Effect of heating-rate on failure temperature of pre-loaded brass H62

The response and failure of brass H62 specimens subjected to different levels of pre-loaded stresses and heating rates were investigated using a Gleeble-1500 thermal-mechanical material testing system. The metallographs of the tested material were also observed and analyzed. It is found that the increase of either pre-loaded stress or heating-rate decreases the failure temperature. Metallographic analysis shows that high heating-rate may cause stronger local thermal inconsistency （LTI） and remarkably increase the microdefects in the material, which may markedly degrade the macroscopic mechanical properties of the material.     

低品位铁矿石高梯度磁分离的研究

一、绪言近年来,随着钢铁工业迅速地发展,需要的铁矿石正在显著地增加。然而在70年代以来,就铁矿石资源而言,世界性出规富矿石枯竭的趋势,则确保高品位铁矿石逐渐地成为困难。例如,美国铁矿石的采掘品位1951年为49.5％,而1971年降为34.0％;苏联1965年为40.8％,而1970年降低为37.3％,1976年降低为36.1％。为了扭转这种     

分形图形在包装CAD中的应用研究

在以电子计算机为代表的现代信息技术的发展中,计算机辅助设计和辅助制造(CAD/CAM)已成为一个最有实际经济价值的新技术之一.     

32OH场强仪检修一例

故障现象:在以下各频段频率显示如下: FM 90M—120M 正常值85M—117M; VHF(LOW) 56M—220M 正常值45M—178M; VHF(H1GH) 440M—660M 正常值153M—455M; UHF 660M—980M 正常值449M—863M。与正常值相差甚远,且在FM、VHF(LOW)、VHF(H1GH)、UHF的任一段,不论40dB、20dB衰减开关是否打开,表头总有停在中间段的指示,扬声器总有噪声。 检查维修:打开机壳,取出机芯,可以见到除电解电容、按键开关、电位器、高频头等     

ZrO_2（Y－TZP）－Si_3N_4复合材料中抑制ZrN生成研究

研究了气氛加压烧成ＺｒＯ２（Ｙ－ＴＺＰ）－Ｓｉ３Ｎ４复合材料中抑制ＺｒＮ生成工艺问题，相组成分析表明：无论添加２０ｗｔ％工业ＺｒＯ２或者Ｙ－ＴＺＰ（３ｍｏｌ％Ｙ。Ｏ。）的氯化硅复合材料，在低于１８５０℃，３ＭＰａｋ气压力下烧成，表面无ＺｒＮ生成．通过加入有效的烧结助剂（Ｙ。Ｏａ＋ＡＩ。Ｏｓ）、增加埋粉中ＳＩＯ分压以及增加保护气氛氮气压力，适当的烧成条件等工艺措施可有效地抑制ＺｒＮ的生成．实验还证实了ＺｒＮ很容易氧化，含有ＺｒＮ的ＺｒＯ。（Ｙ－ＴＺＰ）－ＳｉｓＮ。复合材料试样经９００℃，０．ｓｈ热处理已粉碎性裂开．     

江苏省可持续建筑节能墙体可选择的新材料新技术

江苏省墙体材料革新与推广节能建筑已经历3个五年计划,为可持续建筑发展创造了一定的条件。根据国家及江苏省的有关墙改政策及与时俱进的原则,将省内生产的具有一定规模的新材料和节能新技术进行归类介绍。     

Direct electroless Ni-P deposition on AM50 magnesium alloy from sulfate bath

A bright electroless Ni-P deposition on AM50 magnesium alloy in a sulfate plating bath was proposed by using direct plating process with non-chromate pretreatment. The electroless Ni-P plating on AM50 magnesium alloy has an admirable appearance and good adhesion. The results indicate that the electroless Ni-P deposition with non-chromate pretreatment has better adhesion than that of zinc immersion coating. Anodic polarization curves indicate that the electroless Ni-P deposition obtained from the sulfate bath has similar corrosion-resistance to that obtained from basic nickel carbonate bath. The deposition process generates less pollutant by a non-chromate plating bath and is suitable for the magnesium alloys manufacture because of its low cost. The hardness of the electroless Ni-P plated AM50 is about HV 720.6 and HV 969.7 after heat treatments at 180℃ for 2 h. The wear resistance of Ni-P plated magnesium alloy specimens is about 5 to 9 times as high as that of bare magnesium alloys.     

管内周期性自旋流的强化传热实验

对间隔插入旋流片管内周期性自旋流的传热与流阻性能进行了实验研究,并比较了4种类型的旋流片及其不同旋流片间距的强化传热性能。结果表明,最佳旋流片间距Lp均在33d左右,旋流片强化传热的综合效果从大到小依次为:旋转角α=180°及旋流角β=20.3°的旋流片、旋转角α=270°及旋流角β=20.3°的旋流片、旋转角α=180°及旋流角β=38.1°的旋流片、旋转角α=270°及旋流角β=38.1°的旋流片。     

进一步增强整体开放意识开创我市对外开放工作的新局面

九十年代是中国社会主义现代化建设进程的关键时期。作者从宏观角度提出了青岛市如何进一步增强整体开放意识,开创对外开放工作的设想。对我市今后更好适应我国的经济振兴和社会进步意义重大。