Insecurities in FORTRAN DO-loops

Despite a long-established body of relevant computer science, lack of precise specification of certain aspects of FORTRAN and deviation from the published standards permit the construction of non-standard programs which run under different systems to give contradictory results. This paper highlights certain deviant features of DO-loops.     

A Novel 2.5–3.1 GHz Wide-Band Low-Noise Amplifier in 0.18 \upmu \hbox {m} CMOS

Aiming for the simultaneous realization of constant gain, accurate input and output impedance matching and minimum noise figure (NF) over a wide frequency range, the circuit topology and detailed design of wide broadband low noise amplifier (LNA) are presented in this paper. A novel 2.5–3.1 GHz wide-band LNA with unique characteristics has been presented. Its design and layout are done by TSMC 0.18  \(\upmu \hbox {m}\) technology. Common gate stage has been used to improve input matching. In order to enhance output matching and reduce the noise as well, a buffer stage is utilized. Mid-stages which tend to improve the gain and reverse isolation are exploited. The proposed LNA achieves a power gain of 15.9 dB, a NF of 3.5 dB with an input return loss less than \(-\) 11.6, output return loss of \(-\) 19.2 to \(-\) 19 and reverse isolation of \(-\) 38 dB. The LNA consumes 54.6 mW under a supply voltage of 2 V while having some acceptable characteristics.     

Porosity prediction from seismic inversion of a similarity attribute based on a pseudo-forward equation (PFE): a case study from the North Sea Basin, Netherlands

The objective of this work is to implement a pseudo-forward equation which is called PFE to transform data (similarity attribute) to model parameters (porosity) in a gas reservoir in the F3 block of North Sea. This equation which is an experimental model has unknown constants in its structure; hence, a least square solution is applied to find the best constants. The results derived from solved equations show that the errors on measured data are mapped into the errors of estimated constants; hence, Tikhonov regularization is used to improve the estimated parameters. The results are compared with a conventional method such as cross plotting between acoustic impedance and porosity values to validate the PFE model. When the testing dataset in sand units was used, the correlation coefficient between two variables (actual and predicted values) was obtained as 0.720 and 0.476 for PFE model and cross-plotting analysis, respectively. Therefore, the testing dataset validates relatively well the PFE optimized by Tikhonov regularization in sand units of a gas reservoir. The obtained results indicate that PFE could provide initial information about sandstone reservoirs. It could estimate reservoir porosity distribution approximately and it highlights bright spots and fault structures such as gas chimneys and salt edges.     

Computer user training and attitudes: a study of business undergraduates

For many users, the first real encounter with a computer occurs when taking an introductory course to computers at a college. To the extent that these training courses impact user understanding and motivation, they are important determinants of the user attitudes towards computers and merit serious assessment. Using 327 business undergraduates at two universities in the US, this paper reports on the reactions of students to computers and computer-related tasks before and after an introductory course to computers. Responses to a 20-item scale were analysed to examine the pattern of attitude change experienced by students in their training course. Factor analysis revealed five constructs for describing patterns of computer user attitude: negative reaction to computers; positive reaction to computers; reaction to computers for children education; reaction to computer-mediated services; and reaction to computer games. Four factors show significant change in mean scores after the training courses. The attitudes changed for males more than females, indicating improvement in attitudes. The respondents' attitude to computer-mediated services remained unchanged. While the directions of changes indicate an overall improvement in respondents' reactions, many attitudes did not change significantly after having taken the training courses. This may be due to the content or the format of these courses.     

