Electrolyte/Structure?Dependent Cocktail Mediation Enabling High?Rate/Low?Plateau Metal Sulfide Anodes for Sodium Storage

As promising anodes for sodium-ion batteries, metal sulfides ubiquitously suffer from low-rate and high-plateau issues, greatly hindering their application in f...     

条带开采煤柱支承压力与塑性区分布规律研究

为了对条带开采煤柱支承压力与塑性区分布规律进行研究,采用理论分析、数值模拟及现场监测的方法,通过考虑采空区上覆煤岩体成拱效应,确定出煤柱支承压力分布情况。结合煤柱支承压力分布情况,根据玉华煤矿工程条件,采用ANSYS15.0软件模拟计算不同采空区宽度(100～260 m)、不同工作面埋深(400～600 m)的煤柱最大塑性区宽度,并对玉华煤矿2410工作面回风巷道护巷煤柱的最大塑性区进行监测。研究结果表明：依据所提出的煤柱支承压力计算方法,模拟计算出的煤柱最大塑性区宽度和现场监测结果一致。给出了确定煤柱支承压力分布的计算方法,以及依据该方法计算出的煤柱最大塑性区分布规律,可为煤柱留设宽度设计提供依据。     

新元矿松软煤层回采巷道支护方案与应用

为保障新元矿9105工作面进风顺槽大断面松软煤层巷道围岩的稳定,基于巷道围岩变形机理及松软煤层大断面巷道支护原则,进行顶底板及两帮锚杆索各项支护参数设计,并在支护方案实施后进行围岩变形监测.结果表明:支护方案实施后,巷道掘进及工作面回采期间,围岩变形量均较小,保障了巷道围岩稳定,满足回采使用要求.     

Accurate rotor flux orientation technique for indirect rotor flux oriented control of induction motor drives

Abstract

In this paper, a novel detuning index is first proposed for indicating the proper timing required to correct the rotor time constant of indirect rotor flux oriented controlled single‐cage induction motor drives. This index can faithfully reflect the influence of rotor resistance changes as well as rotor flux changes. It also reduces greatly the number of rotor time constant estimations in practical applications. The theoretical basis of the index and the physical meaning are described in the paper in detail. Based on the proposed index, an on‐line rotor time constant estimator is also proposed to make corrections. Only existing available quantities of the closed loop controller are used for calculating the estimated rotor time constant accurately. Both simulation and experimental results verify the effectiveness of the proposed rotor flux orientation technique. It is seen that the proposed rotor flux orientation technique is suitable for practical applications.     

特高压直流换流站消防系统分析

特高压换流站作为国家电力系统重点单位,消防系统对保证电力设备的安全运行极为重要。本文以金华换流站消防系统为例,介绍了换流站消防系统的组成、功能以及与其他相关系统的联动关系,重点分析了阀厅火灾报警跳闸系统,具有十分重要的现实意义。     

A Method to Reduce Sampling Rate of the ADC in Feedback Channel for Wideband Digital Predistortion

This paper presents a new digital predistortion (DPD) solution for wideband signals with low feedback sampling rate. To reduce the minimum sampling rate of the analog-to-digital converter (ADC) for wideband digital predistortion, the proposed method uses a bandpass filter to form a narrowband signal before the ADC. Then, a deconvolution operation is performed to recover the original wideband signal from the ADC samples. The proposed method is evaluated with an international mobile telecommunication-advanced signal with 100 MHz bandwidth. The simulation results show that the recovered signal of the proposed method closely approximates to the original signal in the passband of the filter, and the mean square error of the deconvolution decreases as the signal-to-noise ratio increases. The proposed algorithm can reduce the sampling rate of the ADC from 1105.92 million samples per second (MSPS) to 368.64 MSPS, and improve the adjacent channel power ratio more than 20 dB, which is merely 5.6 dB less than the conventional DPD with 1105.92 MSPS sampling rate.     

不同粘结剂对碳纳米管红外吸收涂层性能的影响

碳纳米管涂层已在低温工作环境中大量应用,所选用的粘结剂在很大程度上影响其红外吸收性能及与基体的结合性能。分别用水玻璃粘结剂和磷酸盐粘结剂与碳纳米管、镍粉混合制成涂料,并将其涂覆在铜基体表面。采用XRD和SEM对涂层的红外吸收性能、物相、晶体结构及形貌进行了表征;测试了涂层的抗热震性能。结果表明:当粘结剂为磷酸盐、含量为90%~85%时,1 400~3 570 cm~(-1)(2.80~7.14μm)波段内涂层的平均光吸收度达1.992~2.084,红外吸收性能最佳,抗热震次数可达35次(25~120℃),满足了用户要求(10次)。