Influence of initial growth layer and Ti underlayer on magneticproperties and recording characteristics of very thin films ofevaporated Co-Cr media

A Co-Cr film deposited directly on a substrate has an initial growth layer with low coercivity. However, the existence of a Ti underlayer prevents the formation of such a layer. As a result, Co-Cr film deposited on a Ti underlayer has high perpendicular anisotropy and coercivity even in cases of extremely thin film thickness (200 Å). As for the read-write characteristics of Co-Cr thin-film media, the existence of such an initial growth layer greatly improves the reproduced output level. The cause for this is considered to be that the free charges which appear on the back surface of the perpendicular recording layer are reduced and the demagnetization field acting on the recorded magnetization subsequently decreases due to the existence of the initial growth layer     

Near-resonance oscillations of a nonsymmetric nonlinear system with a crack

The Malkin method, which was developed to construct a single unique resonance solution of nonlinear equations, is generalized for the case of the derivation of all stationary solutions in the near-resonance zone, and also for transient oscillations.Kiev Polytechnic Institute. Translated from Problemy Prochnosti, No. 10, pp. 108–112, October, 1989.     

The solution of the inverse problem of gravitational potential using a set of measurements of different field elements

A numerical solution of the inverse problem of the gravitational field at a single point is obtained using six field elements for a point, a spherical cap, a differential spherical sector and a vertical segment. In the system of six equations obtained, the unknowns are the mass of the body, the depth of its center, and the second, third, and fourth degree moments. The accuracy of the solution of this system is ten times higher than when using three field elements. __________ Translated from Izmeritel’naya Tekhnika, No. 5, pp. 3–8, May, 2007.     

On the stabilizing behavior of zirconia: A Combined experimental and theoretical study

Reactive zirconia powder was synthesized by the complexation of zirconium metal from zirconium hydroxide using a solution of 8-hydroxiquinoline. The kinetics of zirconia crystallization was followed by X-ray diffraction, scanning electron microscopy and surface area measured by the nitrogen adsorption/desorption technique. The results indicated that zirconia with a surface area as high as 100 m²/g can be obtained by this method after calcination at 500°C. Zirconia presents three polymorphic phases (monoclinic, tetragonal and cubic), which are reversibly interconversible. The cluster model Zr₄O₈ and Zr₄O₇ ⁺² was used for a theoretical study of the stabilization process. The ab initio RHF method was employed with the Gaussian94 program and the total energies and the energy gap of the different phases were calculated and compared with the experimental energy gap. The theoretical results show good reproducibility of the energy gap for zirconia.     

Fine Purification of Monoisotopic Silanes 28SiH4 , 29SiH4 , and 30SiH4 via Distillation

High-purity isotopically enriched (99.98% ²⁸Si, 99.57% ²⁹Si, and 99.83% ³⁰Si) silane samples are prepared for the first time. The total hydrocarbon content of the samples is no higher than 0.1–0.3 ppm. The concentration of electroactive impurities in the silicon prepared from the purified monoisotopic silane is below 10¹⁵ cm^–3.     

Investigation of Metallic and Ceramic Materials by Small-Angle Neutron Scattering

Small-angle neutron scattering measurements on a double-crystal spectrometer with perfect monochromator and analyzer crystals were used to follow microstructural changes in the aluminum alloy VD-17, refractory alloy ZhS-6, and dispersion-hardened zirconia-based ceramics with yttria additions. The measurements were carried out by the Warren method, involving determination of the small-angle neutron attenuation coefficient. The experimentally determined total macroscopic small-angle scattering cross section is correlated with different parameters characterizing external influences on the material: the number of loading cycles, heat-treatment temperature, and fracture stress. The potential of the proposed approach for optimizing processing technologies is discussed.     

On the role of high-energy electrons in the formation of a plasma-beam discharge structure in a diode with a slit cathode

The spatial structure of visible emission from plasma of a transverse nanosecond pulsed electric discharge in a gas-filled diode with a hollow (slit) cathode has been experimentally studied. A relation is established between the regime of electron energy relaxation and the plasma-beam discharge structure formation. High values of the electron emission coefficient are observed in the experiment, which cannot be explained using the notion of electron emission from a cathode bombarded by fast heavy particles.