the uniformity of electrical, optical and structural properties for gallium doped zinc oxide thin films prepared on the 10 × 10 cm² silica glass substrate by pulsed laser deposition. The resistivity, carrier concentration, mobility, bonding state and atomic composition of the film were uniform along in-plane and depth direction over the 10 × 10 cm² area of the substrate. The film showed the average transmittance of 81-87%, resistivity of 1.4 × 10^− 3 Ω cm, carrier concentration of 9.7 × 10²⁰/cm³ and mobility of 5 cm²/Vs in spite of the amorphous X-ray diffraction pattern. The gradual thickness distribution was found, however, the potential for large-area and low temperature deposition of transparent conducting oxide thin film using pulsed laser deposition method was confirmed.     

Dual-Mode Space-Temporal Simultaneous Processing Equalizer

A tapped delayed line adaptive array antenna (TDL-AAA) and a space-temporal simultaneous processing equalizer (ST-SPE) are proposed as simple space-temporal equalizers based on minimum mean square error (MMSE) criterion. The ST-SPE has a compact hardware with a small number of taps compared to that of the TDL-AAA. The ST-SPE can reduce the computational complexity of the space-temporal joint equalization and it works effectively under the minimum phase condition such as appeared at line-of-sight (LOS) propagation environments at a high antenna height base station. However the ST-SPE cannot work under a non-minimum phase condition caused under N-LOS (non-line-of-sight). On the other hand, the TDL-AAA whose reference signal is synchronized at the center tap (TDL-AAA_C) can work even in the non-minimum phase condition. In this paper, we propose a dual-mode space-temporal simultaneous processing equalizer (Dual-mode ST-SPE) which has a simple configuration and also works in non-minimum phase condition. The Dual-mode ST-SPE can reduce the computational complexity compared to the TDL-AAA_C. Yoshihiro Ichikawa received the B.E. degree in department of communication engineering, in National Defense Academy in 1995, and M.E. and D.E. degree from Ibaraki University in 2001 and 2004, respectively. He joined the Japan Air Self Defense Force in 1995. His research interests are an adaptive algorithm, an antenna design, and an adaptive array antenna. Shigeki Obote received his B.E., M.E. and D.E. degrees in electrical and electronic engineering from Tottori University, Tottori, Japan, in 1996, 1998 and 2000, respectively. Since 2000, he has been with department of media and telecommunications engineering, faculty of engineering, Ibaraki University, Ibaraki, Japan, where he is currently a associate professor. His research interests are in adaptive array antenna and wireless communications systems. Kenichi Kagoshima received the B.E., M.E. and D.E. degrees in electronics engineering from the Tokyo Institute of Technology, Tokyo, Japan, in 1969, 1971, and 1974, respectively. He joined the Nippon Telegraph and Telephone Corporation (NTT) Laboratory in 1974 and researched and developed many kinds of radio communication antennas. Since 1997, he has been a professor at Ibaraki University, Ibaraki, Japan. Dr. Kagoshima was a Secretary and Treasure, Vice Chairman, and Chairman of the IEEE AP-S Tokyo Chapter in 1992, 1993, and 1994, respectively. He was a chair of antennas and propagation professional group of IEICE in 1999 and 2000. In 1973, he received the Yonezawa Prize for Young Engineers and 1998, best paper award from IEICE, respectively.     

Theranostic Agent Combining Fullerene Nanocrystals and Gold Nanoparticles for Photoacoustic Imaging and Photothermal Therapy

Developing photoactivatable theranostic platforms with integrated functionalities of biocompatibility, targeting, imaging contrast, and therapy is a promising approach for cancer diagnosis and therapy. Here, we report a theranostic agent based on a hybrid nanoparticle comprising fullerene nanocrystals and gold nanoparticles (FGNPs) for photoacoustic imaging and photothermal therapy. Compared to gold nanoparticles and fullerene crystals, FGNPs exhibited stronger photoacoustic signals and photothermal heating characteristics by irradiating light with an optimal wavelength. Our studies demonstrated that FGNPs could kill cancer cells due to their photothermal heating characteristics in vitro. Moreover, FGNPs that are accumulated in tumor tissue via the enhanced permeation and retention effect can visualize tumor tissue due to their photoacoustic signal in tumor xenograft model mice. The theranostic agent with FGNPs shows promise for cancer therapy.     

