Strength of Al-Zn-Mg-Cu matrix composite reinforced with SiC particles

The AA7075 alloys reinforced with SiC and without SiC particles were fabricated by a pressureless infiltration method, and then, their tensile properties and microstructures were analyzed. The spontaneous infiltration of molten metal at 800 °C for 1 hour under a nitrogen atmosphere made it possible to fabricate 7075 Al matrix composite reinforced with SiC, as well as a control 7075 Al without SiC. A significant strengthening even in the control alloy occurred due to the formation of in-situ AlN particle even without an addition of SiC particles. Composite reinforced with SiC particles exhibited higher strength values than the control alloy in all aging conditions (underaged (UA), peak-aged (PA), and overaged (OA)), as well as a solution treated condition. Spontaneous infiltration was further prompted owing to the combined effect of both Mg and Zn. This may lead to an enhancement of wetting between the molten alloy and the reinforcement. Consequently, strength improvement in a composite may be attributed to good bond strength via enhancement of wetting. The grain size of the control alloy is greatly decreased to about 2.5 μm compared to 10 μm for the commercial alloy. In addition, the grain size in the composite is further decreased to about 2 μm. These grain refinements contributed to strengthening of the control alloy and the composite.     

Interdiffusion behavior of Hg in HgTe/CdTe superlattices grown on Cd0.96Zn0.04 Te (211)B substrates by molecular beam epitaxy

Double-crystal x-ray rocking curve (DCRC) and secondary-ion mass-spectroscopy (SIMS) measurements have been performed to investigate the effect of rapid thermal annealing on the interdiffusion behavior of Hg in HgTe/CdTe superlattices grown on Cd_0.96Zn_0.04Te (211)B substrates by molecular beam epitaxy. The sharp satellite peaks of the DCRC measurements on a 100-period HgTe/CdTe (100Å/100Å) superlattice show a periodic arrangement of the superlattice with high-quality interfaces. The negative direction of the entropy change obtained from the diffusion coefficients as a function of the reciprocal of the temperature after RTA indicates that the Hg diffusion for the annealed HgTe/CdTe superlattice is caused by an interstitial mechanism. The Cd and the Hg concentration profiles near the annealed HgTe/CdTe superlattice interfaces, as measured by SIMS, show a nonlinear behavior for Hg, originating from the interstitial diffusion mechanism of the Hg composition. These results indicate that a nonlinear interdiffusion behavior is dominant for HgTe/CdTe superlattices annealed at 190°C and that the rectangular shape of HgTe/CdTe superlattices may change to a parabolic shape because of the intermixing of Hg and Cd due to the thermal treatment.     

Characterization of the cavity nucleation factor for life prediction under creep-fatigue interaction

It is understood that grain boundary cavitation is one of the detrimental processes for the degradation of materials that reduces the creep-fatigue life at high temperatures. In a previous investigation, a model for life prediction under creep-fatigue conditions was proposed in terms of cavity nucleation and growth. In that model, the cavity nucleation factor (P) was introduced to correlate between the number of cavities and the plastic strain range from which athermal vacancies are generated. It was considered to be a material specific constant which was independent of the experimental conditions. However, in this study, it is found that the cavity nucleation factor is a function of the plastic strain range but is independent of the testing temperature at near 0.5 T _m. In the light of this dependency, a new cavity nucleation factor (P'), is introduced. Using this new cavity nucleation factor (P'), a modified equation for life prediction is proposed, and it is shown that there is good agreement between predicted and experimental lives. Additionally, an interesting approach has been made to find the physical meaning of the new cavity nucleation factor (P'). According to this study, it is suggested that the new cavity nucleation factor, which is regarded as a material specific constant, is found to be strongly related to the density of the grain boundary precipitates with a linear relationship existing between them.     

An outbreak of malignant catarrhal fever in young rusa deer (Cervus timorensis)

On the basis of clinical signs and histological findings eight 9-month-old male rusa deer (Cervus timorensis) were diagnosed with sheep associated-malignant catarrhal fever. Following a variable course involving rectal temperatures around 40.5 degrees C, depression, inappetence, diarrhoea, corneal opacity and hypopyon all animals died or were euthanased over a 5-week period. Severe multifocal vasculitis, mainly periglomerular and in the arcuate vessels were consistent histological findings which in the past have been adequate to confirm clinical diagnosis of sheep associated-malignant catarrhal fever. A nested polymerase chain reaction test has been used to detect a sheep associated-malignant catarrhal fever PRC product, 238 base-pairs in size, in DNA extracted from lymphocyte preparations. The result supported the diagnosis of sheep associated-malignant catarrhal fever in these deer.     

