间苯二酚溶剂萃取液液相平衡研究

测定了“醋酸正丁酯-间苯二酚(溶质)-盐水(含0.2质量分率NaCl)”三元系在24℃、101.33kPa下的液液相平衡数据并给出了三角相图,用Hand公式对相平衡数据进行了关联,获得了可供工业连续萃取过程设计使用的关联式。本研究将醋酸正丁酯和正丁醇作为溶剂萃取间苯二酚进行了对比,并指出:醋酸正丁酯优于正丁醇。     

低价硫化铝法从氧化铝直接炭还原制铝的动力学研究

低价硫化铝法从氧化铝直接炭还原制铝的动力学过程极为复杂,过程的前期受界面化学反应控制,过程后期受扩散过程控制,并求得不同时期的活化能,反应前期:E1=63.81 kJ/mol(6.67 Pa)、E2=50.82 kJ/mol(66.7 Pa)、E3=54.72 kJ/mol(666.7 Pa)、E4=39.61 kJ/mol(1333 Pa);反应后期:E*1=112.90 kJ/mol(6.67 Pa)、E*2=89.92 kJ/mol(66.7 Pa)、E*3=97.32 kJ/mol(666.7 Pa)、E*4=51.83 kJ/mol(1333 Pa).从动力学的角度提出了反应的较佳条件.温度、真空度的提高一方面可增大反应速率,但另一方面却加大了硫化铝的挥发,仅从增大速率而言,温度应大于1100 ℃,真空度应优于1333 Pa为宜.     

用分解法编制轴类零件图程序

采用分解法编写轴类零件程序，即将具有典型结构的轴分解成若干部分，把每一部分编成通用子程序，连同尺寸标注子程序、表面粗糙度子程序、剖面线子程序、尺寸公差及形位公差子程序等一并存贮在程序库中，需要时一一调用。     

高精细数字会聚校正系统

数字会聚校正使1%的会聚精度提高到0.1%以上。本文叙述了数字会聚校正系统的设计要求,工作原理以及设计计算,给出了在投影电视上的试验结果,最后,指出了今后发展的方向。     

Comments on “Multiphase systolic algorithms for spectraldecomposition” [and reply]

Comments that the paper by Liu and Yao (see ibid., vol.40, no.1, p.190, 1992) presented an efficient algorithm for spectral decomposition, but the parallel algorithm and architecture for the Hessenberg reduction has a problem. The matrix obtained from the unitary similarity transformation is not necessarily a Hessenberg matrix. The authors reply that the Hessenberg reduction described is not in the Hessenberg form. Only the first column is in its proper form. There are many ways to overcome such a problem. One simple way is to use the multiphase rectangular systolic array     

电子仪器发展趋势

本文在回顾了电子仪器近百年发展的历史的基础上,对国际电子仪器制造商、电子仪器行业及电子仪器本身的发展趋势,以及我国电子仪器的发展情况进行了分析归纳和总结.     

Recovery of pyruvic acid with weakly basic polymeric sorbents

BACKGROUND: Carboxylic acids are among the most important substances that can be manufactured from biomass. However, the recovery of carboxylic acids from fermentation broths presents a challenging separation problem. To avoid the production of waste salts and net consumption of chemicals in the calcium carboxylate salt process, the use of reversible chemical complexation with polymeric sorbents and extractants is attractive for carboxylic acid recovery. Pyruvic acid is widely used in the manufacture of medicines, pesticides and foodstuffs and can be produced by fermentation. Since the acidity of pyruvic acid (pK_a = 2.49) is stronger than that of normal carboxylic acids, and as few reports on the recovery of pyruvic acid are available, the sorption of pyruvic acid from aqueous solution on two types of weakly basic polymeric sorbent, tertiary amine D301R and primary amine D392, was investigated over a wide pH range and at various salt (MgSO₄) concentrations. RESULTS: Overloading adsorption of pyruvic acid on both weakly basic polymeric sorbents occurred, with the overloading of D392 being greater than that of D301R. The adsorption of pyruvic acid on both sorbents was greatly affected by the solution pH and the salt concentration in the aqueous phase. An overloading model was able to predict the experimental uptake data very well. CONCLUSION: Solution pH is one of the most important operating conditions, and both polymeric sorbents D392 and D301R can be used to recover pyruvic acid from dilute aqueous solution with high efficiency at a solution pH around 2. The uptake by D392 is greater than that by D301R owing to steric hindrance of the tertiary amine. Copyright © 2008 Society of Chemical Industry     

Organic‐acid‐catalyzed sol–gel route for preparing poly(methyl methacrylate)–silica hybrid materials

In this study, a series of organic–inorganic hybrid sol–gel materials consisting of a poly(methyl methacrylate) (PMMA) matrix and dispersed silica (SiO₂) particles were successfully prepared through an organic‐acid‐catalyzed sol–gel route with N‐methyl‐2‐pyrrolidone as the mixing solvent. The as‐synthesized PMMA–SiO₂ nanocomposites were subsequently characterized with Fourier transform infrared spectroscopy and transmission electron microscopy. The solid phase of organic camphor sulfonic acid was employed to catalyze the hydrolysis and condensation (i.e., sol–gel reactions) of tetraethyl orthosilicate in the PMMA matrix. The formation of the hybrid membranes was beneficial for the physical properties at low SiO₂ loadings, especially for enhanced mechanical strength and gas barrier properties, in comparison with the neat PMMA. The effects of material composition on the thermal stability, thermal conductivity, mechanical strength, molecular permeability, optical clarity, and surface morphology of the as‐prepared hybrid PMMA–SiO₂ nanocomposites in the form of membranes were investigated with thermogravimetric analysis, differential scanning calorimetry, dynamic mechanical analysis, gas permeability analysis, ultraviolet–visible transmission spectroscopy, and atomic force microscopy, respectively. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008