Preparation of spherical fine ZnO particles by the spray pyrolysis method using ultrasonic atomization techniques

An ultrasonic atomizer was used in the spray pyrolysis method to prepare fine, spherical and uniform ZnO particles. Almost spherical particles were obtained successfully which had a mean particle size of 0.15 m and had a very narrow particle size distribution. By using alcohol as the solvent, it was found that the particles do not have hollow shell layers which could usually be observed in the spray pyrolysis process by using water as the solvent. The morphology of the ZnO particles was strongly affected by the concentration of the starting solution.     

Pulsed NMR study in nuclear ordered solid3He

The nuclear spin dynamics in nuclear spin ordered solid³He in low magnetic fields on the melting curve has been studied by pulsed NMR down to 0.6 mK. The free induction decay signals (FID) were measured in single crystals of solid³He at three operating frequencies of 920, 1380, and 1840 kHz. The FIDs were nonexponential and dependent on the rf pulse strength _p H ₁ t _w , where is the gyromagnetic ratio,H ₁ is the rf field strength, andt _w is the pulse width. At small _p they decayed almost linearly in time with a small exponential tail at the end. When _p was further increased they became shorter and neither exponential nor linear in time. At large _p they decayed very rapidly and sometimes could not be observed at all because of the dead time of the NMR detection system. Such behavior of the FID was observed in many different single crystals in the given temperature range at 920 kHz. Tsubota and Tsuneto have shown by solving the nonlinear equations of motion numerically that the motion of the nuclear spin becomes chaotic when the tipping angle exceeds a critical value. Comparing their result with our experimental results, we concluded that some of the results of the rapid decay of the FID at large _p might be attributed to the onset of the chaotic motion. At 1840 kHz it is expected that the nonlinear effects in the equations of motion become less effective than that at 920 kHz. In fact, at this operating frequency the FIDs even at large _p and the tipping angle-dependent frequency shift could be observed. These frequency shifts were in rather good agreement with Namaizawa's theory provided an effective tipping angle was taken into account.     

One-Step Generation of Multiple Gene-Edited Pigs by Electroporation of the CRISPR/Cas9 System into Zygotes to Reduce Xenoantigen Biosynthesis

Xenoantigens cause hyperacute rejection and limit the success of interspecific xenografts. Therefore, genes involved in xenoantigen biosynthesis, such as GGTA1, CMAH, and B4GALNT2, are key targets to improve the outcomes of xenotransplantation. In this study, we introduced a CRISPR/Cas9 system simultaneously targeting GGTA1, CMAH, and B4GALNT2 into in vitro-fertilized zygotes using electroporation for the one-step generation of multiple gene-edited pigs without xenoantigens. First, we optimized the combination of guide RNAs (gRNAs) targeting GGTA1 and CMAH with respect to gene editing efficiency in zygotes, and transferred electroporated embryos with the optimized gRNAs and Cas9 into recipient gilts. Next, we optimized the Cas9 protein concentration with respect to the gene editing efficiency when GGTA1, CMAH, and B4GALNT2 were targeted simultaneously, and generated gene-edited pigs using the optimized conditions. We achieved the one-step generation of GGTA1/CMAH double-edited pigs and GGTA1/CMAH/B4GALNT2 triple-edited pigs. Immunohistological analyses demonstrated the downregulation of xenoantigens; however, these multiple gene-edited pigs were genetic mosaics that failed to knock out some xenoantigens. Although mosaicism should be resolved, the electroporation technique could become a primary method for the one-step generation of multiple gene modifications in pigs aimed at improving pig-to-human xenotransplantation.     

Adsorption properties of oxygen and methane on Ga-ZSM-5; the origin of the selectivity of NOx reduction using methane

The adsorption properties of oxygen and methane on Ga-ZSM-5 and Cu-ZSM-5 catalysts were examined by a TPD method to clarify the extraordinary selectivity of HC-SCR using methane on Ga-ZSM-5. It was observed that Ga-ZSM-5 did not adsorb oxygen but adsorbed methane dissociatively, while on Cu-ZSM-5 oxygen was dissociatively adsorbed and reacted with adsorbed ethylene.     

Ring hydrogenation of naphthalene and 1-naphthol over supported metal catalysts in supercritical carbon dioxide solvent

Catalytic ring hydrogenations of naphthalene and 1-naphthol were studied over several supported metal catalysts in supercritical carbon dioxide solvent at low temperature. Higher concentration of hydrogen in supercritical carbon dioxide and lower reaction temperature were responsible for higher catalyst activity and selectivities to the desired partial ring hydrogenated products as compared with those observed in organic solvent for the same catalyst.     

