经验分析电价与电费管理的稽查

为进一步提升电价与电费管理的工作质量,采取有效措施、深入落实各管理环节的稽查工作是非常必要的。结合自身的工作经验,以电价稽查、电费账务处理等内容为切入点,对电价与电费管理的稽查作一综述,以供业内同行参考。     

减少220 kV主变压器故障冲击技术措施

由于220 kV主变压器中压侧所配的过流保护需要与下级110 kV主变压器保护相配合,导致主变高、中压侧过流保护动作时间整定过长。在110 kV系统发生短路故障时,如果相关保护、开关不能正确动作,则主变压器将承受大电流、长时间的冲击,极有可能损伤变压器。     

Effect of Agglomeration on Mechanical Properties of Porous Zirconia Fabricated by Partial Sintering

Porous ZrO₂ ceramics were fabricated by compacting a fine ZrO₂ powder, followed by pressureless sintering. Two unidirectional pressures of 30 and 75 MPa were used to prepare the green compacts. The strength and the fracture toughness of porous ZrO₂ specimens sintered from the compacts prepared by 75 MPa were substantially higher than those by 30 MPa, especially for the specimens with low porosity. However, the corresponding Young's moduli were identical. This caused the strain to failure of these porous bodies to increase significantly with increasing compaction pressure. Microstructural analyses showed that a number of voids and small flaws existed in the green compacts prepared by the lower pressure, due to the agglomeration of fine ZrO₂ grains. It was revealed that the ZrO₂ agglomeration resulted in a localized nonuniform shrinkage and degraded the mechanical properties of porous ZrO₂ ceramics.     

Graft polymerization of acrylic acid onto polyphenylene sulfide nonwoven initiated by low temperature plasma

Graft copolymerization of acrylic acid (AA) onto polyphenylene sulfide (PPS) nonwoven initiated by low temperature plasma was studied. The effects of various conditions on graft reaction and the grafting rate were investigated. SEM images showed that PPS nonwoven was grafted, and the graft copolymerization only occurred on the surface of PPS. It may be due to the chain transference going with the graft copolymerization. It was found that with the increasing of plasma power, treatment time, space between electrodes, monomer concentration, and temperature of graft polymerization, the grafting rate increased at first, went to the top, and then decreased. The PPS nonwoven surface graft reaction could be optimized by the following processing conditions: 120 s of plasma treatment time, 50 W of plasma power, 1.5 cm of space between electrodes, 30% (w/w) of monomer concentration, and 50°C of temperature of graft polymerization. Measurement of XPS showed that the peak of C1s of graft polyacrylic acid was existed, and the peak area increased with the increase of the grafting rate. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 5884–5889, 2006     

个险再保险信息管理系统的设计与研究

再保险是保险人将其承担的保险业务,以承保形式,部分转移给其他保险人。再保险业务的网络化和信息化管理,很大程度上满足了现代再保险业务管理的需求,推动了再保险公司管理的发展。介绍个险再保险信息管理系统的需求背景,描述系统的总体设计。在系统总体实现方面详细阐述了软件开发平台、相关设备性能容量需求分析和再保险业务风险评估模型。最后对相关设备性能容量进行了评估。     

真空蒸馏法从铟中脱除Cd、Tl的研究

介绍真空蒸馏法取代传统试剂法从铟中脱除镉和铊。通过实验研究了采用真空蒸馏的方法从铟中脱除铊的最佳工艺条件。实验表明,控制蒸馏温度950℃,恒温时间40m in,即可使残余物中铊的含量为0.0006%,铟的挥发率2.14%。     

PTC型BaTiO3陶瓷的孪晶和孪晶界

用透射电镜和高分辨电镜观察研究了PTC型BaTiO_3陶瓷的孪晶和孪晶界结构,并提出了可能的{111}孪晶及孪晶界的原子结构模型。结果表明,{111}孪晶形成氧八面体共面的共格倾斜孪晶界,在孪晶界处可能存在一定量的A空位且原子密度要低于孪晶体内。同时还发现两种其它特征的孪晶现象。     

定量~(13)C-NMR谱表征蔗渣碱木素结构

从蔗渣纸浆黑液中制出纯蔗渣碱木素，然后测定其定量13C-NMR谱．图谱分析表明，蔗渣碱木素主要由紫丁香基，愈创木基和对羟苯基三种丙烷结构单元组成，其中未绩合的紫丁香基、愈创木基和对羟羊基含量比为2.2：1．0：1．4．蔗渣碱术素结构单元间主要以β-O－4烷基芳基醚键连接，也有一定量的非环状α-醚键存在．蔗渣碱木素中，相当部分对香豆酸类结构并非通过酯键而是通过醚键或碳双键连接于芳核上．     

聚醚砜的磺化与热性能

以浓硫酸为溶剂 ,氯磺酸为磺化剂对聚醚砜 (PES)进行了磺化 ,制备了不同磺化度的磺化聚醚砜 (SPES)。探讨了反应的影响因素 ,分析了 SPES的热稳定性。结果表明 SPES的 Tg较 PES升高 ,随着磺化度的增加 ,SPES的降解温度降低。