Untersuchungen zur Dauerfestigkeit carbonitrierter Proben aus den Einsatzstählen 18CrNiMo7‐6und 20MnCr5

The endurance limit of carbonitrided specimens of 18CrNiMo7‐6 and 20MnCr5 case hardening steels were examined under bending conditions. Four variants were manufactured differing in heat treatment and surface conditions. Besides conventional gas carburised variants, carbonitrided specimens with a low and a raised nitrogen content of 0.2 and 0.45% at the surface as well as a carbonitrided and ground variant were examined. The specimens were tested with stress ratios R = –1 and 0. Depending on the nitrogen content cyclic loading evokes compressive residual stresses at the specimens' surfaces, caused by elastic‐plastic deformation. Specimens of the ground variant show additionally a decrease of the residual austenite content when cycled. The induced compressive residual stresses are substantially responsible for high endurance limits at both stress ratios and are the key for understanding the beneficial effect of carbonitriding in this regard.     

4‐Biphenylalanine‐ and 3‐Phenyltyrosine‐Derived Hydroxamic Acids as Inhibitors of the JumonjiC‐Domain‐Containing Histone Demethylase KDM4A

Overexpression of the histone lysine demethylase KDM4A, which regulates H3K9 and H3K36 methylation states, has been related to the pathology of several human cancers. We found that a previously reported hydroxamate‐based histone deacetylase (HDAC) inhibitor (SW55) was also able to weakly inhibit this demethylase with an IC₅₀ value of 25.4 μm . Herein we report the synthesis and biochemical evaluations, with two orthogonal in vitro assays, of a series of derivatives of this lead structure. With extensive chemical modifications on the lead structure, also by exploiting the versatility of the radical arylation with aryldiazonium salts, we were able to increase the potency of the derivatives against KDM4A to the low‐micromolar range and, more importantly, to obtain demethylase selectivity with respect to HDACs. Cell‐permeable derivatives clearly showed a demethylase‐inhibition‐dependent antiproliferative effect against HL‐60 human promyelocytic leukemia cells.     

The Impact of Polyoxyethylene Sorbitan Surfactants in the Microstructure and Rheological Behaviour of Emulsions Made With Melted Fat From Cupuassu (<Emphasis Type="Italic">Theobroma grandiflorum</Emphasis>)

Cupuassu fat is a good candidate for partial substitution of cocoa butter in many products, including emulsions. However, for such use it is necessary to know the characteristics of the products prepared with cupuassu fat. Therefore, the main goal of this work is to characterize emulsions prepared with cupuassu fat using the surfactants Tween^® 60, Tween^® 80 and Tween^® 85 as emulsifiers. The emulsions were prepared at 43 °C with addition of 0.5 or 1.5 % (w/v) of surfactant and compared with an emulsion without surfactant. All emulsions were analysed by conductivity, stability, pH, optical microscopy, rheology and oxidative stability. It was verified that the emulsions prepared with Tween^® 60 and Tween^® 80 have higher stability, smaller droplet size and higher apparent viscosity. Also, these properties are positively influenced by the concentration of the surfactant. On the other hand, emulsions prepared with Tween 85 or without surfactant reached unsatisfactory results. The rheological behaviour of the emulsions was adequately described by both Herschel-Bulkley and Mizhari-Berki models revealing pseudoplastic character. These emulsions also present strong gel behaviour, with storage modulus higher than loss modulus. In conclusion, cupuassu fat can be used as oil phase for emulsions products and this characterization helps to understand their behaviour in order to increase their use in food industry.     

