Comfort limits for asymmetric thermal radiation

Groups of 32 and 16 subjects of both sexes were exposed in an environmental chamber to radiant asymmetry caused by a cool wall, a warm wall, and a cool ceiling. Each subject was tested individually while seated and clothed at 0.6 clo. During each 3.5-hour experiment the subject was exposed to six radiant temperature asymmetries. He was asked whether and where he experienced any local cool or warm sensation, and whether it was felt to be uncomfortable. During the entire experiment he was kept thermally neutral by changing the air temperature according to his wishes.For cool walls, warm walls, and cool ceilings curves have been established showing the percentage of dissatisfied subjects as a function of the radiant asymmetry. Radiant asymmetry at a warm wall caused less discomfort than a cool wall. A cool ceiling caused less discomfort than a warm ceiling. Accepting that 5% of the subjects may feel uncomfortable. a radiant temperature asymmetry of 10°C is allowable at a cool wall, 23°C at a warm wall, and 14°C under a cool ceiling. A previous study showed that 4°C is allowable under a warm ceiling. Radiant asymmetry had no significant impact on the operative temperatures preferred by the subjects. No significant differences were observed between the responses of men and women exposed to radiant asymmetry.     

Use of colloidal ruthenium particles in the electrochemical reduction of benzene by solvated electrons

Ruthenium colloidal particles prepared by the decomposition of a ruthenium acid sulfite complex increased the electrochemical reduction of benzene from 45% to 60% at room temperature and 10 psig of hydrogen. The reduction was carried out in a 21 mole % ethanol - 79 mole % hexamethylphosporamide. The significant increase in the percent of benzene reduced was accompanied by an apparent current efficiency of 98%. Comparison with analogous experiments employing colloidal platinum particles indicates that the above increase in benzene reduction can be attributed to direct catalytic hydrogenation by the ruthenium.     

Whisker reinforcement of glass-ceramics

Silicon carbide whisker reinforcement of anorthite and cordierite glass ceramics has been studied. At 25 vol% whisker loading the flexural strengths increased from 65–103 MPa to 380–410 MPa, the fracture toughnesses increased from 1.0–1.5 MPa m^1/2 to 5.2–5.5 MPa m^1/2. The strengths decline to 240–276 MPa at 1200 °C. The reasons for the decrease in strength with temperature are discussed. Whiskers from two different sources with differences in diameters and aspect ratios were evaluated and the effect of the whisker morphology on the composite properties was studied. It was found that larger diameter, higher aspect ratio whiskers result in improved composite performance. The composites were also characterized in terms of their thermal properties, i.e. thermal expansions and thermal conductivities. The thermal expansion coefficient from 25–1000 °C for anorthite-based composite was 4.6×10^–6 °C^–1 and that for the cordierite-based composite was 3.62×10^–6 °C^–1. The thermal conductivities at 1000 °C were 3.75 and 4.1 Wm^–1 K^–1 for cordierite and anorthite composites, respectively.     

Extremely low-loss 1.5%-/spl Delta/ 32-channel athermal arrayed-waveguide grating multi/demultiplexer

A silica-based 1.5%-/spl Delta/ 100 GHz-spacing 32-channel athermal arrayed-waveguide grating (AWG) with compact size and extremely low insertion loss is described. By reducing the fibre coupling loss and the excess loss in a silicone-filled groove, an insertion loss of 1.3 dB was achieved with this athermal AWG.     

Continuous-wave lasing of single-mode metamorphic quantum dot lasers for the 1.5-μm spectral region

Lasers based on InAs/InGaAs quantum dots grown on metamorphic (In,Ga,Al)As layers deposited by MBE on GaAs substrates exhibited emission near 1.5 μm with a differential quantum efficiency of about 50%. The narrow-stripe lasers operate in a single transverse mode and withstand continuous current density above 20 kA cm^?2 without significant degradation. A maximum continuous-wave output power of 220 mW is obtained. Neither current nor beam filamentation was observed up to the highest pumping levels.     