Homogeneity of fruits and vegetables comminuted in a vertical cutter mixer

The homogeneity of comminuted composites of 20 lb samples of apples, cabbage, and green beans containing field-incurred residues of p, p'-methoxychlor was studied to determine whether a 5 min comminution in a 40 qt vertical cutter mixer produces a homogeneous composite and whether the size of test portions used accurately represents the composite. Duplicate test portions of 100, 50, 25, 10, 5, and 2 g taken from each of 6 separate sections of the mixer were analyzed by standard pesticide residue methodology for p, p'-methoxychlor. Results of this study confirmed that comminution of fresh produce in a 40 qt vertical cutter mixer, according to instructions described in the U.S. Food and Drug Administration's Pesticide Analytical Manual, Volume I, Section 203B, produces a homogeneous composite. No significant differences were found in the data for the 3 crops taken from the 6 sections of the mixer. Test portion weights of 100, 50, and 25 g produced equivalent results for all 3 crops. Statistically significant differences were observed for cabbage at 2, 5, and 10 g and for green beans at 2 g.     

Catalytic behavior of YBa2Cu3O7-x in the partial oxidation of methanol to formaldehyde

The partial oxidation of methanol to formaldehyde was studied over YBa₂Cu₃O_7-x catalyst in a flow reactor. The structural change of YBa₂Cu₃O_7-x before and after the reaction was measured by means of XRD and iodometric titration method. The catalytic characteristics of YBa₂Cu₃O_7-x for the partial oxidation of methanol to formaldehyde was due to copper ions. It was found that Cu⁺² was responsible for the higher selectivity for formaldehyde.     

Improved performances of a S-SEED using extremely shallowquantum-wells and asymmetric Fabry-Perot cavity structure

The authors report significantly improved performances of a symmetric self-electrooptic-effect device (S-SEED), with high on-off contrast ratio (>30:l) and large optical bistability loop widths (ΔP=44%) at an applied bias of V_a=0 V, i.e., with no power supply. The S-SEED is made of extremely shallow quantum wells (ESQWs) in an asymmetric Fabry-Perot (AFP) cavity structure. At V_a =5 V ΔP increased by up to 95%, preserving the high contrast ratio. The reflectivity changes at V_a=0 and 5 V were about 15% and 30%, respectively. These are believed to be the largest values ever reported for such structures     

Relationship of a dystrophin-associated glycoprotein to junctional acetylcholine receptor clusters in rat skeletal muscle

The relationship of a member of the transmembrane dystrophin-associated glycoprotein (DAG) complex to acetylcholine receptors (AChRs) was investigated using immunofluorescence techniques at rat neuromuscular junctions (NMJs) viewed en face. These results were compared with those from a similar previous study of dystrophin and an autosomal homologue (utrophin or dystrophin-related protein, DRP) (Bewick et al. Neuro Report 1992; 3: 857-860). The region of highest 43 K DAG (43DAG) labelling projected beyond the AChRs by approximately 0.3 microns, as does that for dystrophin. By contrast DRP labelling precisely co-localizes with the AChRs. These results suggest that at the NMJ, the region of high 43DAG concentration encompasses the area of highest intensity labelling for both DRP and dystrophin.     

The rank one mixed μ problem and ‘kharitonov-type’ analysis

The general mixed μ problem has been shown to be NP hard, so that the exact solution of the general problem is computationally intractable, except for small problems. In this paper we consider not the general problem, but a particular special case of this problem, the rank one mixed μ problem. We show that for this case the mixed μ problem is equivalent to its upper bound (which is convex), and it can in fact be computed easily (and exactly). This special case is shown to be equivalent to the so-called ‘affine parameter variation’ problem (for a polynomial with perturbed coefficients) which has been examined in detail in the literature, and for which several celebrated ‘Kharitonov-type’ results have been proven.     

An experimental study on the pumping performance of molecular drag pumps

The pumping performance of molecular drag pumps (MDP) has been investigated experimentally. The experimented MDPs are a disk-type drag pump (DTDP), helical-type drag pump (HTDP) and compound drag pump (CDP), respectively. In the case of the DTDP, spiral channels of a rotor are cut on both upper surface and lower surface of a rotating disk, and the corresponding stator is a planar disk. In the case of the HTDP, the rotor has six rectangular grooves. The CDP consists with the DTDP, at lower part, and with the HTDP, at upper part. The experiments are performed in the outlet pressure range of 0.2–533 Pa. The inlet pressure and compression ratio are measured under the various conditions of outlet pressure and throughputs, and nitrogen is used for the test gas. At the outlet pressure of 0.2 Pa, the ultimate pressure has been reached to 1.0 × 10⁻² Pa for the HTDP, 1.3 × 10⁻⁴ Pa for the DTDP, and 3.6 × 10⁻⁵ Pa for the CDP. The maximum compression ratio of the CDP is much higher than those of the DTDP or HTDP. Consequently, the ultimate pressure of the CDP is the lowest one.