Study of Some Variables Affecting Particle Size and Particle Size Distribution of Suspension Polymerization of Methyl Methacrylate

A laboratory reactor was designed and constructed to study the effect of both speed of agitation and a concentration of suspension stabilizer on particle size and particle size distribution during the suspension polymerization of methyl methacrylate. It was concluded that the average particle size of the prepared polymer powder is directly proportional to the speed of agitation and is inversely proportional to the stabilizer concentration. New empirical equations correlating the average particle size and the particle size distribution (PSD) were derived from the study.     

Distributed model predictive control of switched nonlinear systems with scheduled mode transitions

A method for the design of distributed model predictive control (DMPC) systems for a class of switched nonlinear systems for which the mode transitions take place according to a prescribed switching schedule is presented. Under appropriate stabilizability assumptions on the existence of a set of feedback controllers that can stabilize the closed‐loop switched, nonlinear system, a cooperative DMPC architecture using Lyapunov‐based model predictive control (MPC) in which the distributed controllers carry out their calculations in parallel and communicate in an iterative fashion to compute their control actions is designed. The proposed DMPC design is applied to a nonlinear chemical process network with scheduled mode transitions and its performance and computational efficiency properties in comparison to a centralized MPC architecture are evaluated through simulations. © 2013 American Institute of Chemical Engineers AIChE J, 59:860‐871, 2013     

Conformational,thermal, and ionic conductivity behavior of PEO in PEO/PMMA miscible blend: Investigating the effect of lithium salt

In this research, influence of incorporating LiClO₄ salt on the crystallization, conformation, and ionic conductivity of poly(ethylene oxide) (PEO) in its miscible blend with poly(methyl methacrylate) (PMMA) is studied. Differential scanning calorimetry showed that the incorporation of salt ions into the blend suppresses the crystallinity of PEO. The X‐ray diffraction revealed that the unit‐cell parameters of the crystals are independent of the LiClO₄ concentration despite of the existence of ionic interactions between PEO and Li cations. In addition, the complexation of the Li⁺ ions by oxygen atoms of PEO is investigated via Fourier transform infrared spectroscopy. The conformational changes of PEO segments in the presence of salt ions are studied via Raman spectroscopy. It is found that PEO chains in the blend possess a crown‐ether like conformation because of their particular complexation with the Li⁺ ions. This coordination of PEO with lithium cations amorphize the PEO and is accounted for suppressed crystallinity of PEO in the presence of salt ions. Finally, electrochemical impedance spectroscopy is used to characterize the ionic conductivity of PEO in the PEO/PMMA/LiClO₄ ternary mixture at various temperatures. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013     

The component miscibility evolution during polymerization of the polybutadiene containing styrene solutions

In situ graft copolymerization of polystyrene (PS) on polybutadiene (PB) during polymerization of PB solution in styrene monomer was investigated to determine the performance of grafting process, chain structure of generated copolymers, and their effectiveness as compatibilizing agents for incompatible PS-rich and PB-rich phases. The amount of copolymers and their chain structures at different stages of polymerization were determined by gel permeation chromatography (GPC) curves of the reactive blends (taken directly from the reaction) and physical blends (physically prepared based on total composition of reactive blends). It was demonstrated that copolymer formation started from the early stage of polymerization and continued up to the phase inversion stage. In addition, PS grafting on PB occurred initially via single-chain attachment and then converted to a double-chain scenario later on. Compatibilizing efficiency of the copolymers was evaluated by Huggins coefficient (k _H) obtained by performing dilute solution viscometry (DSV) on samples taken at different stages of conversions. The effect of molecular weight of PB on the grafting process and the effectiveness of copolymers generated were also studied. It was found that while compatibilizing role of the copolymers produced from high molecular weight PB (HPB) increases as conversion goes further, the compatibilizing efficiency of the copolymers produced from low molecular weight PB (LPB) shows a very sharp variation in a small range of conversion. Plotting k _H of physical blends against weight fraction of PB molecules in solid content of the solutions (w _PB) showed negative deviation from mixture law with a W-like pattern containing two minima with a maximum in between. While a negative deviation was assumed as indication of immiscibility of the components, upward deviation at middle values of w _PB was attributed to molecular segregations that reduce the interface between the incompatible PS-rich and PB-rich phases.     

Fabrication and modification of polyvinylchloride based heterogeneous cation exchange membranes by simultaneously using Fe-Ni oxide nanoparticles and Ag nanolayer: Physico-chemical and antibacterial characteristics

Polyvinylchloride-blend-styrene butadiene rubber based nanocomposite cation exchange membranes were prepared by solution casting technique. Iron-oxide nanoparticles and Ag-nanolayer were simultaneously utilized as filler and surface modifier in membrane fabrication. The effects of Ag-nanolayer film thickness on membrane physicochemical and antibacterial characteristics of nanocomposite PVC-blend-SBR/Iron-oxide nanoparticles were studied. SEM images showed membrane roughness decreasing by Ag nanolayer thickness increasing. Membrane charge density and selectivity declined by Ag nanolayer coating up to 5 nm in membranes and then showed increasing trend by more nanolayer thickness. Ionic flux also showed increasing trend. Membranes showed good ability in E-Coli removal. 20 nm Ag-nanolayer coated membrane showed better performance compared to others.     

