Time-resolved GISAXS and cryo-microscopy characterization of block copolymer membrane formation

Time-resolved grazing-incidence small-angle X-ray scattering (GISAXS) and cryo-microscopy were used for the first time to understand the pore evolution by copolymer assembly, leading to the formation of isoporous membranes with exceptional porosity and regularity. The formation of copolymer micelle strings in solution (in DMF/DOX/THF and DMF/DOX) was confirmed by cryo field emission scanning electron microscopy (cryo-FESEM) with a distance of 72 nm between centers of micelles placed in different strings. SAXS measurement of block copolymer solutions in DMF/DOX indicated hexagonal assembly with micelle-to-micelle distance of 84–87 nm for 14–20 wt% copolymer solutions. GISAXS in-plane peaks were detected, revealing order close to hexagonal. The d-spacing corresponding to the first peak in this case was 100–130 nm (lattice constant 115–150 nm) for 17 wt% copolymer solutions evaporating up to 100 s. Time-resolved cryo-FESEM showed the formation of incipient pores on the film surface after 4 s copolymer solution casting with distances between void centers of 125 nm.     

The use of (green field) biomass pretreatment liquor for fermentative butanol production and the catalytic oxidation of biobutanol

In this study, pretreatment liquor of acid-stored green and yellowish barley silage was used for fermentative acetone–butanol–ethanol (ABE) production. Further, the catalytic oxidation of biobutanol over Pt catalysts was studied to investigate the behaviour of butanol as a fuel in the combustion engine. After the hydrothermal treatment of green and yellowish barley silage followed by enzymatic hydrolysis, approximately 88% and 100% of the available sugars were recovered, respectively. Batch fermentations of pretreatment barley silage liquor, supplemented with gelatinised barley grain, showed good fermentability with total ABE concentrations of 9.0 g/L and 10.9 g/L. Butanol yields of 0.20, 0.17 and ABE yields of 0.28, 0.26 (g/g monosaccharide) were obtained, respectively. In catalytic activity measurements, the conversion of biobutanol became appreciable in the 120–140 °C range, whereas conversions greater than 95% were obtained over 200 °C. Selectivities were also high, although formation of by-products, such as butyraldehyde, was observed.     

Development and application of an automated subcatchment generator for SWMM using open data

An open source subcatchment generator program was developed for the Stormwater Management Model (SWMM) to automate tedious stages in the model construction process. The generator divides the investigated area into subcatchments using a uniform computation grid and connects the grid cells together and to the underlying stormwater network. The system was tested by applying it to two small urban catchments with different fractions of impervious surfaces in Helsinki, Finland, using mostly openly available data. The simulated discharge results were compared to measured data and to results obtained from manually built models. The proposed system significantly accelerated the setup of a SWMM modelling project, as the routing between the subcatchments as well as the subcatchment slopes and flow widths were directly derived from the computation grid. Automatically generated and manually constructed SWMM models produced discharge results that differed only slightly from each other.     

Chronic obstructive pulmonary disease in patients with end‐stage kidney disease on hemodialysis

The objectives of this study were to assess the prevalence of chronic obstructive pulmonary disease (COPD) in hemodialysis patients with spirometry and to examine the effects of fluid removal by hemodialysis on lung volumes. Patients ≥18 years at two Danish hemodialysis centers were included. Forced expiratory volume in one second (FEV₁), forced vital capacity (FVC), and FEV₁/FVC ratio were measured with spirometry before and after hemodialysis. The diagnosis of COPD was based on both the GOLD criteria and the lower limit of normal criteria. There were 372 patients in treatment at the two centers, 255 patients (69%) completed spirometry before dialysis and 242 of these (65%) repeated the test after. In the initial test, 117 subjects (46%) had airflow limitation indicative of COPD with GOLD criteria and 103 subjects (40.4%) with lower limit of normal criteria; COPD was previously diagnosed in 24 patients (9%). Mean FVC and FEV₁ decreased mildly after dialysis (FVC: 2.84 to 2.79 L, P < 0.01. FEV₁: 1.97 to 1.93 L, P < 0.01) Hemodialysis did not affect the FEV₁/FVC ratio or number of subjects with airflow limitation indicative of COPD (113 vs. 120, P = 0.324; n = 242). COPD is a frequent and underdiagnosed comorbidity in patients on chronic hemodialysis. Spirometry should be considered in all patients on dialysis in order to address dyspnea adequately. Hemodialysis induced a small fall in mean FEV₁ and FVC, which was more pronounced in patients with little or no fluid removal, but the FEV₁/FVC ratio and the number of subjects with airflow limitation indicative of COPD were not affected by dialysis.     

Effects of Different Retention Parameter Estimation Methods on the Prediction of Surface Runoff Using the SCS Curve Number Method

Quantifying different hydrological components is an initial step for sustainable water resources planning and management. One rising concern is the conflict between the environment, hydropower and agriculture mainly in lowland areas where a large share of the base flows need to be abstracted. The Soil and Water Assessment Tool (SWAT) model was used to understand the hydrological processes of the Upper Awash River Basin with the emphasis on analyzing the different options for surface runoff generation using the Soil Conservation Service (SCS) Curve Number (CN) method. In this study, SWAT was applied incorporating two methods for estimating the retention parameter (S) for the SCS-CN method. The first allowed S to vary with soil profile moisture content (SM method) and the second allowed S to vary with accumulated plant evapotranspiration (PT method). Hydrograph comparison indicated that the PT method was better in simulating peak flows while the SM method was better in simulating the low flows. While the predicted stream flow hydrographs showed an agreement between the two methods, the simulated annual water balance indicated a disagreement in quantifying the different hydrological components. After evapotranspiration, base flow was the dominant component simulated in the SM method whereas surface runoff was the foremost in the PT method simulation. The analysis indicated that care must be taken when selecting an appropriate tool for quantifying hydrologic system to be used for decision making especially for un-gauged catchments where validation of model results is not possible.     

