Cholesterol‐imprinted polymer receptor prepared by a hybrid imprinting method

A novel cholesterol‐imprinted polymer (CMIP‐H) was prepared by a hybrid method of covalent imprinting and non‐covalent imprinting. This approach involves the copolymerization of a template‐containing monomer, cholesteryl 2‐hydroxyethyl methacrylate carbonate, and a cross‐linker, followed by hydrolysis to afford a flexible guest‐binding site accompanied with the easy and efficient removal of a ‘sacrificial spacer’. The effect of solvent on the binding capacity of CMIP‐H towards cholesterol was studied, indicating that a good binding capacity towards cholesterol could be achieved in a less‐polar solvent. The binding experiments of CMIP‐H towards a series of structural analogues of cholesterol, including cholesterol acetate, progesterone and stigmasterol, were carried out in hexane. The results showed that CMIP‐H almost did not bind cholesterol acetate at all because the hydrogen‐bonding site is blocked. It exhibited a similar binding towards both cholesterol and stigmasterol, but much higher binding towards progesterone. Copyright © 2005 Society of Chemical Industry     

β－C_2S固溶体稳定的热力学研究

从热力学理论出发，利用Ｘ射线衍射定性和定量的方法，对β－Ｃ＿２Ｓ固溶体的稳定性进行了分析和研究。经热力学理论推导得出β－Ｃ＿２Ｓ稳定的热力学条件，即掺入的微量元素的化学位μ＿ｉ须小于β－Ｃ＿２Ｓ的反应自由焓△Ｇ＿β，μ＿ｉ＜△Ｇ＿β．并定量地计算出一种微量元素稳定β－Ｃ＿２Ｓ的临界掺加量为；多种微量元素对β－Ｃ＿２Ｓ的稳定性判断条件为：     

语音时域分割研究

在语音时域挑选剩余可懂度低的可用置换集合,置换集合是语音TDS系统中不可缺少的重要环节,本文给出了可用置换选取的条件、客观评价标准和方法。     

Mobility modeling, location tracking, and trajectory prediction inwireless ATM networks

Wireless ATM networks require efficient mobility management to cope with frequent mobile handoff and rerouting of connections. Although much attention has been given in the literature to network architecture design to support wide-area mobility in public ATM networks, little has been done to the important issue of user mobility estimation and prediction to improve the connection reliability and bandwidth efficiency of the underlying system architecture. This paper treats the problem by developing a hierarchical user mobility model that closely represents the movement behavior of a mobile user, and that, when used with appropriate pattern matching and Kalman filtering techniques, yields an accurate location prediction algorithm, HLP, or hierarchical location prediction, which provides necessary information for advance resource reservation and advance optimal route establishment in wireless ATM networks     

电位滴定法研究~(99)Tc-HMDP和~(99)Tc-HEDP中Tc的氧化态

~(99)Tc-HMDP和~(99)Tc-HEDP溶液是在相应的螫合剂存在下,用过量SnCl_2还原~(99)TcO_4-制得。用标准I_2液对SnCl_2进行了剩余量电位滴定,确定了在pH～3的介质中,~(99)Tc-HMDP和~(99)Tc-HE-DP中~(99)Tc的氧化态均为+4。全部实验在N_2气流中进行。~(99)Tc-HMDP和~(99)Tc-HEDP的紫外光谱表明:在用I_2滴定的过程中,~(99)Tc只处于一种氧化态+4;将它们放置在空气中,一小时后仍较稳定。     

Correlation of the reactivity,the active surface area and the total surface area of thin films of pyrolytic carbon

Using thin films of pyrolytic carbon the rate of the reaction with oxygen has been measured over the temperature range 625–740°C and at pressures of oxygen from 6–100 torr. The active surface area (ASA) of the films was measured from the total concentration of strongly-bound complexes with oxygen on the surface and the relative total surface area (TSA) was measured by low-temperature adsorption of nitrogen. A maximum in reactivity and in ASA was observed for films of average thickness of about 20 nm with a TSA of about 30 m² g^?1. At the maximum the ASA and TSA were essentially equal. The results are interpreted in terms of the mechanism of formation of pyrolytic carbon in the initial stages.     

纳米SiO2粉体的制备与研究

纳米SiO2粉体的制备是以硅酸钠和盐酸为原料，添加适宜的稳定剂(非离子表面活性剂)和分散剂，在适宜的pH值和温度下，采用化学沉淀法合成。研究表明，要得到性能优良纳米的SiO2粉体，最佳工艺条件为：温度20～40℃，pH=6，反应液质量浓度P1=20g／L，P2=1．20g／L，反应时间15min。结果表明：制备的纳米SiO2粒径30～50nm，比表面积大，分散性好，质量优良，可达到产业化的生产。     

HDPE新牌号树脂的研究

根据扬子石化公司开发HDPE新牌号产品的生产经验,从分子量及分子量分布与树脂性能的关系、密度对HDPE性能的影响、HDPE的共聚改性、HDPE的共混改性、添加剂与HDPE改性等5个方面讨论了HDPE新牌号产品开发的方法。     

Photopolymerization of methyl methacrylate initiated by benzophenone/aromatic tertiary amines

Summary The photopolymerization of methyl methacrylate initiated by benzophenone-tertiary aromatic amines was studied under irradiation at 365 nm. The initiating amino radicals were investigated with combined ESR and spin-trapping method. The rate of polymerization for different amines was found in the sequence of p-hydroxymethyl-N,N-dimethylaniline>N,N-dimmethyltoluidine>N,N-dimethylaniline>p-methyl-N,N-dihydroxyethylaniline. The influence of diphenylmethanol on the polymerization reveals the incapacity of the benzophenone ketyl radical to initiate, while the amino end-group was detected in the polymers. This end-group can interact with benzophenone again, leading to initiate further polymerization to give a copolymer.     

Design of the low power wake-up receiver for internet of things communication

A wake-up receiver with high energy efficiency and low power consumption is proposed for solving the power consuming problems of wireless nodes communication in the Internet of Things. The proposed wake-up receiver based on the wake-up mechanism can effectively schedule the network nodes communication, and use the simple envelope detection structure to achieve frequency down-conversion, which can flexibly manage energy and reduce power consumption. Based on UMC 65nm CMOS process technology, the wake-up receiver is designed and simulated. The results show that it can achieve S₁₁ of -21dBm and a sensitivity of -75dBm at a data rate of 1Mb/s, when operating at the central frequency of 780MHz and input signal adopting an on-off keying (OOK) modulation, and the power consumption is 82μW at 1.2V voltage supply.