Production and functional properties of beef lung protein concentrates

This work investigated the production and the properties of meat protein concentrates from beef lungs (BLPC) at pilot scale. Protein recovery and functional properties were compared to those of BLPC obtained using membrane technology in a previous work (Selmane, D., Vial, C., & Djelveh, G. (2008). Extraction of proteins from slaughterhouse by-products: Influence of operating conditions on functional properties. Meat Science, 79, 640–647). An alkaline solubilisation method was applied for protein extraction, followed by pI precipitation for concentration. The physicochemical properties of BLPC such as molecular mass, solubility, surface hydrophobicity, surface tension and interfacial tension, as well as technofunctional emulsifying and foaming properties were determined. These were compared to those of commercial protein ingredients, such as sodium caseinates, whey protein isolates, egg white proteins and soy protein isolates. Results showed that proteins from BLPC included a low-molecular-weight fraction and exhibited good solubility and high hydrophobicity with small surface and interfacial tensions. This explained their excellent emulsifying activity, better than sodium caseinates, and their good foaming properties.     

Seismic geomorphology and stratigraphic trap analyses of the Lower Cretaceous siliciclastic reservoir in the Kopeh Dagh-Amu Darya Basin

Lower Cretaceous Shurijeh–Shatlyk Formations host some of the main reservoirs in the Kopeh Dagh-Amu Darya Basin.Exploration in this area so far has focused on the development of structural traps, but recognition of stratigraphic traps in this area is of increasing importance. Integration of 3D seismic data with borehole data from thirteen wells and five outcrop sections was used to identify potential reservoir intervals and survey the hydrocarbon trap types in the East Kopeh Dagh Foldbelt(NE Iran). Analyses of horizontal slices indicated that the lower Shurijeh was deposited in a braided fluvial system.Generally, three types of channel were identified in the lower Shurijeh Formation: type 1, which is low-sinuosity channels interpreted to be filled with non-reservoir fine-grained facies; type 2, which is a moderately sinuous sand-filled channel with good prospectively; and type 3, which is narrow, high sinuosity channel filled with fine-grained sediments. Results indicate that upper Shurijeh–Shatlyk Formations were deposited in fluvial to delta and shallow marine environments. The identified delta forms the second reservoir zone in the Khangiran Field. Study of the stratigraphic aspects of the Shurijeh succession indicates that both lower and upper Shurijeh reservoirs are stratigraphic reservoir traps that improved during folding.     

Cube-octameric silsesquioxane (POSS)-capped magnetic iron oxide nanoparticles for the efficient removal of methylene blue

Octavinyl polyhedral oligomeric silsesquioxane (POSS) was polymerized on the surface of Fe3O4 nanoparticles (NPs) and then the NPs were functionalized with carboxylic acid groups using thiol-ene click reactions with thioglycolic acid.The as-prepared Fe3O4@POSS-COOH magnetic hybrid NPs had mesoporous structures with an average particle diameter of 15 nm and a relatively high specific surface area of 447 m^2· g^-1.Experimental results showed that 4 mg of Fe3O4@POSS-COOH NPs efficiently adsorbed and removed methylene blue from water at 5 min.This is due to the presence of both carboxylic acid and pendant vinyl groups on the Fe3O4@POSS-COOH NPs.These NPs could be easily withdrawn from water within a few seconds under moderate magnetic field and showed high stability in acid and alkaline aqueous mediums.     

Analytical study of surface wave multiple refraction in boundary of a scalar impedance surface with a tensor impedance surface

In this paper, the multiple refraction phenomenon is investigated on the boundary of a scalar impedance surface (SIS) and a tensor impedance surface (TIS). When a surface wave (SW) propagates on the SIS and radiates to the boundary of the TIS, the propagation direction of it is changed and the refraction phenomenon is accrued. The method that is proposed in this paper can predict the multiple refraction for the SW. Moreover, another analytical method is introduced for designing the proposed structure which the double refraction (DR) occurs at arbitrary angles on it. Using it, a sample of the structure is designed by printed circuits in 15.2GHz and the results are verified by the full‐wave simulation and measurement. The results are shown that in the structure, DR is occurred in 2° and 22° as predicted. The proposed method can provide many applications such as design of SW power dividers based on the TISs, impedance surface based waveguides, holographic antennas, and feeding of array antennas.