Influence of corticotropin-releasing factor on pancreatic and islet blood flow in different regions of the rat pancreas

Corticotropin-releasing factor (CRF) has previously been shown to selectively dilate the mesenteric vascular bed, without affecting other vascular beds. Pancreatic blood flow and islet blood flow were therefore measured separately with a microsphere technique in the two regions of the rat pancreas perfused by the superior mesenteric artery (SMA) or celiac artery (CA) respectively. Intravenous infusion of CRF (0.25 microgram/kg b.w./min) caused an increase in both whole pancreatic blood flow and islet blood flow in the region of the pancreas perfused by the SMA. The fraction of whole pancreatic blood flow diverted through the islets in this part of the pancreas was, however, unaffected by CRF infusion (approximately 10%). CRF did not change either pancreatic or islet blood flow in the CA-perfused part of the pancreas, and did not affect the release of insulin.     

Energy storage devices for future hybrid electric vehicles

Powertrain hybridization as well as electrical energy management are imposing new requirements on electrical storage systems in vehicles. This paper characterizes the associated vehicle attributes and, in particular, the various levels of hybrids. New requirements for the electrical storage system are derived, including: shallow-cycle life, high dynamic charge acceptance particularly for regenerative braking and robust service life in sustained partial-state-of-charge usage. Lead/acid, either with liquid or absorptive glass-fibre mat electrolyte, is expected to remain the predominant battery technology for 14 V systems, including micro-hybrids, and with a cost-effective battery monitoring system for demanding applications. Advanced AGM batteries may be considered for mild or even medium hybrids once they have proven robustness under real-world conditions, particularly with respect to cycle life at partial-states-of-charge and dynamic charge acceptance. For the foreseeable future, NiMH and Li-ion are the dominating current and potential battery technologies for higher-functionality HEVs. Li-ion, currently at development and demonstration stages, offers attractive opportunities for improvements in performance and cost. Supercapacitors may be considered for pulse power applications. Aside from cell technologies, attention to the issue of system integration of the battery into the powertrain and vehicle is growing. Opportunities and challenges for potential “battery pack” system suppliers are discussed.     

Fatigue anisotropy in cross-rolled, hardened medium carbon steel resulting from MnS inclusions

Anisotropy of forged steel components is especially adverse when it concerns rotationally symmetric components. Manganese sulfides (MnS) in steels may be desired for their improvement of machining properties; however, they also deteriorate fatigue behavior. A quantification of the effect of MnS on anisotropy is necessary to find an optimum for component dimensioning. To isolate the influence of MnS on anisotropy only, high cleanness of the test material is required. The test material in the current investigation was molten in a vacuum furnace to high-cleanness composition. Materials with two different S levels were produced to detect variations in anisotropy according to amount, shape, and distribution of the MnS inclusions. The two batches were cross-rolled to plates with a deformation ratio of 4.5. The MnS phase constitutes, upon forging or rolling, pancake-shaped inclusions. In the case of cross-rolling, an in-plane rotational symmetry of the inclusions could be created. The shape and size of these inclusions are essential for the mechanical behavior of the material. Push-pull fatigue testing was performed in longitudinal (in plane) and short transversal directions relative to the rolling plane. The results showed strong anisotropy of the fatigue behavior with inferior performance in short transverse directions where the principal stress is perpendicular to the flattened inclusions. The anisotropy was somewhat more pronounced for the high-S material, resulting from a different fatigue crack growth mechanism.     

Treatment with the oral growth hormone secretagogue MK-677 increases markers of bone formation and bone resorption in obese young males

The effect of 2 months of treatment with the oral growth hormone (GH) secretagogue MK-677 on markers of bone metabolism was determined in healthy obese male subjects. This was a randomized, double-blind, parallel, placebo-controlled study. Twenty-four healthy obese males, 19-49 years of age, with body mass index > 30 kg/m2 were treated with MK-677 (25 mg/day; n = 12) or placebo (n = 12) for 8 weeks. MK-677 increased markers of bone formation; a 23% increase in the carboxy-terminal propeptide of type I procollagen levels and a 28% increase in procollagen III peptide levels were seen with as little as 2 weeks of MK-677 treatment (p < 0.01 and p = 0.001 vs. placebo, respectively) while a 15% increase in serum levels of osteocalcin was not detected until 8 weeks of treatment (p < 0.01 vs. placebo). Markers of bone resorption were induced within 2 weeks of treatment with MK-677; serum levels of the carboxy-terminal cross-linked telopeptide of type I collagen were increased 26% at 8 weeks (p = 0.001 vs. placebo), and urine hydroxyproline/creatinine and calcium/creatinine ratios at 8 weeks were increased by 23% (p < 0.05 vs. placebo) and 46% (p < 0.05 vs placebo), respectively, MK-677 increased serum insulin-like growth factor binding protein-5 (IGFBP-5) by 43-44% after 2-8 weeks of treatment (p < 0.01 vs. placebo). Serum IGFBP-4 was increased by 25% after 2 weeks of treatment (p < 0.001 vs. placebo) but no significant change from baseline was observed after 8 weeks of treatment. Plasma interleukin-6 was not significantly changed by active treatment. In conclusion, short-term treatment of healthy obese male volunteers with the GH secretagogue MK-677 increases markers of both bone resorption and formation. Large increases in serum levels of IGF-1 and IGFBP-5 and a transient increase in serum IGFBP-4 were found. Future long-term studies are needed to investigate if prolonged treatment with MK-677 increases bone mass.     

