C5: A Step Towards Smart World with Enhanced Holistic Wellbeing

Wireless Personal Communications - Internet of things (IoTs) has been the smartest technology proven worldwide these days. The application products of IoTs are Mobile ad hoc network (MANET) and...     

SAR CHARACTERIZATION OF FOCUSED PLANAR ARRAY OF WATER-LOADED MODIFIED BOX-HORNS FOR HYPERTHERMIA

A 4×4 planar array of modified box-horns as a microwave hyperthermia applicator is theoretically studied to characterize power deposition (SAR) in heating tissue (muscle) at 2450 MHz. A modified box-horn is a novel improved version of conventional box-horn in which horn exciting the box waveguide is flared in both E-and H-planes. Modified box-horn supports TE₁₀ and TE₃₀ modes. The amplitude distribution over the H-plane of the box-horn aperture is a closer approximation to the uniform distribution. It is proposed that the interior of the box-horn be filled with water to provide a better impedance match to biological tissue. By applying Fresnel-Kirchhoff scalar diffraction field theory, the expression for electric field in heating region is derived and distribution of specific absorption rate (SAR) in that region due to planar array of modified box-horns as direct contact applicator is evaluated at 2450 MHz. The results of modified box-horn array are compared with those of a single modified box-horn operating at the same frequency. Results demonstrate that planar array of modified box-horns offers improvement in SAR distribution and penetration depth. It is shown that by changing the phase and amplitude of excitation of the modified box-horns of the array, the relative amplitude and position of the hot spot can be changed. The present analysis is validated through the results obtained by plane wave spectral technique.     

Unambiguously Enhanced Ultraviolet Luminescence of AlGaN Wavy Quantum Well Structures Grown on Large Misoriented Sapphire Substrate

High‐quality epitaxy consisting of Al_1?xGa_xN/Al_1?yGayN multiple quantum wells (MQWs) with sharp interfaces and emitting at ≈280 nm is successfully grown on sapphire with a misorientation angle as large as 4°. Wavy MQWs are observed due to step bunching formed at the step edges. A thicker QW width accompanied by a greater accumulation of gallium near the macrostep edge than that on the flat‐terrace is observed on 4° misoriented sapphire, leading to the generation of potential minima with respect to their neighboring QWs. Consequently, a significantly enhanced photoluminescence intensity (at least ten times higher), improved internal quantum efficiency (six times higher at low excitation laser power), and a much longer carrier lifetime are achieved. Importantly, the wafer‐level output‐power of the ultraviolet light emitting diodes on 4° misoriented substrate is nearly increased by 2–3 times. This gain is attributed to the introduction of compositional inhomogeneities in AlGaN alloys induced by gallium accumulation at the step‐bunched region thus forming a lateral potential well for carrier localization. The experimental results are further confirmed by a numerical modeling in which a 3D carrier confinement mechanism is proposed. Herein, the compositional modulation in active region arising from the substrate misorientation provides a promising approach in the pursuit of high‐efficient ultraviolet emitters.     

C60 Concentration Influence on MEH-PPV:C60 Bulk Heterojunction-Based Schottky Devices

We have investigated the effect of C60 concentration on the performance of poly[2-methoxy-5-(2′-ethylhexoxy-p-phenylene vinylene] (MEH-PPV):C60 blend-based Schottky barrier-based devices. Incorporation of C60 in MEH-PPV leads to a red shift and the reduction of intensity in MEH-PPV absorption spectra. The appearance of a C60 characteristic band in the Raman spectra of the composites indicates the presence of C60 in the blends. A FESEM study reveals that the addition of C60 significantly modifies the surface morphology of the blend films. However, higher concentrations (>?5 wt.%) results in agglomeration of C60 particles. Dark I–V measurements allow us to extract various diode parameters including barrier height, ideality factor, and saturation current. Profound variations have been observed in the dominant charge carrier transport mechanism for different C60 concentrations. A photoresponse study demonstrates the enhancement in the photocurrent with the increase in the C60 concentration up to 5 wt.%. Beyond this concentration, agglomeration impedes exciton dissociation and charge transport, which results in a decrease in the photocurrent. Finally, an impedance spectroscopy analysis has been extensively carried out to estimate the internal device parameters, such as junction resistance, capacitance and carrier lifetime. The correlation between these parameters and I–V curves has been established.     

Accurate and Scalable Simulation of Network of Heterogeneous Sensor Devices

Simulation is an important tool to study and analyze sensor networks. Prior work in sensor network simulation focuses on homogeneous devices. In this paper, we present a system that performs scalable and accurate simulation of a network of heterogeneous sensor devices, including both Stargate intermediate level devices and mote devices. We study accuracy, performance, and scalability of our system. The results show that we can achieve accurate functional behavior for both standalone Stargate simulation and ensemble simulation of a Stargate and motes. For motes, we have less than 4.06% cycle count error for all benchmarks and for Stargate, we have less than 10% error for most benchmarks, and less than 12.5% error for all benchmarks. We also achieve less than 3.6% error for all benchmarks when simulating an ensemble of Stargate and motes. Our system is also more scalable than prior work. We can simulate 160 sensor nodes in real time speed and 2,048 sensor nodes with ten times slowdown on a 16-node cluster.

