Rheological and morphological properties of high‐density polyethylene and poly(ethylene–octene) blends

The rheological and morphological properties of blends based on high‐density polyethylene (HDPE) and a commercial ethylene–octene copolymer (EOC) produced by metallocene technology were investigated. The rheological properties were evaluated in steady and dynamic shear experiments at 190°C in shear rates ranging from 90 s^?1 to 1500 s^?1 and frequency range between 10^?1 rad/s and 10² rad/s, respectively. These blends presented a high level of homogeneity in the molten state and rheological behavior was generally intermediate to those of the pure components. Scanning electron microscopy (SEM) showed that the blends exhibit dispersed morphologies with EOC domains distributed homogeneously and with particle size inferior to 2 μm. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 2240–2246, 2002     

Thermoelectric characterization of NaxMx/2Ti1−x/2O2 (M=Co, Ni and Fe) polycrystalline materials

Layered -titanate materials, Na_xM_x/2Ti_1−x/2O₂ (M=Co, Ni and Fe, x=0.2–0.4), were synthesized by flux reactions, and electrical properties of polycrystalline products were measured at 300–800 °C. After sintering at 1250 °C in Ar, all products show n-type thermoelectric behavior. The values of both d.c. conductivity and Seebeck coefficient of polycrystalline Na_0.4Ni_0.2Ti_0.8O₂ were ca. 7×10³ S/m and ca. −193 μV/K around 700 °C, respectively. The measured thermal conductivity of layered -titanate materials has lower value than conductive oxide materials. It was ca. 1.5 Wm⁻¹ K⁻¹ at 800 °C. The estimated thermoelectric figure-of-merit, Z, of Na_0.4Ni_0.2Ti_0.8O₂ and Na_0.4Co_0.2Ti_0.8O₂ was about 1.9×10⁻⁴ and 1.2×10⁻⁴ K⁻¹ around 700 °C, respectively.     

Software for Simulation of Second‐Generation Ethanol Production by a Simultaneous Saccharification and Fermentation Process

Environmental impacts associated with the consumption of fossil fuels and the need to generate power through renewable resources demands the usage of alternative materials. The objective is the production of clean energy from materials like lignocellulosic biomass to produce second‐generation (2G) ethanol. A software in the Matlab program is elaborated to simulate the simultaneous saccharification and fermentation (SSF) process of lignocellulosic biomass for the 2G ethanol production in batch reactors. Studying the effects of the process variables, it was found that the higher interference is caused by cellulose concentration. Higher concentrations of the product in batch processes are obtained with the maximum cellulose concentrations, cells, and enzyme.     

Relationship between Expression of Onco-Related miRNAs and the Endoscopic Appearance of Colorectal Tumors

Accumulating data indicates that certain microRNAs (miRNAs or miRs) are differently expressed in samples of tumors and paired non-tumorous samples taken from the same patients with colorectal tumors. We examined the expression of onco-related miRNAs in 131 sporadic exophytic adenomas or early cancers and in 52 sporadic flat elevated adenomas or early cancers to clarify the relationship between the expression of the miRNAs and the endoscopic morphological appearance of the colorectal tumors. The expression levels of miR-143, -145, and -34a were significantly reduced in most of the exophytic tumors compared with those in the flat elevated ones. In type 2 cancers, the miRNA expression profile was very similar to that of the exophytic tumors. The expression levels of miR-7 and -21 were significantly up-regulated in some flat elevated adenomas compared with those in exophytic adenomas. In contrast, in most of the miR-143 and -145 down-regulated cases of the adenoma-carcinoma sequence and in some of the de novo types of carcinoma, the up-regulation of oncogenic miR-7 and/or -21 contributed to the triggering mechanism leading to the carcinogenetic process. These findings indicated that the expression of onco-related miRNA was associated with the morphological appearance of colorectal tumors.     

FAME Production and Fatty Acid Profiles from Moist Chlorella sp. and Nannochloropsis oculata Biomass

In the present study, we investigated the production of fatty acid methyl esters (FAME) from moist Chlorella sp. and Nannochloropsis oculata biomass using a hydrolysis–esterification process. Additionally, we evaluated for the first time the fatty acid profile before and after this process. Hydrolysis of the lipid fraction was performed on a moist biomass in the presence of differing amounts of an acid catalyst in both 50 and 100 % w/w water relative to the biomass. The esterification of the crude extracts of the free fatty acids (FFA) was then investigated. The experiments show that in the presence of 50 % w/w water relative to the biomass, the hydrolysis–esterification process results in higher FFA and FAME yields. The analysis of the fatty ester profiles did not reveal any degradation of the FFA from the microalgae biomass under the hydrolysis–esterification conditions. The results were compared with both extraction–transesterification and direct transesterification processes using dry biomass. The extraction–transesterification and hydrolysis–esterification processes resulted in similar FAME yields and similar profiles of the fatty esters from dry and moist biomass materials, respectively.     

