Transient Current Behaviour for Iron in 3.5%NaCl and 3.5%NaCl+ 1%NaNO_2 Solutions during Corrosion Fatigue

The transient current behaviour for Iron in 3.5%NaCl and 3.5%NaCl +1%NaNO2 solutions during corrosion fatigue (CF) process has been investigated at different given strain amplitudes and strain rates. The results show that elastic strain has little contribution to material dissolution. The elastic tension strain results in the decrease in the transient current, while the elastic compression strain increases the transient current. Compared to the elastic deformation, plastic deformation affects material dissolution evidently For iron in 3.5%NaCl solution, the strain amplitude plays a dominant role in the dissolution process accelerated by the plastic strain, while in 3.5%NaCl+1%NaNO2 solution, both the strain amplitude and strain rate play an important role in this process. In this paper, the effect of the elastic deformation on the material dissolution and the relation between the tension and compression current peak values under the plastic cycle deformation are discussed     

Reengineering the Internet for Better Security

The growing proliferation of malware is raising doubts about the Internet's future. Security measures primarily target inbound traffic, but service providers have no incentive to stop attacks and spam at the source. A proposed certification scheme motivates providers to control outgoing traffic, efficiently increasing overall security while preserving the Internet's open, decentralized structure     

Constant boost control of the Z-source inverter to minimize current ripple and voltage stress

This paper proposes two constant boost-control methods for the Z-source inverter, which can obtain maximum voltage gain at any given modulation index without producing any low-frequency ripple that is related to the output frequency and minimize the voltage stress at the same time. Thus, the Z-network requirement will be independent of the output frequency and determined only by the switching frequency. The relationship of voltage gain to modulation index is analyzed in detail and verified by simulation and experiments.     

Effect of igneous activity on hydrocarbon source rocks in Jiyang sub-basin, eastern China

A 50 m thick diabase sill was found in the Paleogene black mudstone hydrocarbon source rocks in Xia38 well. Within heating aureola of the sill, optical changes of kerogen and signatures of extractable bitumens in the mudstones were investigated. Under effects of high heating rate associated with sill intrusion, the vitrinite reflectance (Ro) has an increasing tendency with decreasing distance to the sill both below and above the sill. However, only within a zone of about 15 m to the diabase sill, the vitrinite reflectance shows significant increase. Above the sill, the Ro values increase gradually from 0.6% to 1.0%, whereas below the sill, the Ro values increase dramatically from 0.8% to 3.8%. The contrasting Ro increasing patterns are attributed to the different heat transferring conditions, the relatively open system above the sill and the relatively close system below. The more mature signatures below the sill are also demonstrated by the n-alkane distribution, carbon predominance index and odd-to-even carbon number predominance of the extracted bitumens. Below the sill, the proportion of the saturated hydrocarbons in the extracted bitumens increases from 34% to 79% towards the sill contact. The bitumens in the two highest rank samples which are closest to the sill are dominated by saturated or saturated + aromatic hydrocarbons.The %20S, %αββ and %Ts biomarker parameters of the extracted bitumens are 46%, 58% and 54%, respectively, at Ro = 1.5%. At Ro = 2.6% or 3.0%, they reach to 52%, 71%, and 71%, respectively, still under or close to their corresponding equilibrium end-points. These samples of high rank, established on the basis of optical assessment (vitrinite reflectance), have less mature biomarker signatures. The remarkable disparities between optical and biomarker parameters can be ascribed to that the aromatization of kerogen to increase Ro was more favored than the isomerization of biomarker in the rapid heating scenario.     

OCT-M FCC 汽油深度加氢脱硫技术的研究及工业应用

比较研究了MIP汽油与常规FCC汽油的特点，考察了抚顺石油化工研究院(FRIPP)开发的OCT-M催化汽油选择性加氢脱硫技术由MIP汽油与FCC汽油生产硫含量≯50µg/g汽油的情况下的辛烷值损失。工业应用结果表明，OCT-M技术将MIP汽油硫含量由417～442µg/g降低到24～53µg/g，RON损失0.7～1.8个单位。因此，OCT-M技术可为我国炼厂生产硫含量≯50µg/g的清洁汽油提供经济、灵活的技术方案。     

φ3m分级机螺旋轴断裂分析

文章根据电机负荷理论对φ3m分级机螺旋轴进行受力分析，避免了复杂的推导计算和疲劳强度校核。根据现场实际，将机械技术与电气技术结合，分析其断裂原因，提出改进措施，具有较好的效果和借鉴价值。     

Monolithic Catalysts with Low Noble-Metal Content for Exhaust Purification of Small Gasoline Engines

A series of low noble-metal coment monolithic catalysts for exhaust purification of small gasoline engines was investigated, and it was found that the Pt/Rh-OSM/Al2O3 （where OSM was oxygen storage material） catalyst with Ce0.5Zr0.5-MnOx（3%MnOx） OSM held low light-off temperature for CO, HC, and NO; quite wide three-way window, and outstanding thermal stability. The catalyst could efficiently comrol exhaust emission of small gasoline engines.