An anomaly in the necking behavior of polyethylene

Tensile creep measurements at constant load on nonoriented polyethylene have shown a marked transition at a certain stress level from a neck formation followed by instantaneous fracture to the formation of a neck which resists fracture for a considerable time. The transition, which shifts towards shorter time and higher nominal stress with increasing molecular weight, has been studied for 16 polyethylenes of different molecular weights, degrees of branching and crystalline structures. The marked. transition has only been observed for high density polyethylene of high molecular weight. Deformation measurements show a more distinct necking for the high density than for the medium density polyethylenes. This is consistent with current molecular deformation theories. A hypothesis for the transition is proposed based on the distinctness of the neck process in the high density polyethylene and the large difference in strength between the spherulitic structure and the fibrillar structure. The dependence of the transition on molecular weight is expected since the number of tic chains incrcrtses with increasing molecular weight.     

A dual-affinity gene fusion system to express small recombinant proteins in a soluble form: expression and characterization of protein A deletion mutants

A novel gene fusion system to express and purify small recombinantproteins in Escherichia coli has been constructed. The conceptallows for affinity purification of soluble gene products bysequential albumin- and Zn²+-affinity chromatography. The dual-affinitysystem is well suited for expression of unstable proteins asonly full-length protein is obtained after purification andproteins gain proteolytic stability in the fusion protein. Herewe show that the dual-affinity approach can be used for theexpression of various unstable derivatives of a single IgG-bindingdomain based on staphylococcal protein A. Analysis of the proteolyticstabilities and the IgG-binding properties of the differentmutant proteins suggest that the model for the structure ofan IgG-binding domain must be re-evaluated.     

Quasi three-dimensional, n-bit optical memory based on the ellipsometric principle: model calculations

Model calculations on the ellipsometric memory are presented. The ellipsometric memory is an n-bit optical memory whose information is extracted by use of the ellipsometric principle. The memory cells of the device consist of thin-film multilayer structures, and the information of each memory cell is contained in the optical properties of the thin films. Several thin-film multilayer structures were examined in order to find out how different choices of layer materials and other system parameters such as layer thicknesses and wavelength affect resolutions and limitations of the ellipsometric memory. Such calculations are also useful for optimizing the readout resolution. It was found that it is possible to use memory cells having up to at least eight layers, which would permit 8-bit words to be stored at each location. It was also found that, in principle, several types of materials can be used as layer materials, and various aspects of different choices of materials are discussed.     

Artificial Agent Action in Markets

We summarise our experiences of a number of demonstrators and simulation experiments designed to test the feasibility of using artificial decision making agents in real-time domains, and comment on the significance of our results to autonomous artificial agent action patterns in markets. Our main hypothesis is that the use of norms can extend the capability of artificial decision makers beyond what is obtained from implementing individual utility maximizers in keeping with rational choice theory.     

A Secure Grid Medical Data Manager Interfaced to the gLite Middleware

The medical community is producing and manipulating a tremendous volume of digital data for which computerized archiving, processing and analysis is needed. Grid infrastructures are promising for dealing with challenges arising in computerized medicine but the manipulation of medical data on such infrastructures faces both the problem of interconnecting medical information systems to Grid middlewares and of preserving patients’ privacy in a wide and distributed multi-user system. These constraints are often limiting the use of Grids for manipulating sensitive medical data. This paper describes our design of a medical data management system taking advantage of the advanced gLite data management services, developed in the context of the EGEE project, to fulfill the stringent needs of the medical community. It ensures medical data protection through strict data access control, anonymization and encryption. The multi-level access control provides the flexibility needed for implementing complex medical use-cases. Data anonymization prevents the exposure of most sensitive data to unauthorized users, and data encryption guarantees data protection even when it is stored at remote sites. Moreover, the developed prototype provides a Grid storage resource manager (SRM) interface to standard medical DICOM servers thereby enabling transparent access to medical data without interfering with medical practice.