Studies on the nuclear magnetic resonance spectra of olefinic protons of conjugated fatty acid methyl esters

The NMR spectra of olefinic protons in the four representative conjugated fatty acid methyl esters, methylcis-9,trans-11-octadecadienoate, methyltrans-9,trans-11-octadecadienoate, methyl α eleostearate, and methyl β eleostearate, were studied. The chemical shift of each olefinic proton in these compounds was determined by considering their intramolecular environment. Coupling constants were also obtained as the results of spectral analysis.     

Role of Acetic Acid Added to the Reaction Media for the Enantio-differentiating Hydrogenation of Methyl Acetoacetate Over a Tartaric Acid-modified Nickel Catalyst

The role of acetic acid added to the reaction media for the enantio-differentiating hydrogenation of methyl acetoacetate over a (R,R)-tartaric acid-in-situ-modified nickel catalyst was studied from the viewpoint of the hydrogenation rate during repeated runs. The hydrogenation of methyl acetoacetate on the “enantio-differentiating sites” of a tartaric acid-modified nickel catalyst was specifically accelerated by the acetic acid added to the reaction media to increase the enantio-differentiating ability of the catalyst. In order to increase the enantio-differentiating ability, the addition of acetic acid to the reaction media was required in each run during the repeated use of the catalyst.     

Large macro-dipoles generated in a supramolecular polymer of N,N′,N″-tris(3,7-dimethyloctyl)benzene-1,3,5-tricarboxamide in n-decane

A supramolecular polymer formed by N,N′,N″-tris(3,7-dimethyloctyl)benzene-1,3,5-tricarboxamide (DO₃B) in n-decane (C₁₀) possesses large macro-dipoles naturally generated by three-fold inter-molecular hydrogen bonding aligned along its helical columnar structure connected by defective portions, which are DO₃B molecules containing failure in the hydrogen bond formation, in the order of head to tail arrangement without dipole inversion like type-A polymers.     

Investigation of the effect of surface phosphate ester dispersant on viscosity by coarse-grain modeling of BaTiO slurry

To understand the role of phosphate ester dispersant, we investigated the rheology of a BaTiO slurry. For the model case, a coarse-grain molecular dynamics (CGMD) simulation was performed with the butyral polymer didodecyl hydrogen phosphate (DHP) in the toluene/ethanol solvent. By systematically analyzing the effect of DHP from an atomic-scale first principle and from all-atom MD to microscale CGMD simulation, we investigated how the adsorption of a DHP dispersant on a BaTiO surface affects the microstructure rheology of a BaTiO slurry. The first-principle and all-atom MD simulation suggests that DHP molecules prefer to locate near the BaTiO surface. CGMD simulation shows a reduction in viscosity with an increase in dispersants, suggesting that the dispersant population near the BaTiO surface plays a key role in controlling the rheology of the BaTiO slurry. In this study, we propose an approach for understanding the BaTiO slurry with molecular-level simulations, which would be a useful tool for efficient optimization of slurry preparation.     

Investigation of CH4 Reforming with CO2 on Meso-Porous Al2O3-Supported Ni Catalyst

Meso-porous Al₂O₃-supported Ni catalysts exhibited the highest activity, stability and excellent coke-resistance ability for CH₄ reforming with CO₂ among several oxide-supported Ni catalysts (meso-porous Al₂O₃ (Yas1-2, Yas3-8), -Al₂O₃, -Al₂O₃, SiO₂, MgO, La₂O₃, CeO₂ and ZrO₂). The properties of deposited carbons depended on the properties of the supports, and on the meso-porous Al₂O₃-supported Ni catalyst, only the intermediate carbon of the reforming reaction formed. XRD and H₂-TPR analysis found that mainly spinel NiAl₂O₄ formed in meso-porous Al₂O₃ and -Al₂O₃-supported catalysts, while only NiO was detected in -Al₂O₃, SiO₂, CeO₂, La₂O₃ and ZrO₂ supports. The strong interaction between Ni and meso-porous Al₂O₃ improved the dispersion of Ni, retarded its sintering and improved the activated adsorption of CO₂. The coking reaction via CH₄ temperature-programed decomposition indicated that meso-porous Al₂O₃-supported Ni catalysts were less active for carbon formation by CH₄ decomposition than Ni/-Al₂O₃ and Ni/-Al₂O₃.