Profiling of the Bacterial Microbiota along the Murine Alimentary Tract

Here, the spatial distribution of the bacterial flora along the murine alimentary tract was evaluated using high throughput sequencing in wild-type and Tff3-deficient (Tff3^KO) animals. Loss of Tff3 was linked to increased dextran sodium sulfate-induced colitis. This systematic study shows the results of 13 different regions from the esophagus to the rectum. The number of bacterial species (richness) increased from the esophagus to the rectum, from 50 to 200, respectively. Additionally, the bacterial community structure changed continuously; the highest changes were between the upper/middle and lower gastrointestinal compartments when comparing adjacent regions. Lactobacillus was the major colonizer in the upper/middle gastrointestinal tract, especially in the esophagus and stomach. From the caecum, a drastic diminution of Lactobacillus occurred, while members of Lachnospiraceae significantly increased. A significant change occurred in the bacterial community between the ascending and the transverse colon with Bacteroidetes being the major colonizers with relative constant abundance until the rectum. Interestingly, wild-type and Tff3^KO animals did not show significant differences in their bacterial communities, suggesting that Tff3 is not involved in alterations of intraluminal or adhesive microbiota but is obviously important for mucosal protection, e.g., of the sensitive stem cells in the colonic crypts probably by a mucus plume.     

SMART-Reactors: Tailoring Gas Holdup Distribution by Additively Manufactured Lattice Structures

In chemical process engineering, fast gas-liquid reactions often suffer from an inefficient distribution of gas and therefore mixing and mass transfer performance. This study deals with the possibility of influencing the local gas holdup and bubble size distribution in a gas-liquid process using additively manufactured lattice structures (AMLS). The used measuring technique to study bubble size, velocity, and the local gas holdup is a photo-optical needle probe. By using AMLS, a significant radial homogenization of the local gas holdup and the mean bubble size is achieved. Furthermore, it can be demonstrated that the bubble size can be tailored by the geometry of the inserted structure. It is illustrated that the mean bubble velocities are lowered within the lattice resulting in a higher residence time of the dispersed phase with an impact on the mass transfer performance within the AMLS.     

Lipoxygenase Products in the Urine Correlate with Renal Function and Body Temperature but not with Acute Transplant Rejection

Acute transplant rejection is the leading cause of graft loss in the first months after kidney transplantation. Lipoxygenase products mediate pro- and anti-inflammatory actions and thus we aimed to correlate the histological reports of renal transplant biopsies with urinary lipoxygenase products concentrations to evaluate their role as a diagnostic marker. This study included a total of 34 kidney transplant recipients: 17 with an acute transplant rejection and 17 controls. LTE4, LTB4, 12-HETE and 15-HETE concentrations were measured by enzyme immunoassay. Urinary lipoxygenase product concentrations were not significantly changed during an acute allograft rejection. Nevertheless, LTB4 concentrations correlated significantly with the body temperature (P ≤ 0.05) 3 months after transplantation, and 12- and 15-HETE concentrations correlated significantly with renal function (P ≤ 0.05) 2 weeks after transplantation. In conclusion, our data show a correlation for LTB4 with the body temperature 3 months after transplantation and urinary 12- and 15-HETE concentrations correlate positively with elevated serum creatinine concentrations but do not predict acute allograft rejection.     

Transition and flow boiling heat transfer inside a horizontal tube

Experiments on transition and flow boiling heat transfer with refrigerant R114 inside a horizontal tube were performed at bubble flow, critical heat flux and in the transition region between bubble flow and film boiling at mass fluxes between 1200 and 4000 kg/m² s and in the pressure range between 5 and 15 bar. In comparison with pool boiling bubble flow heat transfer depends essentially on the mass flow rates and on the vapor quality. The critical heat flux depends less on the temperature difference than in pool boiling heat transfer and exhibits a maximal and a minimal value as a function of the pressure. The critical heat flux increases with mass flow rate as already shown by Collier. In the region of transition boiling the heat flux over the difference between wall and saturation temperature approaches a horizontal curve. Therefore in this region an evaporator may always be operated under stable conditions and burn out does not occur.     

