Extended analysis of ground impedance measurement using the fall-of-potential method

An extended analysis of ground impedance measurement using the fall-of-potential method will be presented. An interesting curve that represents the exact locations of the potential probe when the potential and current probes are in different directions is obtained for the first time. Curves representing measurement error are also presented for the case when the potential probe is placed in locations where the correct ground impedance cannot be measured. A similar analysis for ground impedance measurements in multilayer soils is also discussed. The study presented in this paper has extended the theory of the conventional fall-of-potential method and the results obtained can serve as a practical guide for ground impedance measurements made using this method.     

标准椅全身计数器对不同年龄组均匀体模源全能峰效率的刻度

本文介绍了用标准液体源均匀充入聚氯乙烯制的体模,刻度标准椅全身计数器〔φ8″×4″(NaI)〕的方法和结果。分别就代表6个年龄组的体模,测定了标准椅全身计数器对5种能量(364,637,898,1460和1836keV)γ射线的全能峰效率;给出了全能峰效率与γ射线能量和被测对象体重的关系曲线。     

高质量的一级光栅1．55μmDFB激光器

本文详细叙述了ＤＦＢ激光器的设计要点和新的工艺。采用一级全息光栅和二步液相外延法批量研制出高稳定单纵模工作的１．５５μｍ分布反馈激光器（ＤＦＢ—ＬＤ）。外延片成品率＞４０％。器件特性：２５℃时阈值电流２０ｍＡ，单面光功率＞１０ｍｗ，主边模抑制比ＳＭＳＲ达４３ｄＢ（λ／４相移光栅），谱线宽度△ν－２０ｄＢ＝０．３ｎｍ，调制速率＞１．８ＧＨｚ。可靠性测试显示：高温监测光谱稳定，２５°Ｃ时阈值退化率△Ｉｔｈ／ｔ＜０．３ｍＡ／ｋｈ，对应器件预估寿命将超过１０万ｈ。     

Suppression of boron penetration in p+ polysilicon gateP-MOSFETs using low-temperature gate-oxide N2O anneal

It has been reported that high-temperature (~1100°C) N₂ O-annealed oxide can block boron penetration from poly-Si gates to the silicon substrate. However, this high-temperature step may be inappropriate for the low thermal budgets required of deep-submicron ULSI MOSFETs. Low-temperature (900~950°C) N₂O-annealed gate oxide is also a good barrier to boron penetration. For the first time, the change in channel doping profile due to compensation of arsenic and boron ionized impurities was resolved using MOS C-V measurement techniques. It was found that the higher the nitrogen concentration incorporated at Si/SiO₂ interface, the more effective is the suppression of boron penetration. The experimental results also suggest that, for 60~110 Å gate oxides, a certain amount of nitrogen (~2.2%) incorporated near the Si/SiO₂ interface is essential to effectively prevent boron diffusing into the underlying silicon substrate     

分流液压转向牵引计算的展开图及其应用

本文论及分流液压转向牵引计算的概念,方法及其展开图,并且提供了计算机绘制的展开图和应用实例。     

核医学成像技术中计算机的应用

由于计算机和核医学的结合,各种成像方法的计算机化医学图像层析技术正在迅速发展,并开始广泛应用。本文介绍各类成像技术中计算机的应用,特别评述其最近进展,并提出了今后的展望。     

推力矢量控制技术在导弹上的应用及发展

简要介绍了推力矢量控制技术的概念,分析了推力矢量控制的基本原理及特点.在简要分析其技术发展历程的基础上,给出了导弹推力矢量技术的现状和发展趋势.     

Fuzzy control of nitrogen removal in predenitrification process using ORP.

In order to meet increasingly stringent discharge standards, new applications and control strategies for the sustainable removal of nitrogen from wastewater have to be implemented. In the past years, numerous studies have been carried out dealing with the application of fuzzy logic to improve the control of the activated sludge process. In this paper, fuzzy control strategies of predenitrification systems are presented that could lead to better effluent quality and, in parallel, to a reduction of chemicals consumption. Extensive experimental investigations on lab scale plant studies have shown that there was excellent correlation between nitrate concentration and ORP value at the end of the anoxic zone. Results indicated that ORP could be used as an on-line fuzzy control parameter of nitrate recirculation and external carbon addition. The optimal value of ORP to control nitrate recirculation and external carbon addition was - 86 +/- 2 mV and - 90 +/- 2 mV, respectively. The results obtained with real wastewater also showed the good performance and stability of the fuzzy controllers independently from external disturbances. The integrated control structure of nitrate recirculation and external carbon addition in the predenitrification system is also presented.     

One‐step production of 2,3‐butanediol from starch by secretory over‐expression of amylase in Klebsiella pneumoniae

BACKGROUND: 2,3‐Butanediol (2,3‐BD) is a valuable chemical that can be biosynthesized from many kinds of substrates. For commercial biological production of 2,3‐BD, it is desirable to use cheap substrate without pretreatment, such as starch. However, there have been few reports on the production of 2,3‐BD directly from starch. RESULTS: In this work, gene malS coding for α‐amylase (EC 3.2.1.1) precursor was inserted into plasmid pUC18K, and secretory over‐expression of α‐amylase was achieved by engineered Klebsiella pneumoniae. The extracellular recombinant amylase accelerated the hydrolyzation of starch, and one‐step production of 2,3‐BD from starch was carried out by engineered K. pneumoniae. A 2,3‐BD concentration of 3.8 g L^?1 and yield of 0.19 g 2,3‐BD g^?1 starch were obtained after 24 h fermentation. CONCLUSION: The one‐step production of 2,3‐BD from starch was achieved by secretory over‐expression of amylase in K. pneumoniae. This would simplify the process and reduce the production cost considerably by enabling use of starch with minimal pretreatment. Copyright © 2008 Society of Chemical Industry