首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   33742篇
  免费   3756篇
  国内免费   2248篇
电工技术   2891篇
综合类   2879篇
化学工业   4550篇
金属工艺   2166篇
机械仪表   1990篇
建筑科学   2419篇
矿业工程   1165篇
能源动力   739篇
轻工业   4282篇
水利工程   926篇
石油天然气   1212篇
武器工业   374篇
无线电   3413篇
一般工业技术   3376篇
冶金工业   1478篇
原子能技术   533篇
自动化技术   5353篇
  2024年   217篇
  2023年   664篇
  2022年   1409篇
  2021年   1718篇
  2020年   1343篇
  2019年   1060篇
  2018年   1076篇
  2017年   1294篇
  2016年   1108篇
  2015年   1660篇
  2014年   1992篇
  2013年   2402篇
  2012年   2746篇
  2011年   2883篇
  2010年   2664篇
  2009年   2478篇
  2008年   2465篇
  2007年   2236篇
  2006年   1989篇
  2005年   1637篇
  2004年   1065篇
  2003年   746篇
  2002年   623篇
  2001年   572篇
  2000年   465篇
  1999年   252篇
  1998年   137篇
  1997年   106篇
  1996年   94篇
  1995年   77篇
  1994年   58篇
  1993年   59篇
  1992年   62篇
  1991年   26篇
  1990年   37篇
  1989年   28篇
  1988年   26篇
  1987年   23篇
  1986年   27篇
  1985年   14篇
  1984年   24篇
  1983年   17篇
  1982年   15篇
  1981年   12篇
  1980年   25篇
  1979年   16篇
  1978年   12篇
  1977年   10篇
  1974年   10篇
  1951年   8篇
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
71.
为解决焦化行业用电机车采用人工驾驶、定位精度差、劳动强度大的现状,提出了一种基于单片机AT89C51的电机车半自动化运行控制系统,为实现电机车的无人驾驶奠定了基础。介绍了AT89C51根据炉号识别系统、脉冲编码器及三灯对正传感器的位置反馈信号,确定电机车运行速度曲线的方法。变频器ACS800采用主/从控制方式,实现了两台电机以轮对车轮对铁轨无相对滑动为基准的同步运行,及负载在变频器之间的均匀分配。给出了该系统硬件构成框图及软件流程图。本系统结构简单,实现方便,控制精度高,对恶劣环境有较强的适应能力。  相似文献   
72.
当前IMS Learning Design(IMS LD)规范中虽然整合了QTI(Question and Test Interoperability)规范,但是在当前的播放器中却没有很好地整合QTI服务,这就阻碍了播放器和QTI之间的通信,从而不能很好地实现QTI服务。文中针对SLeD体系结构,在该体系结构中加入了中间软件层,利用这个中间软件层实现了播放阶段QTI和播放器的通信。  相似文献   
73.
逆变电源PI双环数字控制技术研究   总被引:12,自引:2,他引:12  
本文分析了正弦波逆变电源实际应用情况和数字控制的特点,提出了一种带输出电流前馈的PI双环(输出电压外环滤波电感电流内环)数字化控制方案,利用极点配置的方法设计控制系统参数,并根据实际系统模型设计了输出电压和电感电流的状态观测器,最后给出了各种实验条件下的实验波形.实验结果表明,该方案设计简单、实用,能很好地达到逆变电源输出的各项性能指标要求.  相似文献   
74.
为了减少谐波磁势,削弱同步附加转矩,提高电机的效率及改善电机性能,三相异步电机的定子线圈广泛采用单、双层不等匝正弦绕组(以下简称正弦绕组)。由于正弦绕组每极每相下各线圈的跨距和导体数均不相等,其绕线模尺寸计算复杂,文章介绍了它的计算方法。  相似文献   
75.
With the introduction of low‐powered pico/femto‐base stations and relay nodes into the macro‐cell, recent heterogeneous networks provide an attractive approach for future wireless communication. Although it may achieve better coverage and higher capacity, several problems remain unsolved before practical deployment. For example, how to select the proper cell from neighbor low‐powered cells and then occupy the radio resource without interference on macro‐users is both important and challenging, especially for rigorous multimedia applications. The traditional cell access algorithms and quality‐control parameters such as delay or throughput no longer suit well in this complex environment. An effective approach should be pursued. In this paper, we investigate this interesting cell association problem and propose a complete green resolution on the basis of thorough discussions about the multimedia transmission under these concerns. Cognitive radio is introduced to share spectrum between macro‐cell and low‐powered cells while securing the transmission of authorized macro‐users. We also bring forth the concept of ‘interference balance’ to better manage the overall interference and energy consumption in the network. Restless bandit model is formulated on the basis of channel state, data rate, interference control, and the carefully chosen intra‐refreshing rate for multimedia traffic. Then the cell association scheme is designed to be efficient and practical because of the simple index property of our model output. Simulation results have proven the performance of our proposed resolution compared with existing algorithms on interference constraint, multimedia distortion, and overall network energy consumption balance. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   
76.
