Results of initial surgery and adjuvant chemotherapy in treating small-cell lung cancer

The changes in the intestinal mucosal permeability were observed by quantitatively assessing plasma to luminal clearance of 99mTc-labeled DTPA, and the influence of platelet activating factor (PAF) on it was investigated. The results showed that intestinal permeability was significantly elevated after severe burn and was positively correlated with increase in PAF in the intestinal tissue (r = 0.94, P < 0.01). PAF antagonist therapy could significantly attenuate postburn intestinal mucosal permeability. It is concluded that PAF is one of the important factors causing increased intestinal permeability after severe burn.     

A circular reflector interferometer for the far infrared

The construction of a Fourier transform spectrometer to study magnetic resonances in solids is described. The spectrometer operates in the Far Infrared (maximum frequency of 500 cm^?1) and is based on a wavefront dividing interferometer with circular geometry. To illustrate the performance, a water vapour spectrum is given.     

Nonlinearity of p-i-n photodetectors

At higher operating frequencies, the field dependence of the carrier velocity in p-i-n photodetectors generates harmonics and intermodulation products that can degrade the dynamic range of RF fiber-optic links. The authors present both a perturbational theory and measured harmonic data for a p-i-n photodiode operated at very high power densities which show that this and other detector nonlinear effects need not seriously compromise link performance. In particular, neither transit-time nor static nonlinearities in p-i-n photodiodes need limit the dynamic range of fiber-optic links operating below 5 GHz. The fact that the theoretical bandwidth of the photodiode, with all parasitic capacitance and inductance ideally removed, is 17 GHz, suggests that comparable spur-free performance should be achievable at X and Ku-band frequencies, once packaging parasitics are reduced     

A theoretical design basis for minimizing CMOS fixed taper bufferarea

This paper develops a theoretical basis for the minimization of chip area required for fixed taper buffer design. It modifies the well-known procedure for minimizing delay time in such circuits to derive a minimum number of required stages. Rather than minimize delay time, the procedure realizes a specified buffer delay time using a stage-area scale factor that minimizes the total area of the buffer. Since an integer number of tapered stages must be used while the calculations lead to noninteger results, the effects of roundoff errors are included     

Cortical implants for the blind

Arrays of stimulating electrodes can be placed in the brain itself, in the visual cortex, to bring vision to the profoundly blind. However, when designing such devices one needs to take into consideration the fact that the visual pathway maps images onto cortical structures in a complex and unpredictable way     

Jitter reduction through feedback for picosecond pulsed InGaAsPlasers

Following a comparison of picosecond-pulse generation techniques, feedback schemes are reported for the generation of picosecond pulse trains with improved jitter for both multicontact and conventional single-contact InGaAsP-InP lasers. Subpicosecond jitter is achieved for Q-switched laser sources using a novel optoelectronic feedback scheme. The use of resonant electrical feedback is shown to improve the timing jitter of gain-switched pulses by up to six times. Pulse-to-pulse timing jitter as low as 250 fs is demonstrated for a hybrid of optical and electrical feedback schemes. Limits for timing jitter in diode lasers are established for optoelectronic, electrical, and optical feedback schemes, and the key picosecond pulse generation schemes are compared in terms of timing jitter for the first time     

On the measurement of SSB noise figure using sideband cancellation

A new method for determining the single-sideband noise figure of a device from double-sideband measurements is proposed which eliminates the need for tunable filters and hence greatly reduces the complexity and cost of performing accurate noise figure measurements. This paper compares results obtained to those obtained using a traditional single-sideband measurement system with a tuneable filter and provides a full error analysis of the new technique. The method also offers considerable possibilities for future use at higher (microwave) frequencies where YIG filters and image reject mixers are not readily available     

Silicon carbide-toughened zirconia ceramics

Tetragonal zirconia polycrystalline (TZP) ceramics containing SiC reinforcement in the form of fine particles (nano-scale), particles (micro-scale), whiskers and platelets were synthesized by hot-pressing. The effects of morphology and grain size of SiC reinforcement on the strength and fracture toughness at room temperature were investigated. The addition of SiC (in whatever form) caused decreases in strength and toughness at room temperature with the exception of whisker-reinforced materials. Toughness fell off with increasing temperature, but nevertheless retained about one-half of the room-temperature value for that particular SiC reinforcement. However, the whisker- and particle-reinforced materials had higher K _lc values at high temperature than fine particle- or platelet-reinforced materials, with values in excess of 7 MPa m^1/2 at 1000 °C. The microstructure was examined for SiC whisker-reinforced/TZP materials by TEM and HREM, to examine the nature of the whisker/zirconia interface.