Four-point probe characterization of 4H silicon carbide

We report on four-point probe measurements on SiC wafers as such measurements give erratic data. Current-voltage measurements on n-type SiC wafers doped to 3 × 10¹⁸ cm⁻³ are non-linear and single probe I-V measurements are symmetrical for positive and negative voltages. For comparison, similar measurements of p-type Si doped to 5 × 10¹⁴ cm⁻³ gave linear I-V, well-defined sheet resistance and the single probe I-V curves were asymmetrical indicating typical Schottky diode behavior. We believe that the reason for the non-linearity in four-point probe measurements on SiC is the high contact resistance. Calculations predict the contact resistance of SiC to be approximately 10¹² Ω which is of the order of the input resistance of the voltmeter in our four-point probe measurements. There was almost no change in two-probe I-V curves when the spacing between the probes was changed from 1 mm to 2 cm, further supporting the idea that the I-V characteristics are dominated by the contact resistance.     

Nonmonotonic Coupled Dissolution-Precipitation Reactions at the Mineral–Water Interface

Dissolution is inherent to fluid-mineral systems. Yet its impact on minerals reacting with electrolytes is overlooked. Here, a novel nonmonotonic behavior for the surface interactions of carbonates (calcite and Mg-calcite) with organic acids is reported. Applying a bioinspired approach, Mg-calcite sensors via amorphous precursors, avoiding any preconditioning with functional groups are synthesized. A quartz crystal microbalance is used to study the mass changes of the mineral on contact with organic acids under varying ionic conditions, temperatures, and flow velocities. Supported by confocal Raman microscopy and potentiometric titrations, nonmonotonous mass developments are found as a function of Ca²⁺ concentration and flowrate, and attributed to three coupled chemical reactions: i) carbonate dissolution via Ca²⁺ ion complexation with organic molecules, and the formation of organo-calcium compounds as ii) a surface phase at the mineral–water interface, and iii) particles in the bulk fluid. These processes depend on local ion contents and the precipitation onset (i.e., saturation index) of organo-calcium salts, both of which substantially differ in the bulk fluid and in the fluid boundary layer at mineral interfaces. This continuum between dissolution and precipitation provides a conceptual framework to address reactions at mineral interfacial across disciplines including biomineralization, ocean acidification and reservoir geochemistry.     

A novel approach for coefficient quantization of low-pass finite impulse response filter using differential evolution algorithm

Evolutionary computational techniques have been employed judiciously in various signal processing applications of late. In this paper, such an attempt has been made to design a low-pass linear-phase multiplier-less finite duration impulse response (FIR) filter using differential evolution (DE) algorithm. This particular evolutionary optimization technique has been explored to search the impulse response coefficients of the FIR filter in the form of sum of power of two (SPT) in order to avoid the multipliers during design process. The performance of the designed low-pass filter has been studied thoroughly in terms of its frequency characteristics and primitive requirement of fundamental hardware blocks. The superiority of our design has been ascertained over a number of existing techniques by various means. Finally, the proposed filter of different lengths has been implemented on a field programmable gate array (FPGA) chip for evaluating the competency of this work. The percentage improvement in hardware complexity produced by our design has also been computed and clearly listed in this paper for convenience.     

Efficient design of bio-basis function to predict protein functional sites using kernel-based classifiers

In order to apply the powerful kernel-based pattern recognition algorithms such as support vector machines to predict functional sites in proteins, amino acids need encoding prior to input. In this regard, a new string kernel function, termed as the modified bio-basis function, is proposed that maps a nonnumerical sequence space to a numerical feature space. The proposed string kernel function is developed based on the conventional bio-basis function and needs a bio-basis string as a support like conventional kernel function. The concept of zone of influence of a bio-basis string is introduced in the proposed kernel function to take into account the influence of each bio-basis string in nonnumerical sequence space. An efficient method is described to select a set of bio-basis strings for the proposed kernel function, integrating the Fisher ratio and a novel concept of degree of resemblance. The integration enables the method to select a reduced set of relevant and nonredundant bio-basis strings.     

Variation in the volatile terpenoids of two industrially important basil (Ocimum basilicum L.) cultivars during plant ontogeny in two different cropping seasons from India

BACKGROUND: Two Ocimum basilicum cultivars, ‘Vikarsudha’ and ‘CIM‐Saumya’, grown in the Kumaon region of western Himalaya were evaluated for their essential oil yield and composition at different stages of plant growth during two distinct cropping seasons (spring–summer and rain–autumn). RESULTS: The highest yield of essential oil was obtained at full bloom stage in both cultivars in both cropping seasons. The essential oils obtained from different stages in two cropping seasons were analysed by capillary gas chromatography with flame ionisation detection, and gas chromatography–mass spectrometry. The major component of cultivar ‘Vikarsudha’ was methyl chavicol (84.3–94.3%), while for cultivar ‘CIM‐Saumya’ the main components were methyl chavicol (62.5–77.6%) and linalool (14.4–34.1%). CONCLUSION: This study clearly indicated that cultivar, cropping season, plant ontogeny and plant part had significant effects on the yield and quality of the essential oil of O. basilicum. Further, the amount of methyl chavicol in the cultivars grown in this region was higher than in cultivars from other parts of India. Copyright © 2011 Society of Chemical Industry