Effect of Wall Surface Properties at Different Drying Kinetics on the Deposition Problem in Spray Drying

Current methods in alleviating the wall deposition problem in spray drying emphasize mainly controlling the stickiness of the drying particles and less attention is placed on the properties of the dryer wall. In this experimental study, the effect of wall surface properties on the deposition mechanism has been investigated. Properties considered in classifying different wall materials were surface energy, roughness, and dielectric properties. The model solution contained sucrose, representing low-molecular-weight sugars commonly encountered in spray drying of fruit and vegetable juices. The effect of wall properties on deposition was explored at different drying rates producing particles of different surface rigidity. Larger surface roughness produced higher deposition fluxes for particles with high impact velocity and moisture. Surface energy and surface roughness were found to have no significant effect for dry rigid particles at the middle and bottom elevation of the drying chamber. However, material with lower surface energy (Teflon) exhibited less deposition for rubbery particles at such elevations. Analysis shows that dielectric wall material (Teflon) tends to enhance deposition of dry particles because of attrition at the surface. Higher wall temperature was found to produce slightly more deposition. The results of this work give a general indication of the effect of wall material on the deposition problem and provide the fundamental understanding for further studies along this line. Proper selection of dryer wall material will provide potential alternatives for reducing the deposition problem.     

基于遗传算法的土钉支护结构优化设计研究

通过建立三维有限元模型,对土钉支护的变形和受力性能进行分析,得出土钉力的合理分布。在此基础上,考虑土钉支护的水平位移,采用遗传算法,对土钉支护的结构优化设计进行研究,建立了土钉支护结构的优化设计数学模型,并编制了相应的计算程序。通过算例分析,并与基于极限平衡分析的优化结果相比较,得出合理的土钉支护结构设计的参考结论。     

Average consensus in networks of dynamic agents with switching topologies and multiple time-varying delays

In this paper, we discuss average consensus problem in undirected networks of dynamic agents with fixed and switching topologies as well as multiple time-varying communication delays. By employing a linear matrix inequality method, we prove that all the nodes in the network achieve average consensus asymptotically for appropriate communication delays if the network topology is connected. Particularly, several feasible linear matrix inequalities are established to determine the maximal allowable upper bound of time-varying communication delays. Numerical examples are given to demonstrate the effectiveness and the sharpness of the theoretical results.     

One-to-Many and Many-to-One Optical Chaos Communications Using Semiconductor Lasers

A theoretical construction of one-to-many (OTM) and many-to-one (MTO) chaos synchronization communications using semiconductor lasers is presented. One center laser provides strong injections (strong link) to other side lasers, and the side lasers also provide weak injections (weak link) to the center one. Simulation results show that the side lasers synchronize with the center laser through injection-locking. In addition, messages transmitted via the strong links or the weak links experience strong chaos pass filtering, enabling us to realize OTM and MTO communications.     

Quadtree-based genetic algorithm and its applications to computer vision

Many computer vision problems can be formulated as optimization problems. Presented in this paper is a new framework based on the quadtree-based genetic algorithm that can be applied to solve many of these problems. The proposed algorithm incorporates the quadtree structure into the conventional genetic algorithm. The solutions of image-related problems are encoded through encoding the corresponding quadtrees, and therefore, the 2D locality within a solution can be preserved. Examples addressed using the proposed framework include image segmentation, stereo vision, and motion estimation. In all cases, encouraging results are obtained.     

Sandwich panels with Kagome lattice cores reinforced by carbon fibers

Stretching dominated Kagome lattices reinforced by carbon fibers were designed and manufactured. The sandwich panels were assembled with bonded laminate skins. The mechanical behaviors of the sandwich panels were tested by out-of-plane compression, in-plane compression and three-point bending. Different failure modes of the sandwich structures were revealed. The experimental results showed that the carbon fiber reinforced lattice grids are much stiffer and stronger than foams and honeycombs. It was found that buckling and debonding dominate the mechanical behavior of the sandwich structures, and that more complaint skin sheets might further improve the overall mechanical performance of the sandwich panels.     

钻井液振动筛叠层筛网透筛率的研究

从理论上详细论述了钻井液振动筛叠层筛网对固相颗粒分离的影响 ,首次提出用透筛率的概念定量地描述这一影响 ,并进行了实例计算。研究表明 ,当上下层筛网随机叠加时对透筛率的影响有以下几种情况 :(1)当上下层筛网开孔尺寸相除的余数为零 ,任意组合叠层筛网的透筛率分别为某一常数 ;(2 )上层筛网目数一定时 ,下层筛网目数越大 ,则透筛率越小 ;(3)上下层筛网的目数相差越小 ,透筛率越小 ;(4 )任意目数的上下层筛网随机叠加后 ,其透筛率仅在一个小范围内变化 ,因此任一叠层筛网有其固有的透筛率属性。     

Fast-converging minimum frequency error RLS lattice filter for narrowband interference with discrete frequency steps

This paper discusses the fundamental convergence and frequency tracking properties of the recursive-least-squares (RLS) lattice filter in the presence of narrowband interference (NBI) whose frequency varies in discrete steps. It is shown for filters of this type, that the residual forward energy (RFE) after a frequency transition is a function of the input signal-to-noise ratio (SNR), separation of the sequential frequencies and the filter time constant and is exponentially decaying in nature. Reducing the RFE is important in removing unwanted transient artefacts from the desired signal. The convergence behaviour of the RLS algorithm based on a posteriori estimation errors is analysed under a number of conditions by varying the SNR and frequency step size. In order to limit the impact of the RFE while maintaining a minimum frequency tracking error in steady conditions, a fast-converging minimum frequency error (FCMFE) RLS lattice filter is suggested. For comparison, a least-mean-square (LMS) based gradient-adaptive lattice (GAL) filter is also analysed for this class of narrowband interference.     

新型微波有源滤波器综合方法

本文给出了一种新颖的微波有源滤波器的拓扑结构及综合方法，并对有源滤波电路进行了计算机模拟，结果表明本文给出的微波有源滤波器电路具有优良的的窄带滤波特性，通带内正向增益大于１０ｄＢ，带外抑制大于３０ｄＢ。     

Determination and interpretation of fractal properties of the sandstone pore system

A knowledge of fractal properties of the pore system is extremely useful with regard to the interrelationships between moisture transport and pore structure. The fractal dimension characterises the egree of resolutiondependence of a property. Given a completely interlaced pore system such as that of sandstone, the fractal dimension of the pore volume, or the porosity, quantifies the cross-sectional variability of the pore channels and is thus of great relevance with regard to transport processes. The fractal dimension of the pore surface describes the surface roughness. A newly-developed measuing technique is presented for the simultaneous determination of fractal dimensions of porosity and pore surface and for establishing fraction radii distributions in order to derive relevant parameters for moisture transport.