Effect of Heat Treatment on Microstructure and Mechanical Properties of Extruded PM Ti–6Al–4V Alloy With Deformation Flowlines

Metallurgical and Materials Transactions A - Two heat treatments, namely 955°C/2h/AC (AC = air cooling) and 955°C/4h/FC (FC = furnace cooling), were carried out on...     

Ce对440C不锈轴承钢夹杂物演变的影响

为探究稀土Ce对440C不锈轴承钢中夹杂物的改性作用,利用实验室MoSi₂电阻炉对440C不锈轴承钢进行稀土Ce处理,采用OM、SEM等系统分析了Ce的添加对440C不锈轴承钢脱氧及夹杂物演变的影响。结果表明,随着Ce加入量的增加,其收得率逐渐升高。Ce的加入使钢中TO质量分数由0.002 5%降低至0.001 2%。未加入Ce的钢中夹杂物主要为Al₂O₃、MnS以及镁铝尖晶石;加入质量分数为0.011 5%的Ce后,夹杂物被改性为以Ce-Al-O为主的夹杂物;当Ce的添加量达到0.036 4%时,夹杂物被完全改性为Ce-O-S夹杂物。适量的Ce可以降低夹杂物尺寸及面积比例,但过量加入会使夹杂物尺寸变大。在本试验条件下,当Ce质量分数为0.011 5%时,钢中夹杂物细小弥散效果最明显。以上结论可为Ce在高碳铬不锈轴承钢中的应用提供参考。     

多孔钯的制备及其结构与性能

研究了以钯粉和碳酸钠为原料制备多孔钯的烧结-溶解新工艺，用FESEM分析了多孔钯的微观结构形貌，并进一步研究了制备的多孔钯的力学性能和氢同位素的交排换代性能。结果表明，烧结-溶解工艺能稳定地制备出孔隙率为85．29％-87．82％的多孔钯，其压缩强度大于2MPa。室温下孔隙率为87.30％的多孔钯对氘的单位质量吸收量为0．0767L／g，氢同位素排代交换率为86．2％。     

不同形貌Ga2O3纳米材料可控合成工艺研究

通过研究基片种类、加热温度、保温时间、冷却速度及是否加入催化剂等不同工艺参数对低维Ga2O3，纳米材料形貌的影响，确定出合成5种不同形貌β-Ga2O3纳米材料的工艺条件。场发射扫描电镜（FE-SEM）表明5种不同形貌α-Ga2O3纳米材料分别为纳米线、纳米棒、纳米带、纳米环及纳米片。X射线衍射（X-ray）分析结果表明不同形貌纳米材料均为晶格常数日=1．223nm，b=0．304nm，c=0．58nm，a=90°，β=103．7°，γ=90°的单斜晶系β-Ga2O3晶体。     

碱式硫酸镁晶须的合成及应用

以一定浓度的MgSO4和NaOH溶液为原料,在常温下混合,在160℃,0.5 MPa的条件下用水热法反应8 h,制备出增强阻燃材料MgSO4.5Mg(OH)2.3H2O型碱式硫酸镁晶须(MOS),探讨了反应条件对产物形貌、结构及组成的影响,初步确立了制备MOS的工艺条件。经过对复合材料的拉伸性能测试得出结论,采用MOS填充改性的聚丙烯,优于市售纳米氢氧化镁和阻燃级氢氧化镁。     

Structural and transport effects of doping perfluorosulfonic acid polymers with the heteropoly acids, H3PW12O40 or H4SiW12O40

A perfluorosulfonic acid (PFSA) polymer with pendant side chain -O(CF₂)₄SO₃H was doped with the heteropoly acids (HPAs), H₃PW₁₂O₄₀ and H₄SiW₁₂O₄₀. Infrared spectroscopy revealed a strong interaction between the HPA and the PFSA ionomer. Modes associated with the peripheral bonds of the HPA were shifted to lower wave numbers when doped into PFSA membranes. Small-angle X-ray scattering (SAXS) measurements showed the presence of large crystallites of HPA in the membrane with d spacings of ca. 10 Å, close to the lattice spacing observed in bulk HPA crystals. Under wet conditions the HPA was more dispersed and constrained the size of the sulfonic acid clusters to 20 Å at a 5 wt% HPA doping level, the same as in the vacuum treated ionomer samples. Under conditions of minimum hydration the HPA decreased the E_a for the self-diffusion of water from 27 to 15 kJ mol⁻¹. The reverse trend was seen under 100% RH conditions. Proton conductivity measurements showed improved proton conductivity of the HPA doped PFSAs at a constant dew point of 80 °C for all temperatures up to 120 °C and at all relative hummidities up to 80%. The activation energy for proton conduction generally was lower than for the undoped materials at RH ≤80%. Significantly the E_a was 1/2 that of the undoped material at RHs of 40 and 60%. A practical proton conductivity of 113 mS cm⁻¹ was observed at 100 °C and 80% RH.     

Maximum principle for mean-field jump–diffusion stochastic delay differential equations and its application to finance

This paper investigates a stochastic optimal control problem with delay and of mean-field type, where the controlled state process is governed by a mean-field jump–diffusion stochastic delay differential equation. Two sufficient maximum principles and one necessary maximum principle are established for the underlying system. As an application, a bicriteria mean–variance portfolio selection problem with delay is studied to demonstrate the effectiveness and potential of the proposed techniques. Under certain conditions, explicit expressions are provided for the efficient portfolio and the efficient frontier, which are as elegant as those in the classical mean–variance problem without delays.     

Lewis酸存在下的自由基共聚合——Ⅰ.GeCl_4与BCl_3存在下的乙酸乙烯酯与丙烯酸交替共聚

乙酸乙烯酯(VAc)与丙烯酸(AA)在GeCl_4及BCl_3存在下通过自由基聚合可得到交替共聚物。对GeCl_4体系,聚合反应速率正比于[引发剂]~(0.5)。当VAc/AA=1:1(mol比)时有最大反应速率。CCl_4对本聚合反应无链转移作用。通过紫外光谱分析可证实VAc及AA均与GeC\(?)生成络合物;ESR分析表明,络合AA自由基较未络合AA有较强的阳离子特性,交替共聚的原因可能与络合AA自由基及活化单体络合物二者有关。     

加热炉用喷补料的研制及应用

介绍了ＨＹＪ—０１喷补料的实验室研制及工业应用。实践表明，该喷补料粘接强度好，抗热震性好。喷补衬使用时间已超过１４个月，无明显破损现象。     

炭黑－环氧树脂导电复合材料的研究

本文研究了炭黑－环氧树脂复合材料的制备工艺及炭黑填充率对材料电阻率的影响。实验结果表明，加入表面活性剂，明显改善了炭黑在环氧树脂中分布的均匀性。炭黑－环氧树脂材料具有明显的渗流效应，正温度系数效应即ＰＴＣ效应，非线性伏安特性和电磁波屏蔽效应。