用φ20mm离心萃取器两步法制取高纯钇

本文研究了中钇富镧稀土的氧化物溶液在环烷酸中的萃取行为，测定了镧钇组成、温度变化与分离系数的关系；在Ｐ＿（５０７）体系中研究了ｐＨ值与分配比的关系；提出用环烷酸、Ｐ＿（５０７）两种萃取剂制备高纯钇的工艺流程。用８４台φ２０ｍｍ离心萃取器进行了一个月的台架试验，结果证明两种萃取剂有很好的互补性，在满足钇的纯度要求下有较高收率。离心萃取器具有易分相、体系存留量少、液流密闭性好等优点，它更适宜于粘度大、级数多、产品纯度要求高的体系。     

关于Ada95变体部分等语法的修正意见

本文指出了Ａｄａ９５ 参考手册中记录变体部分、记录聚集、分情形语句与异常处理段等语法描述中存在的问题，并分别给出了它们的修正方案。     

川东地区长兴组缝洞型储层的识别

本文针对四川东部地区上二叠统长兴组(P_2~2)缝洞型储层的低孔、低渗及非均质性等特点,分析了影响这类储层识别的主要因素,提出了利用现有的地球物理测井手段定性识别储层的指标和定量综合识别储层的方法,这可望提高测试成功率。     

在役加氢反应器试验板脆化和氢损伤的测定与研究

充分利用了带主焊缝的役后试板，在国内首次开展回火脆化、氢介质下断裂韧性与疲劳扩展的研究，结果表明，加氢反应器焊缝有明显的脆化表现。同时，核查了反应器开停车升温速度和降温速度规定，以及确定了裂纹允许尺寸的参考数据，为今后安全运行提供了充分的依据。     

Acidity near eroding polylactide-polyglycolide in vitro and in vivo in rabbit tibial bone chambers

Eroding poly(DL-lactide-co-glycolide)(PDLLG) washers were observed chronically in vitro and in vivo following loading in a bone chamber tibial implant (BCI). Images were recorded using intravital microscopy of the implanted rabbit and direct pH measurements were obtained of the tissue in the bone chamber using a combination probe-reference microelectrode. While statistically significant pH differences were found between the control (unloaded) and experimental (PDLLG-bearing) BCIs, they were only of the order of 0.2 pH units. This value proved to be physiologically insignificant as no statistically significant difference in bone defect healing, as indicated by angiogenesis, was detected. It was shown that the measured small pH changes during PDLLG washers erosion would result whether the buffer was phosphate-buffered saline replaced weekly or interstitial fluid subject to vascular exchanges.     

Experimental and theoretical studies on a distributed temperaturesensor based on Brillouin scattering

Results are reported from recent research on the use of the Brillouin gain/loss mechanism for distributed sensing. A theoretical model of the interaction of the pulsed and CW beams is described and compared with experiments. Results from a system with a 51 km sensing length are presented. We finally investigate issues related to the variation within the sensing fiber of the polarizations of the two beams     

以技术进步促进蒸汽能源的节约

本文运用“软科学”一即通过建立数学模型，进行系统分析和系统优化，阐述对蒸汽管网优化运行的方法及原理，达到提高供热效率及节能降耗的目的．     

在τ—ρ域用特征积分法反演层状介质的速度和密度

本文提出一种在τ-p 域内用特征积分法反演层状介质速度与密度的方法。该方法首先把有偏移距的地震资料变换到截取时间τ和水平慢度 P 域内,然后,对任取的二道平面波地震记录,分别用特征积分法反演波阻抗,再用这对波阻抗分离层状介质的速度和密度。文中讨论了误差对反演结果的影响,并对理论模型进行了试算,效果令人满意。     

Material removal and surface damage in EDM of Ti3SiC2 ceramic

Material removal and surface damage of Ti₃SiC₂ ceramic during electrical discharge machining (EDM) were investigated. Melting and decomposition were found to be the main material removal mechanisms during the machining process. Material removal rate was enhanced acceleratively with increasing discharge current, i_e, working voltage, u_i, but increased deceleratively with pulse duration, t_e. Microcracks in the surface and loose grains in the subsurface resulted from thermal shock were confirmed, and the surface damage in Ti₃SiC₂ ceramic led to a degradation of both strength and reliability.