The Effect of processing on the content and composition of free sterols and sterol esters in soybean oil

The content and composition of free sterols and sterol esters in crude soybean oil and in oils from different stages of two continuous refining systems were determined. The sterols were isolated by preparative thin layer chromatography and analyzed by gas chromatography with cholesterol as an internal standard. The free sterols in one of the degummed oils amounted to 3.1 mg/g and were diminished to 1.8 mg/g oil by the De Laval Short-Mix refining process. The content of free sterols of the other degummed oil was reduced from 3.4 to 1.6 mg/g oil by the Zenith process. The greatest reduction of sterol content was caused by the treatment with bleaching earth. The sterol esters accounted for 0.6 mg/g of the degummed oil, and only very small changes were observed during the processes. However, changes in the composition of fatty acids of the sterol esters were found. These changes might indicate a selective deacylation of sterol esters or an interesterification during the refining processes. The composition of sterols in free and esterified form were different. Campesterol, stigmasterol and sitosterol were obtained in both free and esterified form, but Δ7 stigmasterol was only found in esterified form. Only small changes in the percentage distribution of the sterols occurred during the processes. Present adress Food Technology Division, ALFA-LAVAL,S-14700 Tumba, Sweden     

Säurekatalysierte Umsetzungen von Aromaten mit Alkanen und Cycloalkanen. IX. Alkylierungen mit 2,2,4-Trimethylpentan (Isooctan)

Acid-catalyzed Reactions of Aromatic Hydrocarbons with Alkanes and Cycloalkanes. IX. Alkylations with 2,2,4-Trimethylpentane (Isooctane) The non-conventional alkylation of benzene, toluene, ethyl- and isopropylbenzene, fluoro- and chlorobenzene with 2,2,4-trimethylpentane in the presence of acid catalysts is described. The composition of the rather complex reaction mixtures is determined by gas-liquid chromatography and mass spectrometry, tert. butylarenes being the main products beside alkylsubstituted indanes and tetralines. Their formation is interpreted as a competition between fragmentation and isomerization of the alkylating agent. By use of trifluoromethanesulfonic acid or combinations of catalysts from HF or HSO₃F with variant metallic fluorides at lower temperatures the selectivity of the reaction may be partially raised.     

PV solar electricity industry: Market growth and perspective

The photovoltaic (PV) solar electricity market has shown an impressive 33% growth per year since 1997 until today with market support programs as the main driving force. The rationales for this development and the future projections towards a 100 billion € industry in the 2020s, by then only driven by serving cost-competitively customer needs are described.The PV market, likely to have reached about 600 MW in the year 2003, is discussed according to its four major segments: consumer applications, remote industrial electrification, developing countries, and grid-connected systems. While in the past, consumer products and remote industrial applications used to be the main cause for turnover in PV, in recent years the driving forces are more pronounced in the grid-connected systems and by installations in developing countries. Examples illustrating the clear advantage of systems using PV over conventional systems based, e.g., on diesel generators in the rural and remote electrification sector are discussed. For the promotion of rural electrification combined with the creation of local business and employment, suitable measures are proposed in the context of the PV product value chain.The competitiveness of grid-connected systems is addressed, where electricity generating costs for PV are projected to start to compete with conventional utility peak power quite early between 2010 and 2020 if time-dependent electricity tariffs different for bulk and peak power are assumed. The most effective current-pulling force for grid-connected systems is found to be the German Renewable Energy (EEG) Feed-in Law where the customers are focusing on yield, performance, and long-life availability.The future growth in the above-defined four market segments are discussed and the importance of industry political actions in order to stimulate the markets either in grid-connected systems by feed-in tariff programs as well as for off-grid rural developing country applications by long-term financing schemes are pointed out.A technology roadmap is presented with special emphasis on the fact that different customer needs are best served with best-adopted technologies and not vice versa. The need for the third generation PV technologies, implying that so called first (c-Si-wafer)- and second (thin-film)- generation PV technologies will be overcome in a short to medium time scale, is obsolete; in contrast, the excellent scientific ideas developed within ‘Third generation’ concepts—like utilization of hot electrons, quantum wells and nanostructures—are shown to be part of ‘New Technologies’ opening new product ideas and additional market segments. The rationale for decreasing cost by increasing productivity for all technologies as well as the interpretation of price learning curves is presented.The role of PV in the future global energy supply chain is lined out. Due to a fast growing market driven by increasing widespread acceptance of PV, a substantial PV business and creation of employment in coming decades is expected. This in turn can provide solutions for nowadays global issues, such as a global energy justice by providing environmentally benign power to billions of people, who otherwise will lack energy solutions severely.