Cyberbullying,cyber aggression and their impact on the victim – The teacher

This paper focuses on the results of the national research of cyberbullying of Czech teachers, which was realized in year 2016 in the entire Czech Republic. The research focused on impact of cyberbullying on teachers – especially in emotional, physiological and behavioural area. The research involved a total of 5136 primary and secondary school teachers from all regions of the Czech Republic. The research has shown that a fifth of respondents (21.73%) has experienced a cyber-attack on their person, however cyberbullying during the last 12 months lasting over 1 week was confirmed only by 3.52% of the total number of respondents.     

Dispersion characteristics of asymmetric coupled anisotropic dielectric waveguides using FDFD

The formulation is developed in the frequency domain and the finite difference method is used for the numerical solution of the scalar wave equation, written in terms of the transverse components of the magnetic field. As a result a conventional eigenvalue problem is obtained without the presence of spurious modes due to the implicit inclusion of the divergence of the magnetic field equal to zero. The formulation is developed to include biaxial anisotropic dielectrics with an index profile varying arbitrarily in the cross section of the waveguide under analysis. This formulation is then applied to the analysis of the influence on the dispersion characteristics of the dimensions of asymmetric coupled rectangular uniaxial anisotropic dielectric waveguides. As expected, the reduction of the height or the width of one of the rectangular dielectric waveguides causes the dispersion curves to move towards higher frequencies.     

Transformation champ proche — champ lointain bidimensionnelle et monodimensionnelle appliquée à des mesures de SER

In high frequency thercs measurement of large target must be done at important distances, so the distance of measurement (Fraunhofer’s distance) R is given by R ≥ 2d² /λ where d is the tranversal length of the target and λ the radiation wavelength. In this paper we present a method for target that are large relative to the curvature of the spherical wavefront and the curvature of the cylindrical wavefront. A two-dimensional analytical algorithm transforms the spherical wave (near-field) measurement into the desired plane wave (far-field) and a one-dimensionnal analytical algorithm transforms the cylindrical wave (near-field) measurement into the desired plane wave (far-field). We present some results on simulations and measurements. A comparison of one-dimensional and two-dimensional methods demonstrates the efficiency of the two dimensional methods.     

Micro-emboli detection: an ultrasound Doppler signal processing viewpoint

Several studies have been carried out in the last twenty years on the characterization and detection of cerebral artery emboli. From the detection point of view, the existing methods are largely based on the classical Fourier analysis of which the well known limitations provide poor accuracy. This paper first recalls existing methods based on Fourier, Wigner-Ville and wavelet approaches. It then presents new emboli detection methods based on parametric signal processing approaches. The basic idea of these parametric methods is to compare the Doppler embolic signal to its autoregressive model. The detection principle consists in constructing a decision information which contains the signature of the micro-embolus being sought. The detection is finally evaluated using receiver operating characteristic (ROC) curves. Comparison between the new methods and classical approaches is performed using a realistic embolic signal simulation. Furthermore, to validate our theoretical study, we tested our new algorithms using in vivo signals. This comparison shows the significant inaccuracy of existing methods to detect micro-emboli.     

Effects of electrical and mechanical stunning methods on meat quality in ostriches