Canadian Field Soils I. Mineral Composition by XRD/XRF Measurements

Forty Canadian soils were laboratory tested for the presence of quartz and other minerals using X-ray diffraction/X-ray fluorescence techniques. On average, the highest quartz content was observed in soil samples from sites in Nova Scotia followed by Prince Edward Island sites, whereas soil sample from British Columbia sites had the lowest quartz content. The second most abundant mineral was albite that mainly occurred in soil samples from Ontario and Quebec sites. Illite was the third most abundant and prevailed in soils mainly from British Columbia and New Brunswick sites. Soil samples from British Columbia sites had the highest combined clay and silt content and were composed of illite, albite, kaolinite, and chlorite. The lowest clay content was found in the samples from the Quebec sites. The highest microcline (a potassium feldspar) content was observed in Quebec, Ontario, and Prince Edward Island sites. In contrast to other provinces, samples from Quebec and Ontario sites also included amphibole. Soil samples from Saskatchewan and Manitoba sites also comprised carbonates, i.e., calcite and dolomite. Iron oxides (e.g., goethite) were present in all soils, except the Quebec sites, but their occurrence was rather insignificant.     

Thermogravimetric behavior of perfluoropolyether

In this article, two kinds of perfluoropolyether (PFPE) with different terminal groups were investigated using thermogravimetric analysis (TGA), infrared (IR) spectroscopy, gel permeation chromatography (GPC), and gas chromatography/gas mass spectrum (GC/MS) analysis. PFPEs with a hydroxyl or carboxylic acid terminal group were more heat stable than was PFPE with carboxylic methyl ester. Perfluoropropylene oxide-type PFPE with a perfluoroethyl terminal group at one end tends to lose weight more rapidly than does copolymer-type PFPE with dihydroxyl or dicarboxyl methyl ester terminal groups at both ends. The residual weight fraction of PFPE with a perfluoroethyl terminal group was dependent on the average molecular weight. The number-average molecular weight of PFPE can be calculated from the peak intensity ratio between the polar group and C F stretching by measuring the IR spectrum of PFPE. The number-average molecular weight of PFPE increased because of the evaporation loss of its low molecular weight fraction and the crosslinking reaction of PFPE with increase in temperature. GC/MS analysis showed that the main product of the pyrolysis of PFPE was hexafluoropylene. We speculated on the PFPE degradation mechanism and the optimum PFPE chemical structure in terms of heat stability. © 1996 John Wiley & Sons, Inc.     

Two types of a passive safety containment for a near future BWR with active and passive safety systems

The paper presents two types of a passive safety containment for a near future BWR. They are named Mark S and Mark X containment. One of their common merits is very low peak pressure at severe accidents without venting the containment atmosphere to the environment. The PCV pressure can be moderated within the design pressure. Another merit is the capability to submerge the PCV and the RPV above the core level. The third merit is robustness against external events such as a large commercial airplane crash. Both the containments have a passive cooling core catcher that has radial cooling channels. The Mark S containment is made of reinforced concrete and applicable to a large power BWR up to 1830 MWe. The Mark X containment has the steel secondary containment and can be cooled by natural circulation of outside air. It can accommodate a medium power BWR up to 1380 MWe. In both cases the plants have active and passive safety systems constituting in-depth hybrid safety (IDHS). The IDHS provides not only hardware diversity between active and passive safety systems but also more importantly diversity of the ultimate heat sinks between the atmosphere and the sea water. Although the plant concept discussed in the paper uses well-established technology, plant performance including economy is innovatively and evolutionally improved. Nothing is new in the hardware but everything is new in the performance.     

HNF1A Mutations and Beta Cell Dysfunction in Diabetes

Understanding the genetic factors of diabetes is essential for addressing the global increase in type 2 diabetes. HNF1A mutations cause a monogenic form of diabetes called maturity-onset diabetes of the young (MODY), and HNF1A single-nucleotide polymorphisms are associated with the development of type 2 diabetes. Numerous studies have been conducted, mainly using genetically modified mice, to explore the molecular basis for the development of diabetes caused by HNF1A mutations, and to reveal the roles of HNF1A in multiple organs, including insulin secretion from pancreatic beta cells, lipid metabolism and protein synthesis in the liver, and urinary glucose reabsorption in the kidneys. Recent studies using human stem cells that mimic MODY have provided new insights into beta cell dysfunction. In this article, we discuss the involvement of HNF1A in beta cell dysfunction by reviewing previous studies using genetically modified mice and recent findings in human stem cell-derived beta cells.