Efficient data processing and quantum phenomena: Single-particle systems

We study the relation between the acquisition and analysis of data and quantum theory using a probabilistic and deterministic model for photon polarizers. We introduce criteria for efficient processing of data and then use these criteria to demonstrate that efficient processing of the data contained in single events is equivalent to the observation that Malus' law holds. A strictly deterministic process that also yields Malus' law is analyzed in detail. We present a performance analysis of the probabilistic and deterministic model of the photon polarizer. The latter is an adaptive dynamical system that has primitive learning capabilities. This additional feature has recently been shown to be sufficient to perform event-by-event simulations of interference phenomena, without using concepts of wave mechanics. We illustrate this by presenting results for a system of two chained Mach-Zehnder interferometers, suggesting that systems that perform efficient data processing and have learning capability are able to exhibit behavior that is usually attributed to quantum systems only.     

Hydrologic regionalisation impacts on wet-weather control selection.

Continuous simulation is performed using the US Environmental Protection Agency (USEPA) Storm Water Management Model (SWMM) to evaluate regional differences around the United States in hydrologic and water quality performance of wet-weather controls. Controls are characterised as being limited by peak inflow rate (i.e. any device with little or no storage, such as screens, filters and some proprietary devices) or by storage capacity (e.g., ponds, tanks). For flow-limited devices, results are presented in the form of percentage of annual runoff volume captured (passing through the device) for a given inflow capacity. For storage-limited devices, results are presented in two forms: percentage of annual runoff volume captured as a function of unit basin size and drawdown (drain) time, and as a percentage of total suspended solids captured, for the same two variables. Regional differences are apparent, driven mainly by variations in rainfall patterns around the country.     

Effect of nisin on the storage of sous vide processed Korean seasoned beef

Seasoned beef called Jangzorim in Korea is produced by boiling in soy sauce, and is a popular food in Korea. The aim of this study is to evaluate the microbial safety and physical qualities of sous vide processed seasoned beef, and the effect of nisin during storage. Sous vide processed packages with or without nisin (100 IU or 500 IU) were stored at 4 °C or 25 °C for 60 days, and samples measured for quality at regular intervals throughout this storage period. In the case of 25 °C storage, the number of mesophilic microorganisms in seasoned beef packages without nisin increased markedly, but with nisin there was no observed increase. Psychrotrophic microorganisms, anaerobic microorganisms, and B. cereus cells showed similar trends, although C. perfringens was not detected in all samples. At 25 °C storage, changes in the cutting force of packages containing nisin showed no significant change, packages without nisin decreased markedly. The colour of packages without nisin showed a drastic decrease in lightness (‘L’) while no changes were observed in packages with nisin.     

Processes of the Collision Interaction between Ceramic Particles Being Crushed in a Circulation Pneumatic Crusher

A new circulation pneumatic crusher capable of producing submicron powders of refractory materials is presented. A mathematical model is constructed for the dynamic breaking of ceramic macroparticles. This model allows the basic laws of shock-wave crushing in the circulation pneumatic apparatus to be analyzed.__________Translated from Teoreticheskie Osnovy Khimicheskoi Tekhnologii, Vol. 39, No. 3, 2005, pp. 327–333.Original Russian Text Copyright © 2005 by Belov, Biryukov, Roslyak, Yugov, Afanas’ev.     

Preparation and Characterization of Novel Polyimides from 2,6-bis[1-(p-dimethylaminophenylimino)ethyl] pyridine for the Selective Extraction of some Metals

Summary A group of new polyimides has been prepared by solution condensation of 2,6-bis[1-(p-dimethylaminophenylimino)ethyl] pyridine containing pendant NMe₂ units and various dianhyrides in N-methylpyrrolidone (NMP). The tridentate (N-N′-N) pydim ligands were prepared by Schiff-base condensation of 2,6-diacetylpyridine and 4-dimethylaminoaniline in the presence of formic acid as catalyst. These polymers were investigated for their extraction capabilities for Zn(II), Mn(II), Cu(II), Cd (II) and Ni(II) and at different pH. Under different conditions enhanced selectivity was observed. Up to 98% quantitative recoveries were observed for all metals.