Autonomous Adsorption Cooling—Driven by Heat Storage Collected from Solar Heat

This study investigates the performance of an adsorption chiller driven by thermal heat collected from solar collectors’ panels with heat storage. The heat is reserved in a storage tank and the reserved heat is used to drive the adsorption chiller. The investigation was carried on the climatic conditions of Dhaka, Bangladesh. Heat transfer fluid goes from the collectors to the adsorption cooling unit, then from the adsorption cooling unit to the storage tank. It is seen that heat storage is more effective than direct solar coupling; however, it requires more collectors, depending on the size of the storage tank. The analysis shows that cycle time is one of the most influential parameters for the solar-driven adsorption cooling system. It is seen that the size of the collector can be reduced if the proper cycle time is adjusted. The analysis also revealed that the system with 22 collectors (each of 2.415 m²) along with 1000 s cycle time provides better performance for the base run conditions. It is also seen that the solar-driven adsorption chiller with heat storage works well beyond the sunset time.     

Hydrogen from solar energy,a clean energy carrier from a sustainable source of energy

Solar energy is going to play a crucial role in the future energy scenario of the world that conducts interests to solar-to-hydrogen as a means of achieving a clean energy carrier. Hydrogen is a sustainable energy carrier, capable of substituting fossil fuels and decreasing carbon dioxide (CO₂) emission to save the world from global warming. Hydrogen production from ubiquitous sustainable solar energy and an abundantly available water is an environmentally friendly solution for globally increasing energy demands and ensures long-term energy security. Among various solar hydrogen production routes, this study concentrates on solar thermolysis, solar thermal hydrogen via electrolysis, thermochemical water splitting, fossil fuels decarbonization, and photovoltaic-based hydrogen production with special focus on the concentrated photovoltaic (CPV) system. Energy management and thermodynamic analysis of CPV-based hydrogen production as the near-term sustainable option are developed. The capability of three electrolysis systems including alkaline water electrolysis (AWE), polymer electrolyte membrane electrolysis, and solid oxide electrolysis for coupling to solar systems for H₂ production is discussed. Since the cost of solar hydrogen has a very large range because of the various employed technologies, the challenges, pros and cons of the different methods, and the commercialization processes are also noticed. Among three electrolysis technologies considered for postulated solar hydrogen economy, AWE is found the most mature to integrate with the CPV system. Although substantial progresses have been made in solar hydrogen production technologies, the review indicates that these systems require further maturation to emulate the produced grid-based hydrogen.     

Graphene‐based ternary composites for supercapacitors

The research on electrode materials for supercapacitor application continues to evolve as the request of high‐energy storage system has increased globally due to the demand for energy consumption. Over the past decades, various types of carbon‐based materials have been employed as electrode materials for high‐performance supercapacitor application. Among them, graphene is 1 of the most widely used carbon‐based materials due to its excellent properties including high surface area and excellent conductivity. To exploit more of its interesting properties, graphene is tailored to produce graphene oxide and reduced graphene oxide to improve the dispersibility in water and easy to be incorporated with other materials to form binary composites or even ternary composites. Nowadays, ternary composites have attracted enormous interest as 2 materials (binary composites) cannot satisfy the requirement of the high‐performance supercapacitor. Thus, many approaches have been employed to fabricate ternary composites by combining 3 different types of electroactive materials for high‐performance supercapacitor application. This review focuses on the supercapacitive performance of graphene‐based ternary composites with different types of active materials, ie, conducting polymers, metal oxide, and other carbon‐based materials.     

Evidence of nano-galvanic couple formation on in-situ formed nano-aluminum amalgam surfaces for passivation-bypassed water splitting

Reaction of Al metal with water is a well-known technique for large scale production of hydrogen. However, this method suffers from kinetic limitations due to formation of a passivation layer on Al, preventing optimal operations. Using high resolution Scanning Kelvin Probe Force Microscopy (SKPFM), we show the origin of formation of 'nano-galvanic couple' on in situ formed nano-aluminum amalgam surfaces in a water splitting system; passivation based limitations are completely bypassed in this approach. Furthermore, they offer an opportunity to beneficiate and recover mercury in contaminated water. The nano-galvanic corrosion due to substantial lateral variation in surface contact potential is responsible for the observed high throughput of hydrogen production (720 mL/min per 0.5 g Al salt). It may be noted that this process fares better than in situ prepared nano-Al based hydrogen production, wherein 600 mL/min of hydrogen is obtained for 0.5 g Al salt. Investigations using Cyclic Voltammetry (CV) and Electrochemical Impedance Spectroscopy (EIS) provide evidence for passivation-bypassed hydrolysis and favourable kinetics for in situ derived nano-AlHg hydrolytic agents (when compared to nano-Al). This study, to the best of our knowledge, reports the first direct proof of nano-galvanic couple formation on in-situ prepared nanoaluminum amalgam surface; paving a direct way to overcome the long standing passivation problem in Al hydrolysis. It is found that the hydrogen production rate and standard deviation (SD) of the contact potential of nanoaluminum amalgam are directly related to the rate of addition of the reducing agent, offering an opportunity for kinetic control for the in situ hydrolytic process.     

