Characterization of particulate emissions from occupant activities in offices

This paper characterizes the relationship between occupant activities and indoor air particulate levels in a non-smoking office building. Occupant activities were recorded on video. Particulate concentrations were monitored by three optical particle counters (OPCs) in five size ranges at three heights. Particulate mass concentrations were measured gravimetrically and bioaerosol concentrations were determined by impaction methods. Occupant activities and number concentrations were determined with 1-min resolution over a 1-week period. Occupant activities such as walking past or visiting the monitoring site explained 24-55% of the variation of 1- to 25-micron diameter particle number concentrations. Statistical models associating particulate concentrations with occupant activities depended on the size fraction and included an autocorrelative term. Occupant activities are estimated to contribute up to 10 micrograms m-3 in particulate concentrations per person. Number concentrations of particles smaller than 1 micron had little correlation with indoor activities other than cigarette smoking and were highly correlated with outdoor levels. The method can be used to characterize emissions from activities if rapid measurements can be made and if activities can be coded from the video record.     

Treatment of gas-phase methanol in conventional biofilters packed with lava rock

The performance of laboratory scale methanol-degrading biofilters packed with lava rock was checked during almost 1 yr under different conditions. The biomass concentration and biomass adaptation of the inoculum dramatically affected the start-up and the performance of the systems during the first stages of operation. A fast start-up was obtained when using concentrated and adapted inocula, while diluted or non-adapted inocula proved to be much less efficient. The performance of the reactor during long-term operation was significantly affected by the toxic load and moisture content of the gas. Critical loads between 120 and 280 g/m(3)h were reached during different phases of the study. The reactor had a high stability to EBRT changes when working at values between 48.0 and 91.1s, showing little or no negative effect when decreasing the EBRT. Hardly any difference was observed regarding performance when using either a downflow or upflow feed, although slightly better results were obtained when working in a downflow mode.     

An extension of ASM2d including pH calculation

This paper presents an extension of the Activated Sludge Model No. 2d (ASM2d) including a chemical model able to calculate the pH value in biological processes. The developed chemical model incorporates the complete set of chemical species affecting the pH value to ASM2d describing non-equilibrium biochemical processes. It considers the system formed by one aqueous phase, in which biochemical processes take place, and one gaseous phase, and is based on the assumptions of instantaneous chemical equilibrium under liquid phase and kinetically governed mass transport between the liquid and gas phase. The ASM2d enlargement comprises the addition of every component affecting the pH value and an ion-balance for the calculation of the pH value and the dissociation species. The significant pH variations observed in a sequencing batch reactor operated for enhanced biological phosphorus removal were used to verify the capability of the extended model for predicting the dynamics of pH jointly with concentrations of acetic acid and phosphate. A pH inhibition function for polyphosphate accumulating bacteria has also been included in the model to simulate the behaviour observed. Experimental data obtained in four different experiments (with different sludge retention time and influent phosphorus concentrations) were accurately reproduced.     

Contact flocculation-filtration of humic substances

Contact flocculation-filtration of humic dispersions with alum in medium grain (0.62 mm) sand gave short runs to breakthrough, while in coarse (1.2 mm) media clarification was inefficient. Alum with cationic polymer gave in coarse media acceptable runs, but shorter then for mineral dispersions. Analysis of results by parameters of existing filtration models showed that using the Ives-Iwasaki model and plotting filtration coefficient λ vs specific deposit σ gave different λ_max for different polymer dose, plot of λ_max vs dose goes through maximum at optimum dose.Plotting the cube root of headloss vs square root of specific deposit gave a straight line corresponding to Shektman formula.Analysis by Adin-Rebhun model showed that for contact flocculation-filtration humic dispersions attachment coefficient k₁ was similar to, detachment k₂ was many fold higher then and theoretical maximum mass capacity much lower then in case of mineral dispersions.Calculations showed that the solid content and the density of alumo-organic deposits in bed are much lower than of alumo-mineral deposits. Polymers and minerals increase the solid content, the density of deposits and the mass capacity of filter beds.     

A study of a water-reducing agent from cashew nutshell liquid

The water-reducing agent better known as superplasticizer is a recent development. A number of base materials have been used for the development of such water-reducing agents which can act better than ordinary plasticizers in concrete. The sulphonated salts of melamine, napthalene, lignin, hydroxycarboxylic acids and hydroxylated polymers are some typical compounds. Recently cashew nutshell liquid obtained from a natural product waste as a thick black phenolic compound has been converted into a water-reducing agent. This paper describes the results obtained on its effectiveness in influencing the rheological properties of flow, viscosity, particle size distribution, etc, of cement particles in hydrating cements and the water-reducing capabilities in cement mortars and concretes.     

Attitudes towards regionalism in a rapid growth suburb

A key issue confronting our newer suburbs is the stance they should take towards efforts at regional cooperation and coordination of major policy areas. This article analyzes the preferences on this issue held by residents in a rapid growth suburb in the St. Louis metropolitan area. Through factor analysis, four identifiable dimensions of regionalist preferences were obtained from questionnaire responses--administrative cooperation, land-use cooperation, mass transit cooperation, and regional basic services cooperation. Correlational analyses between these dimensions of regionalist preferences and selected community status characteristics, social situation characteristics, and local political participation status of respondents reveal no systematic covariation. Thus municipal policies which influence the population mix within a community with respect to the life situation characteristics measured in this study are not likely to be useful instruments for influencing the preferences, pro or con, of the community towards regionalist policies. Further, local political participants are found to be representative of the larger community's regionalist policy preferences.     

Landscape structure indices for assessing urban ecological networks

Analysis and planning of ecological networks is a relatively new phenomenon and is a response to fragmentation and deterioration of quality of natural systems. In urban areas, the problems of land use intransigence, political and jurisdictional issues create a difficult environment for implementing ecological networks. The specific questions addressed in this research program revolve around the viability of planning an ecological network in an urban landscape. The development and articulation of an ecological network plan was undertaken previously and in this paper, a series of assays of landscape structure are used to examine the viability of an ecological network in the Phoenix, Arizona urban area. Three principal analyses were utilized: (1) patch content analysis, (2) corridor content analysis, and (3) network structure analysis. Patch and corridor content analyses examined the internal characteristic and immediate context for each of the 89 ecological network elements. The network structure analysis incorporates a process for aggregating results of patch and corridor analyses and incorporates indicators that describe interrelationships between landscape elements. For each of these analyses the existing condition was compared to the optimal plan to demonstrate the level of change that can be expected. The results and conclusions of this research are that an ecological network plan provides modest but important improvement in ecological systems in the Phoenix urban area.     

Effect of agitation, turbidity, aluminium foil reflectors and container volume on the inactivation efficiency of batch-process solar disinfectors

We report the results of experiments designed to improve the efficacy of the solar disinfection of drinking water, inactivation process. The effects of periodic agitation, covering the rear surface of the container with aluminium foil, container volume and turbidity on the solar inactivation kinetics of Escherichia coli (starting population = 10(6) CFU ml(-1)) were investigated. It was shown that agitation promoted the release of dissolved oxygen from water with subsequent decrease in the inactivation rates of E. coli. In contrast, covering the rear surface of the solar disinfection container with aluminium foil improved the inactivation efficiency of the system. The mean decay constant for bacterial populations in foil-backed bottles was found to be a factor of 1.85 (std. dev. = 0.43) higher than that of non-foil-backed bottles. Inactivation rates decrease as turbidity increases. However, total inactivation was achievable in 300 NTU samples within 8 h exposure to strong sunshine. Inactivation kinetics was not dependent on the volume of the water container for volumes in the range 500-1500 ml.