Soft nanocomposites: nanoparticles to tune gel properties

The demand for new, soft materials with bespoke physical and biological characteristics and functionality has fuelled the research into nanocomposite hydrogels. ‘Soft’ nanocomposites – nanoparticles within a hydrated, polymeric gel matrix – offer a simple, yet versatile, platform for the design of materials with specific – and tunable – properties. Indeed, the ‘soft’ properties of the matrix can be combined with the inherent functionality of the nanoparticles (drug loading, antimicrobial, light refraction etc.) or give rise to altogether new characteristics (toughness, optical properties, self‐healing etc.) evolved from the synergistic interaction of the polymer chains with the particles. In this review, we report the evolution and achievements of nanocomposite gels, with a focus on mechanisms and structure. The review is therefore structured around the properties resulting from the gel/nanoparticle association, rather than a classification based on applications or specific types of polymer or nanoparticles. How can nanoparticles tune mechanical, optical, biological properties or impart stimuli‐responsiveness to a polymer gel matrix ? and how is this behaviour linked to the underlying structure? © 2015 Society of Chemical Industry     

Influence of Alkaline Additives and Buffers on Mineral Trapping of CO2 under Mild Conditions

Carbon dioxide (CO₂) gas is the main contributor to climate change. CO₂ storage in underground brines and oil‐field brines by mineral trapping has been considered as a promising alternative in order to reduce CO₂ emissions. However, permanent storage of CO₂ in stable carbonate minerals is greatly dependent on brine pH, being favored over an alkaline pH. The effect of alkaline additives (NaOH, KOH, CaO) and buffer solutions (NaHCO₃/NaOH, Na₂HPO₄/NaOH, NH₄Cl/NH₄OH) on the mineral trapping of CO₂ under mild conditions using a synthetic brine is investigated. The results indicate that both NaOH+NH₄Cl/NH₄OH and KOH+NH₄Cl/NH₄OH mixtures promote precipitation mainly of calcium carbonate (CaCO₃).     

A Synthetic MUC1 Glycopeptide Bearing βGalNAc‐Thr as a Tn Antigen Isomer Induces the Production of Antibodies against Tumor Cells

This study presents the synthesis of the novel protected O‐glycosylated amino acid derivatives 1 and 2 , containing βGalNAc‐SerOBn and βGalNAc‐ThrOBn units, respectively, as mimetics of the natural Tn antigen (αGalNAc‐Ser/Thr), along with the solid‐phase assembly of the glycopeptides NHAcSer‐Ala‐Pro‐Asp‐Thr[αGalNAc]‐Arg‐Pro‐Ala‐Pro‐Gly‐BSA ( 3 ‐BSA) and NHAcSer‐Ala‐Pro‐Asp‐Thr[βGalNAc]‐Arg‐Pro‐Ala‐Pro‐Gly‐BSA ( 4 ‐BSA), bearing αGalNAc‐Thr or βGalNAc‐Thr units, respectively, as mimetics of MUC1 tumor mucin glycoproteins. According to ELISA tests, immunizations of mice with βGalNAc‐glycopeptide 4 ‐BSA induced higher sera titers (1:320 000) than immunizations with αGalNAc‐glycopeptide 3 ‐BSA (1:40 000). Likewise, flow cytometry assays showed higher capacity of the obtained anti‐glycopeptide 4 ‐BSA antibodies to recognize MCF‐7 tumor cells. Cross‐recognition between immunopurified anti‐βGalNAc antibodies and αGalNAc‐glycopeptide and vice versa was also verified. Lastly, molecular dynamics simulations and surface plasmon resonance (SPR) showed that βGalNAc‐glycopeptide 4 can interact with a model antitumor monoclonal antibody (SM3). Taken together, these data highlight the improved immunogenicity of the unnatural glycopeptide 4 ‐BSA, bearing βGalNAc‐Thr as Tn antigen isomer.