The effect of electrical and captive needle air pressure stunning methods on some meat quality parameters was examined in ostriches under practical conditions. One hundred and fifteen ostriches were used in three experiments. The ostriches were stunned either electrically (head only) or by using a captive needle with air pressure. In the first experiment the ostriches were stunned at 90 V (～effectively 52 V), 200 V and by captive needle using air pressure. In the second experiment voltages of 175 and 200 V were applied and a captive needle stunning method using air pressure. In the third experiment the birds were stunned at 175 V with a short stun/stick interval. Experiments 2 and 3 were performed in a different slaughterhouse from experiment 1. Meat quality was assessed by measuring the pH, temperature and colour at 45 min and 18 h post mortem and by determining water binding capacity and haemorrhage score at 18 h post mortem in the big drum, tender loin and triangular filet muscles. The measured stunning parameters in the first experiment were 204±96 mA (～52 V) during 11±1 s and 556±85 mA (～200 V) during 6±0 s. The stun/stick interval was 136±38 s. The rigor mortis value in the tender loin and both pH(1) and pH(2) in the big drum, tender loin and triangular filet muscles were (p<0.05) lower when stunned with air pressure compared with electrical stunning. Moreover internal light scattering remained higher. The measured currents in the second experiment were 561±226 mA (～173 V) during 6±2 s and 518±120 mA (～200 V) during 6 s. The stun/stick interval was 39±12 s. The pH at 45 min and 18 h differed (p<0.05) in the tender loin and triangular filet muscles as did the temperature at 45 min in the three muscles between the different stunning groups. The stunning in the third experiment was carried out with 548±180 mA during 6±2 s. The stun/stick interval was 5±2 s. After the short stun/stick interval the pH(2) was lower (p<0.05) for the tender loin and triangular filet muscles and the wetness of the filter paper of the big drum was (p<0.05) lower compared with the other groups. Our experiments showed that stunning methods affected several meat quality parameters. Using a high electrical stunning current, captive needle stunning or a short stun/stick interval may positively affect some parameters. More research is necessary to examine effects of pre slaughter handling on meat quality.     

Dispersion in finlines on semiconductor and the S-parameters of a step discontinuity

The Transverse Transmission Line method is used for the characterization of bilateral and unilateral finlines on a semiconductor substrate and in conjunction with the modal method, for the calculation of the scattering parameters due to a step discontinuity on a unilateral finline with a lossless dielectric substrate. Numerical results of the effective dielectric constant, attenuation constant and characteristic impedance for the bilateral and unilateral finlines on semiconductor substrates, and results of scattering parameters of a step discontinuity for unilateral finline, are presented.     

基于可调谐式RS-POTDR实现已安装光纤累积PMD分布的测量

本文描述了一种新的偏振敏感OTDR方法,其非常适用于对已安装的光纤链路(可包含多种不同单模光纤类型)的累积PMD进行定量分布测量.通过这种方法,可以确定PMD较高的光纤区域,并且可以在必要的情况下替换该区域光纤,从而以经济有效的方法降低链路PMD.     

Sur l’utilisation des équations intégrales en régime transitoire dans les problèmes d’électromagnétisme

It is possible in many cases by using space-time integral equations to compute the scattering and penetration of electromagnetic fields via explicit time-stepping diagrams. The case of conducting surfaces, thin scatterers, apertures and shieldings of finite conductivity are discussed with emphasis on the simplicity and the validity domain of the relevant equations. Examples concern the field of a far-located dipole incident on a cylinder with infinite conductivity, with an aperture or with resistive walls.     

A Multi-user Receiver for Inter-Cell Interference Reduction in LTE PUCCH Signaling

In 3rd generation partnership project (3GPP) long term evolution (LTE) systems, when no resources has been assigned in the uplink to a given user equipment (UE), the control information associated with layers 1 and 2 in the protocol stack is conveyed back to the base station through the so-called physical uplink control channel (PUCCH). In PUCCH, the data streams transmitted by multiple UEs are multiplexed in the time-domain and in the frequency-domain with the aid of spreading codes. Although the spreading codes associated with UEs within the same cell can be assumed to be orthogonal, the presence of inter-cell interference (ICI) in multi-cell scenarios severely limits receiver performance. In particular, the Format 1 of PUCCH, which is associated with the transmission of hybrid automatic repeat request acknowledgements (ACK/NACK) and scheduling requests, has a major impact on system performance, since an incorrectly decoded ACK/NACK message may introduce significant delay in data transmission. In this contribution, we propose a new multi-user receiver for ICI reduction in PUCCH LTE that operates both in cooperative and non-cooperative multi-cell architectures. The proposed receiver relies on a constrained tensor modeling of the received signal in PUCCH signaling, and affords an iterative joint channel estimation and symbol detection by simultaneously exploiting the energy of the data symbols and the pilot tones present in PUCCH. The formulation of the proposed algebraic receiver model incorporates symbol-basis hopping and slot-basis hopping signaling schemes, which are interference randomization techniques existing in the 3GPP specifications of LTE system. Computer simulation results show the remarkable performance gains of the proposed receiver compared to the conventional time-frequency decorrelator based receiver.