The residential gateway

Burgeoning competition in telecommunications is multiplying the number of communications paths into the home-but a standard multinetwork connection could sort them out. Services going into the residence may enter over copper wires, hybrid fiber coax, RF transmission, fiber to the curb, or, most importantly, by any combination of these sources and structures. To have a successful market, residential customers must be able to move smoothly from one combination of these offerings to another so that the customers consider the move worthwhile. For this multinetwork-to-multiservice interconnection to have value, it must be simple, and that simplicity is the basis for the residential gateway concept. In other words, the substantial complexity of the interconnection must be hidden from the consumer. The concept is essentially the development of a set of interface standards between the broadband residential access networks and the communication services (the internal networks) required for the consumer's home     

Chebyshev multilevel absorber design concept

Pyramidal- and wedge-absorber materials are used extensively in anechoic measurement chambers to attenuate stray signals. Typical absorber layouts result in large absorber walls in which the absorber tips and bases are roughly aligned in the same plane. Such a quasi-periodic configuration produces a strong coherent specular reflection which dominates the absorber scattered field. Based on the multisection impedance transformer concept, one can divide absorber elements into different levels (layers) so that this coherence can be destroyed to reduce the specular absorber scattering level. The synthesis of this desired behavior can be implemented by the Chebyshev transformer technique, which provides the largest bandwidth given a passband ripple threshold. The resulting reflected field is then the product of the original absorber response times the Chebyshev reduction factor, which is independent of polarization and absorber properties. Various measured results are used to show that more than a 10-dB improvement can be achieved at the critical low end of the frequency band using this approach. This improvement cannot be achieved using conventional design concepts unless the absorber size is doubled     

Mathematical foundations for error estimation in numericalsolutions of integral equations in electromagnetics

The problem of error estimation in the numerical solution of integral equations that arise in electromagnetics is addressed. The direct method (Green's theorem or field approach) and the indirect method (layer ansatz or source approach) lead to well-known integral equations both of the first kind [electric field integral equations (EFIE)] and the second kind [magnetic field integral equations (MFIE)]. These equations are analyzed systematically in terms of the mapping properties of the integral operators. It is shown how the assumption that field quantities have finite energy leads naturally to describing the mapping properties in appropriate Sobolev spaces. These function spaces are demystified through simple examples which also are used to demonstrate the importance of knowing in which space the given data lives and in which space the solution should be sought. It is further shown how the method of moments (or Galerkin method) is formulated in these function spaces and how residual error can be used to estimate actual error in these spaces. The condition number of all of the impedance matrices that result from discretizing the integral equations, including first kind equations, is shown to be bounded when the elements are computed appropriately. Finally, the consequences of carrying out all computations in the space of square integrable functions, a particularly friendly Sobolev space, are explained     

Designing better adaptive sampling algorithms for ECG Holtersystems

Let Ψ be any adaptive sampling algorithm that can run in real time on a tapeless multichannel electrocardiogram (ECG) Holter system. Simple methods which can significantly improve Ψ's fidelity are described and their results are compared in this paper. It is shown that by adding some simple tests to Ψ, the signals reconstructed by Ψ can be improved as much as 5.45 dB. It is also shown that under the same data rate, a good data compressor with slowly sampled input ECG is preferable to a bad data compressor with highly sampled input ECG     

Spotlight mode SAR stereo technique for height computation

This paper examines the feasibility of extracting three-dimensional (3-D) or topographic information in spotlight mode stereo synthetic aperture radar (SAR). A display of a SAR (intensity) image has two axes: range and cross-range. Elevated scatterers appear closer in range; this phenomenon is called radar image layover. How the height of each scatterer can be computed from the difference in its layover between two images is investigated. This is analogous to computing height from disparity distance (triangulation) in optical stereo. The same procedure can be applied on pixel by pixel basis for terrain elevation mapping. A general expression is derived for the accuracy of the height estimate as a function of the range resolution and the angular difference between the image planes. Accuracy increases as the angle between the image planes increases, but the bright scatterers in one image tend to fade in the other image. This limited angular persistence of radar scatterers is also discussed. Trajectories for data collection are examined that provide near-optimal height estimates while eliminating the scatterer persistency problem.     