CO2 methanation over Ni and Rh based catalysts: Process optimization at moderate temperature

H₂ was produced from aluminum/water reaction and reacted with CO₂ over Ni and Rh based catalysts to optimize the process conditions for CO₂ methanation at moderate temperature. Monometallic catalysts were prepared by incorporating Ni and Rh using nickel nitrate hexahydrate (Ni(NO₃)₂·6H₂O) and rhodium(III) chloride trihydrate (RhCl₃·3H₂O)as a precursor chemical. The preliminary study of the catalysts revealed higher activity and CH₄ selectivity for Rh based catalyst compared to that of Ni based catalyst. Further, Rh based catalyst was investigated using response surface methodology (RSM) involving central composite design. The quadratic model was employed to correlate the effects of variable parameters including methanation temperature, %humidity, and catalyst weight with the %CO₂ conversion, %CH₄ selectivity, and CH₄ production capacity. Analysis of variance revealed that methanation temperature and humidity play an important role in CO₂ methanation. Higher response values of CO₂ conversion (54.4%), CH₄ selectivity (73.5%) and CH₄ production capacity (8.4 μmol g^?1 min^?1) were noted at optimum conditions of 206.7°C of methanation temperature, 12.5% humidity and 100 mg of the catalyst. The results demonstrated the ability of Rh catalyst supported on palm shell activated carbon (PSAC) for CO₂ methanation at low temperature and atmospheric pressure.     

Detection of fresh palm oil adulteration with recycled cooking oil using fatty acid composition and FTIR spectral analysis

There is a growing concern over the food safety issue related to increased incidence of cooking oil adulteration with recycled cooking oil (RCO). The objective of this study was to detect fresh palm olein (FPO) adulteration with RCO using fatty acid composition (FAC) and Fourier-transform infrared spectroscopy (FTIR) spectral analyses combined with chemometrics. RCO prepared in the laboratory was mixed with FPO in the proportion ranged from 1% to 50% (v/v) to obtain the adulterated oil samples (AO). FACs for FPO, RCO, and AO were determined using gas chromatography equipped with a flame ionization detector (GC-FID). The compositions of most fatty acids in RCO lied within the normal ranges of Codex standard, except for C8:0, C10:0, C11:0, C15:0, trans C18:1, and polyunsaturated fatty acids (PUFAs), C20:5. PUFAs showed a consistent decreasing trend with increasing magnitude of change with respect to increasing adulteration level and thus might be a good indicator for detecting FPO adulteration with RCO. The evaluation parameters (coefficient of determination, root mean standard error) of the FTIR-partial least square (PLS) model of palm oil adulteration with recycled oil are R² = 0.995 and 3.25, respectively. For FTIR spectral analysis, the distinct variations in spectral regions and aberrations in characteristic bands between FPO and RCO were observed. The optimized PLS calibration model developed from normal spectral of the combined region at 3602–3398, 3016–2642, and 1845–650 cm^?1 overpredict the adulteration level. On the other hand, the discriminant analysis classification model was able to classify the FPO and AO into two distinct groups. Improvement of the principles of combined techniques in authenticating AO from fresh oil is beneficial as a guideline to detect adulteration in cooking oil.     

Optimize adaptive media playout using dynamic fuzzy logic control for video streaming

Multimedia Tools and Applications - Adaptive Media Playout (AMP) controls adapt playout rate to prevent buffer outage and to reduce delay in playout. Most AMP techniques use buffer fullness or its...     

PSW statistical LSB image steganalysis

Multimedia Tools and Applications - Steganography is the art and science of producing covert communications by concealing secret messages in apparently innocent media, while steganalysis is the art...     

Vital parameters for high gamma-aminobutyric acid (GABA) production by an industrial soy sauce koji Aspergillus oryzae NSK in submerged-liquid fermentation

Food Science and Biotechnology - In submerged-liquid fermentation, seven key parameters were assessed using one-factor-at-a-time to obtain the highest GABA yield using an industrial soy sauce koji...