Pressure release of containments during severe accidents in Switzerland

As required by the Swiss Federal Nuclear Safety Inspectorate (HSK) all Switzerland's five nuclear power plants have to install a containment filtered venting system. The integrity of the containment (the last barrier for radioactive releases to the environment) can be threatened by overpressure due to inadequate heat removal. Design requirements have been provided for a specific class of severe accident scenarios. In general the capacity of the system is considered sufficient if it is able to vent the steam production corresponding to a decay heat level of 1% of the thermal reactor power. The mitigation capacity for the reduction of released radioactive material is specified by a retention factor of 1000 for aerosols to prevent or limit a long term ground contamination and a factor of 100 for elementary iodine for prevention or limiting of thyroid doses and to avoid short term evacuation. Besides existing requirements for design, maintenance and operation, additional claims such as passivity and operability at any pressure conditions inside the containment have to be met. Passivity implies that the system can be initiated after a severe accident without any operator action. The system also has to allow early manual venting. Various filtered venting systems are presently available. The nuclear power plants of Beznau, Gosgen, Leibstadt and Muhleberg have already selected such systems and already implemented them or are going to install them step by step. Beznau selected the Sulzer-EWI system which is using a water pool with nozzles-baffle plates and mixing elements to achieve the required filtration of the aerosols. In both Beznau units, the systems are installed and in standby mode. Gosgen, a pressurized water reactor as well as Beznau, is going to implement a filter system developed by Siemens-KWU, known as sliding pressure venting process, combining a venturi scrubber in a water pool and a mesh filter. The boiling water reactor of Leibstadt also selected the same system as Beznau while Müheberg choose the ABB system but not in the common design. The venturi pipes are thereby integrated in the water pool of the outer torus. The system in all five nuclear power plants is fully operable and in standby mode since December 1993.     

Comparison of physical property-porosity behaviour with minimum solid area models

An extensive survey of the porosity dependence of (room temperature) physical properties shows that mechanical properties and electrical and thermal conductivity, i.e. properties dependent on the local flux or fields in the material, follow minimum solid area models. This is shown extensively for elastic properties and tensile (flexure) strength, but consistency with other properties, e.g. compressive strength, hardness, electrical and thermal conductivity is also shown. Although data for ceramics is most extensive, data for rocks, metals, and carbon are included, since the consistency of these, especially of metals with ceramics, provides important support for the minimum solid area concept. While porosity characterization is generally minimal, expected model trends with pore character are corroborated by correlating processing and resultant expected pore character with porosity-property results. It is argued that properties dependent on mass should be better fit by a linear, i.e. rule of mixture, relationship between such properties and porosity. Support for this is shown in dielectric constant-porosity data.     

Absorbability of Calcium From Common Beans

Absorption of calcium from white, red, and pinto beans, labeled with ⁴⁵Ca, was measured in 24 women in a three-way randomized design using a calcium load of 72 mg and milk as the referent. Fractional absorption for the three beans averaged 0.219 ± 0.047 and did not differ by type. Milk calcium absorption at the same load was more than two times higher, 0.451 ± 0.088 (P < 0.001). Oxalate content averaged 0.34%, and phytate averaged 1.7%, a stoichiometric excess relative to calcium. To evaluate the relation of phytate to reduced absorbability, labeled pinto beans were pre-treated with phytase and fed to 10 subjects. Fractional absorption rose, averaging 0.318 ± 0.071, (P <0.01 vs. untreated beans), but was significantly below that of milk. The difference was partly accounted for by phytate, with the remainder probably due to relatively high oxalate.     

CHALLENGE STUDIES WITH CLOSTRIDIUM BOTULINUM TYPE E IN A VALUE-ADDED SURIMI PRODUCT STORED UNDER A MODIFIED ATMOSPHERE

Challenge studies were carried out on raw, cooked, and sterilized surimi nuggets, inoculated with 10⁴ spores/g of C. botulinum type E spores. All products were packaged in air and air with an Ageless SS oxygen absorbent and stored at 4, 12 and 25C. Toxin was not detected in any raw product throughout storage (28 days). The absence of toxigenesis was attributed to the low pH (4.1–4.3) due mainly to the growth of lactic acid bacteria (10⁷CFU/g). Toxin was also not detected in any cooked product after 28 days. Product pH did not decrease as previously (due to the absence of LAB), but counts of C. botulinum still decreased throughout storage.
In sterile nuggets , C. botulinum counts increased to 10⁶ cfu/g at both 12 and 25C, respectively, by 28 days. Lactic acid bacteria and Bacillus spp. were not detected throughout the 28 days storage period. Toxin was detected by days 28 and 14 at 12 and 25C, respectively, and toxigenesis preceded spoilage. The absence of toxin in cooked nuggets was attributed to the anti-botulinal role by Bacillus species, the predominant spoilage bacteria in cooked nuggets.     

On solving constrained optimization problems with neural networks:a penalty method approach

Deals with the use of neural networks to solve linear and nonlinear programming problems. The dynamics of these networks are analyzed. In particular, the dynamics of the canonical nonlinear programming circuit are analyzed. The circuit is shown to be a gradient system that seeks to minimize an unconstrained energy function that can be viewed as a penalty method approximation of the original problem. Next, the implementations that correspond to the dynamical canonical nonlinear programming circuit are examined. It is shown that the energy function that the system seeks to minimize is different than that of the canonical circuit, due to the saturation limits of op-amps in the circuit. It is also noted that this difference can cause the circuit to converge to a different state than the dynamical canonical circuit. To remedy this problem, a new circuit implementation is proposed.     

Intussusception caused by a carcinoma of the cecum during pregnancy: report of a case and review of the literature

Respiratory infections are the most common infection in children. They differ remarkably according to age, bacteria and viruses. Therefore a careful history of outbreak, age, former infections, involvement of surroundings, symptoms, etc are essential. The present study included 50 children, aged between 0.3 and 12 yrs, all treated ambulatorily. 21 received brodimoprim (B) and 29 erythromycin (E). Indications were: tonsillitis, bronchitis, otitis media, sinusitis and scarlet fever. Dosages were: B was given 10 mg/kg body weight (b.w.) initially followed by 5 mg/kg b.w., once-a-day. The duration of treatment varied between 4 and 14 days (mean 8.3 days). E was given 30.50 mg/kg b.w. 3 times per day; duration 4 to 14 days (mean 8.6 days). Overall results were: in group B:12 cures, 5 improvements, 3 failures; 1 not assessable. In group E: 20 cures, 8 improvements, 1 failure. Side effects: in group B: vomiting (1), skin reaction (2), discontinuation (2); in group E: skin reaction (1), diarrhea (5), diarrhea+vomiting (1); discontinuation (2). The differences in efficacy and tolerability in the two groups are not statistically significant. The improved compliance with a single versus t.i.d. dosages has to be taken into account.     

MEASUREMENT OF THE SPECIFIC SURFACE AREA OF POWDERS BY THIN LAYER WICKING

The specific surface areas (A) of different clay mineral powders were measured by both the BET method and by thin layer wicking. The values of A for the BET and the wicking experiments coincided within a few percent. Thus, the simple and inexpensive thin layer wicking approach may well suffice to obtain reliable specific surface area values for most powders. From the wicking data it is also possible to obtain a rough estimate of the average particle size.