Tensile and flexural creep rupture tests on partially-damaged concrete specimens

Three series of novel tensile and flexural creep tests on partially-damaged concrete specimens were carried out in order to gain some insight into creep crack growth and failure of strain-softening materials. In the tests, each specimen was initially loaded to a given point in the descending branch and thus had a lower load-carrying capacity than that at the peak-point. Then, the specimen was unloaded and reloaded to sustain a load which was from 70% to 95% of its current load-carrying capacity. Experimental creep curves display a three-stage process, consisting of primary, secondary and tertiary stages, with a decreasing, constant and increasing creep rate, respectively. The secondary stage dominates the whole failure lifetime, whereas both the secondary and tertiary stages are important in terms of creep deformation. Failure life-time seems to be more sensitive to the change of load level in flexural tests rather than in tensile tests. The decrease in load-carrying capacity due to damage tends to result in a shorter failure lifetime and a lower critical load level for creep rupture. The descending branch of the static load-deflection or load-CMOD curve may be used as an envelope criterion for creep fracture.     

Fullerene Reactivity in an Oxygen Plasma

Fullerene reactivity in an oxygen plasma was measured and compared with those determined under the same conditions for a comprehensive set of 50 carbon materials. The possible reasons for the high plasma reactivity of the fullerene sample in an oxygen plasma are discussed.     

Anatomical basis of the variable aspects of injuries of the axillary nerve (excluding the terminal branches in the deltoid muscle)

The course of the axillary n. is complex with three points of angulation that may be used to delineate four segments and a fifth segment that corresponds to the intramuscular ending of the nerve in the deltoid m. The purpose of this study was to determine the precise anatomy of the nerve and of its branches, and some morphologic features for each segment. Thirty-two shoulders from embalmed adult cadavers have been studied. The axillary n. was divided in five segments: 1) from its origin to the inferior border of the subscapularis m., 2) from the subscapularis m. to the anterolateral border of the tendon of the long head of the triceps brachii m., 3) from the triceps to the posteromedial part of the surgical neck of the humerus, 4) from the humerus to the entry into the deltoid m., 5) the intramuscular distribution of the nerve in the deltoid m. In each segment from 1 to 4 were noted the origins of the branches to the subscapularis and teres minor mm. and to the scapulohumeral joint, and the origins of the lateral cutaneous branchial n. and of the terminal motor branches to the deltoid m. The length and the diameter of the nerve in the segments and the distance from the segment S1 to the musculotendinous junction of the subscapularis m. were measured. The results showed that the mean diameters were about 4.1 mm in segment 1, 4.1 mm in segment 2 and 3.4 mm in segment 3. The mean distance to the musculotendinous junction was 7.7 mm. Many variations in the levels of origin of the different muscular, articular or cutaneous branches were found without symmetry between the right and left sides. The lateral cutaneous brachial n. was absent in four cases. The results are compared with those in the literature. The division into five segments is proposed to radiologists and surgeons for evaluation or operative procedures on the axillary n., and to provide a hypothesis about the variable aspects of injuries of the nerve.     

Hypercoagulability and chronic atrial fibrillation: the role of markers of thrombin generation

BACKGROUND: We have studied 64 patients with congestive heart failure, half of them also with chronic nonvalvular atrial fibrillation (AF). Patients were also stratified according to a history of prior stroke. METHODS: The generation of thrombin was investigated by means of the molecular markers prothrombin fragment 1 + 2 (F1 + 2) and thrombin-antithrombin III complex (TAT), because AF patients may have a hypercoagulable state. There was only a trend toward higher values of TAT and F1 + 2 for AF patients, while subjects with previous stroke (irrespective of AF) had increased levels of the markers of thrombin generation (TAT stroke+ 18.95 +/- 5.15 vs TAT stroke- 8.34 +/- 2.41; F1 + 2 stroke+ 2.22 +/- 0.29 vs F1 + 2 stroke- 1.32 +/- 0.12). The presence of spontaneous echo contrast (SEC) within left atrium was also investigated in 32 AF patients by transesophageal echocardiography. RESULTS: TAT were significantly higher in subjects (n = 11) with SEC (TAT sec+ 37.5 +/- 13.41 vs TAT sec- 8.7 +/- 2.51, p = 0.008). CONCLUSIONS: Finally, when we grouped into 1) those with both AF and stroke, 2) AF alone, 3) stroke alone and 4) sinus rhythm without stroke, levels of F1 + 2 were higher (and marginally higher TAT) in patients with AF and stroke than in those without stroke, revealing that there is a true clotting activation state in these subjects.