以显微荧光检验法检测常用盖印材料

显微荧光检验法是显微检验的一个重要角度,由于缺少基础性研究,这一方法在文件检验中的运用并不广泛.着重考虑曝光时间这一因素,以盖印材料的荧光特性为观察角度,运用显微荧光检验法对大量常用盖印材料进行系统、全面的观察和研究.研究表明,绝大部分盖印材料可被激发出荧光,每种盖印材料的荧光特性都有各自的规律性特点.     

Morphologies-Controlled Synthesis and Optical Properties of Bismuth Tungstate Nanocrystals by a Low-Temperature Molten Salt Method

Well-crystallized bismuth tungstate (Bi₂WO₆) powders with different morphologies were successfully synthesized via a low-temperature molten salt method. The powders were characterized by X-ray diffraction, transmission electron microscopy, and UV-Vis, respectively. It was found that the variation of morphology of the obtained Bi₂WO₆ powder mainly depends on the different reaction temperatures and the weight ratio of LiNO₃–NaNO₃ salt to precursor. In addition, the UV-Visible absorption spectra showed that the synthesized powders had strong light absorption properties not only in the ultraviolet light but also in the visible light region.     

PPTA／尼龙1010分子复合材料流变行为的研究

本文采用共沉淀法制备了聚对苯二甲酰对苯二胺(PPTA)/尼龙1010分子复合材料。测定了PPTA/尼龙1010分子复合材料的流变行为,发现PPTA使尼龙1010的表观熔体粘度变大,且PPTA/尼龙1010分子复合材料的表观熔体粘度对温度的敏感性不象尼龙1010那样突出。     

EDTA在尿素换热设备清洗中的应用

草酸法清洗换热设备垢层时对设备腐蚀严重。EDTA能与积垢中的铁离子反应生成溶于水的络合离子,达到清洗积垢的目的,对设备腐蚀程度也小,通过EDTA、Fe含量的变化可判断清洗程度。     

聚合转化率对硫调型氯丁胶结构与性能的影响

研究了硫调型氯丁橡胶乳液聚合中转化率对产晶结构与性能的影响.结果表明,随单体转化率的提高,聚合物的凝胶量及其交联密度增大,致使断链速度减慢,所得断链胶的门尼粘度上升,残存凝胶量增加,分子支化程度增大,分子量分布变宽,焦烧时间缩短。而相应硫化胶的拉伸强度、撕裂强度、冲击弹性和硬度等提高,扯断伸长率和永久变形下降。这些变化一般在转化率为80——85％时有明显转折.综合考虑产量与质量,聚合转化率控制在82±2％较为适宜。     

Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.     

英汉情感隐喻的共性与差异

为进一步了解情感隐喻的实质,以人类基本情感的隐喻表达作讨论对象,对英汉语言中的基本情感隐喻进行共性与差异分析。     

VR技术对地下步行商业街心理环境辅助设计初探

文章力图以VR（虚拟现实）技术手段应用于城市地下步行商业街规划设计,来解决当前传统规划手段地下步行商业街规划中普遍存在的对其心理环境构筑的忽视和考虑不完善的诟病,以期最大限度消除规划设计中消极空间的产生,并对其关键技术进行了研究和探讨     

Molten salts/ceramic-foam matrix composites by melt infiltration method as energy storage material

A new type of high temperature energy storage material was obtained through the melt infiltration method, using compounding SiC ceramic foam as matrix and Na₂SO₄ as phase change material. The resulting composite material was measured by XRD, SEM, TG-DSC methods. The experimental results indicate that the composite is composed of silicon carbide, sodium sulfate and square quartz, and no chemical reactions occurs between Na₂SO₄ and SiC matrix. Na₂SO₄ has a good bonding with the SiC ceramic foam matrix. As the composite material is characterized by high thermal energy storage density and high thermal conductivity, it is suit for energy storage under high temperature. Funded by the “863” Hi-Tech Research and Development Program of China (2008AA05Z418)     

弱酸性条件起始合成MUF树脂工艺研究

为了开发一种新的在"弱酸—弱碱—弱酸—弱碱"条件下合成三聚氰胺-尿素-甲醛树脂(MUF)的工艺,对弱酸性条件下起始合成MUF工艺进行研究.探讨了在不同酸性阶段加入的三聚氰胺对脲醛树脂性能的影响,找出最佳的三聚氰胺改性脲醛树脂的合成工艺.在最佳工艺基础上,评价三聚氰胺用量对MUF树脂性能的影响以及对胶合板性能的影响,并对MUF树脂和普通脲醛树脂进行红外分析.结果证明:三聚氰胺在甲醛与尿素一次缩聚之后加入,对脲醛树脂改性效果最好,其胶合板湿剪切强度与甲醛释放量之间达到较好平衡,胶合板甲醛释放量为0.63mg/L,湿剪切强度为1.03MPa.红外谱图分析表明:三聚氰胺分子以亚甲基与脲醛树脂分子链相连并有可能嵌入脲醛树脂分子链中,形成一定数量的醚键,使三聚氰胺在脲醛树脂中真正起到骨架作用.