Squeeze-film effects in MEMS devices with perforated plates for small amplitude vibration

Squeeze-film effects of perforated plates for small amplitude vibration are analyzed through modified Reynolds equation (MRE). The analytical analysis reckons in most important influential factors: compressibility of the air, border effects, and the resistance caused by vertical air flow passing through perforated holes. It is found that consideration of air compressibility is necessary for high operating frequency and small ratio of the plate width to the attenuation length. The analytical results presented in this paper agree with ANSYS simulation results better than that under the air incompressibility assumption. The analytical analysis can be used to estimate the squeeze-film effects causing damping and stiffness added to the system. Since the value of Reynolds number involved in this paper is low (< 1), inertial effects are neglected.     

Hydriding and Dehydriding Characteristics of Mechanically Alloyed LaMg_(17) Ni Composite Material

Magnesiumandmagnesiumalloyshavebeenin vestigatedashydrogenstoragematerialsforseveralde cadesbecausefarmorehydrogenbyweightcanbestoredinthemthaninmostoftheothercurrentlyknownhydrogenstoragealloys .Moreover ,thehighnaturalabundanceofMg ,itslightmassandenviron mentalcompatibilitypotentiallymakemagnesiumoneofthemostprospectivecandidatesforfuturehydrogenstoragematerials .Unfortunately ,thepracticalappli cationofMganditsalloyshasbeenlimitedonlytocertainstoragedevicebecauseoftheirpoorhydriding dehydr…     

新型建筑材料在基础工程中的应用

重点介绍了在地基基础和基坑围护方面7种新型建材的特性和应用现状,并预测了新型建材在基础工程中的发展趋势。     

汽轮机轴承烧瓦与轴颈的渗巴氏合金现象

简述轴承工作性质，巴氏合金应用与相组成的基本情况。论述汽轮机转子在两个电厂长期运行后，由于轴颈发生的不正常摩擦损伤，在大修改造中由无损检查、机械加工揭示出轴颈存在严重的渗巴氏合金现象，低熔点金属Sn、Sb与Cu向转子材料晶界的深层渗入最终导致了3根大型在投转子的严重开裂与报废。图11表2     

深圳抽水蓄能电站上水库主坝坝型选择

本文着重介绍了在可研究性阶段,通过对深圳抽水蓄能电站上水库主坝设计过程中坝型选择的相关因素的分析,确定其大坝类型的过程。     

亦儒亦佛的率真个性——试论孙悟空个性的儒佛因素

孙悟空在大闹天宫中表现的个性主要有4个方面：一是戏弄神鬼；二是不甘受辱；三是追求尊严；四是藐视王权。这些个性又蕴含着儒佛文化因素。     

广义预测控制系统的仿真软件设计与开发

介绍了基于广义预测控制的模型预测控制（MPC）系统仿真软件的开发与实现过程。该软件包含了MAC，IMAC，DMC，DDMC和GPC五种预测控制算法，可以用不同的方法实现对预测控制系统的综合性仿真以及控制器参数的调整。利用该软件可对模型预测控制系统的作用机理做进一步仿真分析，并有助于定性分析各种算法中设计参数对系统性能的影响以及不同算法之间的区别。     

Photoreactivation of Escherichia coli following medium-pressure ultraviolet disinfection and its control using chloramination.

Ultraviolet (UV) disinfection is becoming increasingly popular as an alternative disinfection technology to chlorination in recent years. In this study, we investigated the photoreactivation of Escherichia coli following medium-pressure (MP) UV disinfection of synthetic water by a bench-scale collimated beam apparatus. The UV doses ranged from 1.6 -19.7 mWs/cm2 and photoreactivation was investigated for 6 hours under fluorescent light. In addition, chloramination was applied after UV disinfection to investigate its ability to control photoreactivation. It was found that photoreactivation occurred for all UV doses tested and the increase in bacteria numbers ranged from 0.04 to 1.35 log10. However, the degree of photoreactivation decreased with increased UV doses. Chloramination experiments revealed that the addition of 0.5 mg/l of monochloramine resulted in suppression of photoreactivation for 1 hour only. An increased monochloramine dose of 1 mg/l was found to prevent photoreactivation for the entire duration of the experiment. The results of this study have shown that photoreactivation occurs even after MP UV disinfection, although it is of a lesser extent at higher UV doses. This study has also established that secondary chloramination can effectively suppress and eliminate photoreactivation with a chloramine dose of 1 mg/l.     

立方相GaN的持续光电导

研究了金属有机物化学气相外延 (MOVPE)方法生长的非故意掺杂的立方相 Ga N的持续光电导效应 .在六方相 Ga N中普遍认为持续光电导效应与黄光发射有关 ,而实验则显示在立方 Ga N中 ,持续光电导效应与其中的六方相 Ga N夹杂有关系 ,而与黄光发射没有关系 .文中提出 ,立方相 Ga N与其中的六方相 Ga N夹杂之间的势垒引起的空间载流子分离是导致持续光电导现象的物理原因 .通过建立势垒限制复合模型 ,解释了立方相 Ga N的持续光电导现象的物理过程 ,并对光电导衰减过程的动力学作了分析 .对实验数据拟合的结果证明以上的模型和推导是与实验相符的 .     

Solution of large deformation contact problems with friction between Blatz-Ko hyperelastic bodies

The present paper is devoted to the analysis of the contact problems with Coulomb friction and large deformation between two hyperelastic bodies. One approach to separate the material nonlinearity and contact nonlinearity is presented. The total Lagrangian formulation is adopted to describe the geometrically nonlinear behavior. Nondifferentiable contact potentials are regularized by means of the augmented Lagrangian method. Numerical examples are carried out in two cases: rigid-deformable contact and deformable-deformable contact with large slips. The numerical results prove that the proposed approach is robust and efficient concerning numerical stability.