Experimental investigation of particle contact time at the wall of gas fluidized beds

The contact time of particles at the walls of gas fluidized beds has been studied using a radioactive particle tracking technique to monitor the position of a radioactive tracer. The solids used were sand or FCC particles fluidized by air at room temperature and atmospheric pressure at various superficial velocities, covering both bubbling and turbulent regimes of fluidization. Based on the analysis of tracer positions, the motion of individual particles near the walls of the fluidized bed was studied. The contact time, contact distance and contact frequency of the particles at the wall were evaluated from these experimental data. It was found that in a bed of sand particles, the mean wall contact time of the fluidized bed of sand particles decreases by increasing the gas velocity in the bubbling and increases in the turbulent fluidization. In other words, the particle-wall contact time is minimum at the onset of turbulent fluidization in the bed of sand particles. However, the mean wall contact time is almost constant in both regimes of fluidization in the bed of FCC particles. All the existing models in the literature predict a decreasing contact time when the gas velocity in the bed is increased. It was also shown that the contact distance increases monotonously by increasing the gas velocity in the bed of sand particles, while it is almost constant for the bed of FCC particles. Contact frequency has a trend similar to that of the contact time for both sand and FCC particles.     

Synergistic effect of salt ions and water-soluble amphiphilic compounds of acidic crude oil on surface and interfacial tension

This study investigated the effect of solubility of amphiphilic compounds of acidic crude oil in water on the surface and interfacial tension (IFT) with NaCl, MgCl₂, CaCl₂, and Na₂SO₄ salts. Accordingly, distilled water, along with the salts mentioned in zero ionic strength up to 2 mol were put in contact with crude oil to become saturated with amphiphilic compounds. The effects of these compounds were investigated on the properties of contact water by pH, total organic carbon (TOC), FTIR (Fourier transform infrared spectroscopy), water-air surface tension (ST), and water-n-decane IFT tests. The results showed that some of the organic components of crude oil, especially acidic and basic compounds, are present or soluble in water, which have a significant effect on reducing the surface and IFT. The IFT reduction of water-n-decane was greater than the water-air ST system. Also, the observations showed that for both NaCl and Na₂SO₄ salt water, with increasing ionic strength of water, there was an optimum salinity within the range of 0.1-0.25 mol/L for both salts with the amount of surface and IFT minimized at this point. In the other two salts, this point was delayed upon elevation of ionic strength and was observed at high salinity. In this case, divalent cations reduce tension rate compared to monovalent cations. Due to solubility of acidic and basic groups in water, pH of salt water illustrates an acidic trend. Results of the FTIR test confirmed solubility of these compounds as well.     

Future directions in physiochemical modeling of the thermodynamics of polyelectrolyte coacervates

We review theories of polyelectrolyte (PE) coacervation, which is the spontaneous association of oppositely charged units of PEs and phase separation into a polymer-dense phase in aqueous solution. The simplest theories can be divided into “physics-based” and “chemistry-based” approaches. In the former, PEs are treated as charged, long-chain, molecules, defined by charge level, chain length, and chain flexibility, but otherwise lacking chemical identity, with electrostatic interactions driving coacervation. The “chemistry-based” approaches focus on the local interactions between the species for which chemical identity is critical, and describe coacervation as the result of competitive local binding interactions of monomers and salts. In this article, we show how these approaches complement each other by presenting recent approaches that take both physical and chemical effects into account. Finally, we suggest future directions toward producing theories that are made quantitatively predictive by accounting for both long range electrostatic and local chemically specific interactions.     

A Review on the Role of miR-149-5p in the Carcinogenesis

miR-149 is an miRNA with essential roles in carcinogenesis. This miRNA is encoded by the MIR149 gene on 2q37.3. The miR-149 hairpin produces miR-149-5p and miR-149-3p, which are the “guide” and the sister “passenger” strands, respectively. Deep sequencing experiments have shown higher prevalence of miR-149-5p compared with miR-149-3p. Notably, both oncogenic and tumor suppressive roles have been reported for miR-149-5p. In this review, we summarize the impact of miR-149-5p in the tumorigenesis and elaborate mechanisms of its involvement in this process in a variety of neoplastic conditions based on three lines of evidence, i.e., in vitro, in vivo and clinical settings.     

The Emerging Role of Non-Coding RNAs in the Regulation of Virus Replication and Resultant Cellular Pathologies

Non-coding RNAs, particularly lncRNAs and miRNAs, have recently been shown to regulate different steps in viral infections and induction of immune responses against viruses. Expressions of several host and viral lncRNAs have been found to be altered during viral infection. These lncRNAs can exert antiviral function via inhibition of viral infection or stimulation of antiviral immune response. Some other lncRNAs can promote viral replication or suppress antiviral responses. The current review summarizes the interaction between ncRNAs and herpes simplex virus, cytomegalovirus, and Epstein–Barr infections. The data presented in this review helps identify viral-related regulators and proposes novel strategies for the prevention and treatment of viral infection.