工艺参数对马氏体不锈钢激光冲击区表面轮廓的影响   总被引:1,自引:0,他引:1  
激光功率密度和搭接率对马氏体不锈钢的激光冲击区的表面轮廓有较大影响.激光功率密度从3.79 GW/cm2到7.25 GW/cm2,冲击区塑性变形程度随功率密度增大而增大,当激光功率密度为6.09 GW/cm2时,冲击区塑性变形程度适中,其残余应力平均值达-569.1 MPa.搭接率试验结果表明,搭接率为33%时,可获得较大面积无挤出的激光冲击区,无挤出区域的塑性均匀,变形深度波动幅度在2μm以内,而且此搭接率下冲击区挤出面积较小,分布具有规律,便于再次冲击以降低冲击区的表面波纹度.  相似文献   
77.
A new type of film cooling hole with micro groove structure is presented in this paper.Based on the finite volume method and the Realizable k-εmodel,the film cooling process of the hole in a flat plate structure is simulated.The surface temperature distribution and film cooling effect of different film cooling holes were analyzed.The effects of micro-groove structure on wall attachment and cooling efficiency of jet were discussed.The results show that under the same conditions,the transverse coverage width and overall protective area of the new micro-groove holes are larger than those of the ordinary cylindrical holes and special-shaped holes.Compared with ordinary holes,the new micro-groove holes can better form the film covering on the surface and enhance the overall film cooling efficiency of the wall.For example,when the blowing ratio M=1.5,the effective coverage ratio of micro-groove holes is 1.5 times the dustpan holes and is 8 times the traditional cylindrical holes.It provides reference data and experience rules for the optimization and selection of advanced cooling structure of high performance aero-gas engine hot-end components.  相似文献   
78.
针对红外图像边缘模糊和非均匀性噪声强的特点,提出了一种基于加权的自适应红外图像边缘增强方法。该方法不仅增强红外图像边缘,而且改善了传统边缘增强算法对图像噪声放大的缺点,避免了对强边缘的过渡增强导致图像出现过增强现象,改善了图像质量。实验结果表明,该方法具有良好的前景和实用价值。  相似文献   
79.
We previously found that short-term treatment (week 8 to 12 after injury) with high-dose angiotensin receptor blocker (ARB) induced the regression of existing glomerulosclerosis in 5/6 nephrectomy rats. We therefore assessed the effects of long-term intervention with ARB vs. nonspecific antihypertensives in this study. Adult rats underwent 5/6 nephrectomy and renal biopsy 8 weeks later. The rats were then divided into three groups with equivalent renal function and glomerular sclerosis and treated with high-dose losartan (ARB), nonspecific antihypertensive triple-therapy (TRX), or left untreated (Control) until week 30. We found that blood pressure, serum creatinine levels, and glomerulosclerosis were lower at sacrifice in ARB and TRX vs. Control. Only ARB reduced proteinuria and maintained the density of WT-1-positive podocytes. Glomerular tufts showed more double-positive cells for CD44, a marker of activated parietal epithelial cells, and synaptopodin after ARB vs. TRX or Control. ARB treatment reduced aldosterone levels. ARB-treated rats had significantly improved survival when compared with TRX or Control. We conclude that both long-term ARB and triple-therapy ameliorate progression, but do not sustain the regression of glomerulosclerosis. ARB resulted in the superior preservation of podocyte integrity and decreased proteinuria and aldosterone, linked to increased survival in the uremic environment.  相似文献   
80.
Temperature-sensitive genic male sterile (TGMS) line Beijing Sterility 366 (BS366) has been utilized in hybrid breeding for a long time, but the molecular mechanism underlying male sterility remains unclear. Expression arrays, small RNA, and degradome sequencing were used in this study to explore the potential role of miRNA in the cold-induced male sterility of BS366. Microspore observation showed defective cell plates in dyads and tetrads and shrunken microspores at the vacuolated stage. Differential regulation of Golgi vesicle transport, phragmoplast formation, sporopollenin biosynthesis, pollen exine formation, and lipid metabolism were observed between cold and control conditions. Pollen development was significantly represented in the 352 antagonistic miRNA-target pairs in the integrated analysis of miRNA and mRNA profiles. The specific cleavage of ARF17 and TIR1 by miR160 and miR393 were found in the cold-treated BS366 degradome, respectively. Thus, the cold-mediated miRNAs impaired cell plate formation through repression of Golgi vesicle transport and phragmoplast formation. The repressed expression of ARF17 and TIR1 impaired pollen exine formation. The results of this study will contribute to our understanding of the roles of miRNAs in male sterility in wheat.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号