Oscillations in a bounded volume of reacting gas suspensate

Sverdlovsk. Translated from Fizika Goreniya i Vzryva, Vol. 27, No. 1, pp. 82–88, January–February, 1991.     

Personal spaces — ePerSpace

This paper describes the ePerSpace research project which aims to significantly increase user acceptance of networked audiovisual systems and applications at home and virtually anywhere by enabling innovative interoperable value-added personalised networked services and applications. Moreover, it aims to develop an open architecture and a framework that will significantly increase the speed of developing novel value-added personalised services by reusing well-defined system components with open APIs. The structure of the paper follows the methodology of the project. It starts with a vision of future personalised services from the users’ perspective by developing five scenarios. These scenarios are then used to extract the requirements of the personalisation framework which is then described in terms of its personalisation, service management, digital home environment management and content adaptation capabilities.     

Highly integrated direct conversion receiver for GSM/GPRS/EDGE with on-chip 84-dB dynamic range continuous-time /spl Sigma//spl Delta/ ADC

This paper describes a highly digitized direct conversion receiver of a single-chip quadruple-band RF transceiver that meets GSM/GPRS and EDGE requirements. The chip uses an advanced 0.25-/spl mu/m BiCMOS technology. The I and Q on-chip fifth-order single-bit continuous-time sigma-delta (/spl Sigma//spl Delta/) ADC has 84-dB dynamic range over a total bandwidth of /spl plusmn/135 kHz for an active area of 0.4 mm/sup 2/. Hence, most of the channel filtering is realized in a CMOS IC where digital processing is achieved at a lower cost. The systematic analysis of dc offset at each stage of the design enables to perform the dc offset cancellation loop in the digital domain as well. The receiver operates at 2.7 V with a current consumption of 75 mA. A first-order substrate coupling analysis enables to optimize the floor plan strategy. As a result, the receiver has an area of 1.8 mm/sup 2/.     

Treatment of municipal wastewater UASB reactor effluent by unconventional flotation and UV disinfection.

Post-treatment of an UASB reactor effluent, fed with domestic sewage, was conducted using two-stage flotation and UV disinfection. Results were compared to those obtained in a parallel stabilisation pond. The first flotation stage employed 5 - 7.5 mg L(-1) cationic flocculant to separate off more than 99% of the suspended solids. Then, phosphate ions were completely recovered using carrier flotation with 5-25 mg L(-1) of Fe (FeCl3) at pH 6.3-7.0. This staged flotation led to high recoveries of water and allowed us to separate organic matter and phosphate bearing sludge. The water still contained about 1 x 10(2) NMP/100 mL total coliforms, which were removed using UV radiation to below detection levels. Final water turbidity was < 1.0 NTU, COD < 20 mg L(-1) O2 and 71 mNm(-1), the liquid/air interfacial tension. This flotation-UV flowsheet was found to be more efficient than the treatment in the stabilisation pond and appears to have some potential for water reuse. Results were discussed in terms of the biological, chemical and physicochemical mechanisms involved.     

L-Expressnet: The Communication Subnetwork for the C-NET Project

L-Expressnet is the communication suxbnetwork for the CNET local area network project of the CNR, Italy. Based on a single bus topology, it utilizes a simple and efficient virtual-token access protocol which provides ordered and collision-free transmission. The paper discusses the needs which led to L-Expressnet, describes the protocol, proves its correct operation, and compares its throughput-delay performance with those of other typical bus Protocols. A major advantage of L-Expressnet is that its implementation may be based on Ethernet standard transceivers and network interfaces.     

Semiconductor optical amplifier for CWDM operating over 1540-1620 nm

A semiconductor optical amplifier was developed for coarse wavelength-division-multiplexing (CWDM) operating over 1540-1620 nm (C-L band). A unique quantum-well structure was designed to meet the requirements for the CWDM operation such as wide bandwidth, low polarization-dependent gain, and high-saturation power at the short wavelength end of the band (1540 nm). Over the band, 24-dB maximum chip gain was obtained with less than 4.3-dB gain flatness and more than 14.6-dBm saturation power.