Artificial Neural Network modeling of a hydrogen dual fueled diesel engine characteristics: An experiment approach

The rapid growth of vehicular pollution; mostly running on the diesel engine, emissions emerging are the concerns of the day. Owing to clean burn characteristics features, Hydrogen (H₂) as a fuel is the paradigm of the researcher. Extensive research presented in the literature on H₂ dual fueled diesel engine reveals, the significant role of H₂ in reducing emissions and enhancing the performance of a dual fueled diesel engine. With meager qualitative experiment data, the feasibility to develop an efficient Artificial Neural Network (ANN) model is investigated, the developed model can be utilized as a tool to investigate the H₂ dual fueled diesel engine further. In the process of developing an ANN model, engine load and H₂ flow rate are varied to register performance and emission characteristics. The creditability of the experiment is ascertained with uncertainty analysis of measurable and computed parameters. Leave-out-one method is adopted with 16 data sets; seven training algorithms are explored with eight transfer function combinations to evolve a competent ANN model. The efficacy of the developed model is adjudged with standard benchmark statistic indices. ANN model trained with Broyden, Fletcher, Goldfarb, & Shanno (BFGS) quasi-Newton backpropagation (trainbfg) stand out the best among other algorithms with regression coefficient ranging between 0.9869 and 0.9996.     

Inversion with regularization for the retrieval of tropospheric aerosol parameters from multiwavelength lidar sounding

We present an inversion algorithm for the retrieval of particle size distribution parameters, i.e., mean (effective) radius, number, surface area, and volume concentration, and complex refractive index from multiwavelength lidar data. In contrast to the classical Tikhonov method, which accepts only that solution for which the discrepancy reaches its global minimum, in our algorithm we perform the averaging of solutions in the vicinity of this minimum. This averaging stabilizes the underlying ill-posed inverse problem, particularly with respect to the retrieval of number concentration. Results show that, for typical tropospheric particles and 10% error in the optical data, the mean radius could be retrieved to better than 20% from a lidar on the basis of a Nd:YAG laser, which provides a combination of backscatter coefficients at 355, 532, and 1064 nm and extinction coefficients at 355 and 532 nm. The accuracy is improved if the lidar is also equipped with a hydrogen Raman shifter. In this case two additional backscatter coefficients at 416 and 683 nm are available. The combination of two extinction coefficients and five backscatter coefficients then allows one to retrieve not only averaged aerosol parameters but also the size distribution function. There was acceptable agreement between physical particle properties obtained from the evaluation of multiwavelength lidar data taken during the Lindenberg Aerosol Characterization Experiment in 1998 (LACE 98) and in situ data, which were taken aboard aircraft.     

Assessing road investments: accessibility changes,cost benefit and production effects

Infrastructure investment projects and programmes are generally evaluated by comparing project costs with pertinent benefits. In this paper a series of alternative national road investment programmes in Sweden are examined. Each programme is assessed in terms of expected time savings and reduced accident rates. In addition we make use of a general production function with regionally specific accessibility characteristics as arguments. With this approach, improved accessibility implies an increase of the production potential. The paper compares the value of these production effects with the value of time savings and other benefits in a standard CB-calculation. In the comparisons more than 50 alternative national investment programmes are assessed, and their degree of consistency is estimated.An earlier version of this paper was presented at the European RSA-conference in Moscow, August 1993 and has benefitted from comments during the conference. The authors are grateful for suggestions rendered by two anonymous referees. We also wish to thank R. Jonsson, G. Lindberg and L.-G. Mattsson. Supply of data and research funds from the National Road Administration is acknowledged.     

Polychlorinated naphthalenes in Swedish background air

Polychlorinated naphthalenes (PCNs) with four to eight chlorines were studied in air collected at two background stations in Sweden, one southerly and one northerly. Air was sampled with a high-volume sampler, and gas-phase adsorbents and filters were analyzed separately. The sum of TeCNs to HxCNs in the gaseous phase ranged between 1 and 10 pg/m3 with significantly higher concentrations at the southern location Hoburgen. HpCNs and OCN were below the detection limit. The highest concentrations were found in two samples from Hoburgen with the air masses coming from SW and W and during warm weather (+11 degrees C). The lowest concentration was found in a sample from the northern location Ammarn?s at cold weather (-22 degrees C) when the air came from the east. A correlation was found between logP and 1/T indicating that temperature has a larger effect than location on the concentration in the gas phase. The TeCNs constituted 50-75% in the gaseous phase. In most filter samples TeCNs and PeCNs were below the limit of quantitation. PUF samples with air trajectories from W to NE had relatively higher concentrations of late eluting TeCNs and PeCNs, while in samples with winds from SE to S the early eluting congeners dominated. Samples with early eluting congeners were mainly collected at lower temperature. TriCNs constituted the dominant homologue group both in the gaseous and particulate phase of air samples as well as in bulk deposition from a rural monitoring station south of Stockholm. The octanol-air partition coefficient described the gas/particle interaction well for samples collected at temperatures down to -8 degrees C.