A comparison of theoretical and empirical reflection coefficientsfor typical exterior wall surfaces in a mobile radio environment

This paper presents microwave reflection coefficient measurements at 1.9 GHz and 4.0 GHz for a variety of typical smooth and rough exterior building surfaces. The measured test surfaces include walls composed of limestone blocks, glass, and brick. Reflection coefficients were measured by resolving individual reflected signal components temporally and spatially, using a spread-spectrum sliding correlation system with directional antennas. Measured reflection coefficients are compared to theoretical Fresnel reflection coefficients, applying Gaussian rough surface scattering corrections where applicable. Comparisons of theoretical calculations and measured test cases reveal that Fresnel reflection coefficients adequately predict the reflective properties of the glass and brick wall surfaces. The rough limestone block wall reflection measurements are shown to be bounded by the predictions using the Fresnel reflection coefficients for a smooth surface and the modified reflection coefficients using the Gaussian rough surface correction factors. A simple, but effective, reflection model for rough surfaces is proposed, which is in good agreement with propagation measurements at 1.9 GHz and 4 GHz for both vertical and horizontal antenna polarizations. These reflection coefficient models can be directly applied to the estimation of multipath signal strength in ray tracing algorithms for propagation prediction     

Characterization of spherically focused transducers using an ultrasonic measurement model approach

A new and computationally efficient method is developed for characterizing a spherically focused, ultrasonic transducer (and its accompanying test system). Procedures for determining the probe's effective radius, effective focal length, and system efficiency factor are described. Predicted responses that make use of these effective parameters are shown to correspond very well to measured responses for a number of different transducers.     

Beam test of the CsI(Tl) calorimeter for the BELLE detector at the KEK-B factory

We studied the performance of a prototype electromagnetic calorimeter for the BELLE detector at the KEK proton synchrotron for an energy range of 0.25–3.5 GeV. The prototype consisted of an array of 6 × 5 CsI(Tl) crystals with 30 cm length (16.2 radiation lengths) and about 6 cm × 6 cm cross section. The scintillation light of each CsI(Tl) crystal was read out by two large-area PIN photodiodes and charge-sensitive preamplifiers attached at the rear face of the crystal. We measured the energy and position resolution for electrons and the e/π separation for two sets of matrix configurations: one corresponded to the center and the other to the edge of the barrel calorimeter. The overall performance measured by the test proves that the prototype calorimeter is satisfactory for the use in the BELLE detector.     

High performance CMOS current comparator

A new high-speed CMOS current comparator is described. By changing the buffer of an existing comparator from class B to class AB operation, voltage swings are reduced, resulting in greater speed for small input currents. Simulation results employing a 1.6μm CMOS technology show the response time to a 0.1μA input current to be 11ns and the power dissipation to be 1.4mW, resulting in a five times improvement in speed/power ratio over existing high-speed current comparators     

Effect of glutamine on protein synthesis in isolated intestinal epithelial cells

The purpose of this study was to determine the etiologic factors of denture stomatitis. Fifteen subjects with clinical evidence of localized simple denture stomatitis, fifteen subjects without clinical signs of denture stomatitis, and forty-five subjects with clinical evidence of generalized simple denture stomatitis were investigated clinically and mycologically. Subjects were evaluated according to age, sex, duration of denture usage, smoking habits, frequency of denture brushing, overnight denture wearing, pH level of saliva and degree of candidal colonization and candidal formation. Salivary samples and swabs were taken from the palate and the mucosal surfaces of the dentures investigated mycologically in order to identify the yeast colonies. Smears were taken from the palate and investigated in order to identify candidal formation. No statistically significant relationship was found between denture stomatitis and age, sex, duration of denture usage, frequency of denture brushing, overnight denture wearing or pH level of saliva. There was however, a statistically significant relationship between denture stomatitis and denture hygiene, smoking habits, candidal colonization and candidal formation.     

Crystal structures of Escherichia coli and Salmonella typhimurium 3-isopropylmalate dehydrogenase and comparison with their thermophilic counterpart from Thermus thermophilus

The basis of protein stability has been investigated by the structural comparison of themophilic enzymes with their mesophilic counterparts. A number of characteristics have been found that can contribute to the stabilization of thermophilic proteins, but no one is uniquely capable of imparting thermostability. The crystal structure of 3-isopropylmalate dehydrogenase (IPMDH) from the mesophiles Escherichia coli and Salmonella typhimurium have been determined by the method of molecular replacement using the known structure of the homologous Thermus thermophilus enzyme. The structure of the E. coli enzyme was refined at a resolution of 2.1 A to an R-factor of 17.3%, that of the S. typhimurium enzyme at 1.7 A resolution to an R-factor of 19.8%. The three structures were compared to elucidate the basis of the higher thermostability of the T. thermophilus enzyme. A mutant that created a cavity in the hydrophobic core of the thermophilic enzyme was designed to investigate the importance of packing density for thermostability. The structure of this mutant was analyzed. The main stabilizing features in the thermophilic enzyme are an increased number of salt bridges, additional hydrogen bonds, a proportionately larger and more hydrophobic subunit interface, shortened N and C termini and a larger number of proline residues. The mutation in the hydrophobic core of T. thermophilus IPMDH resulted in a cavity of 32 A3, but no significant effect on the activity and thermostability of the mutant was observed.