Preparation of micro-patterned surfaces of Si-N-O films and their influence on adhesion behavior of endothelial cells

Microgrooves were prepared on Si(100) surface by photolithography and wet etching.Subsequently,Si-N-O films were deposited on the microgrooves by unbalanced magnetron sputtering(UBMS) and micro-patterned surfaces of Si-N-O films were obtained.The size of the micropatterns was measured by surface profilometer.The chemical composition of Si-N-O films were characterized by X-ray photoelectron spectrometry(XPS) and the wettability of the micropatterned surfaces was evaluated by contact angle measurement.The beh...     

Dynamic equivalent method of interconnected power systems with consideration of motor loads

The existing equivalent methods usually only deal with static load models and neglect the dynamic characteristics of loads such as induction motors.This paper presents a dynamic equivalent method which considers motor dynamics.At first,the clustering criterion of motor loads is given.The motors with similar dynamic characteristics are classified into one group.Then,reduction of motors in the same group is carried out.Finally,parameters of the equivalent motor are calculated and the equivalent system is thus...     

一种高效的网格资源监测算法ACTC的改进算法

资源监控是网格计算的关键组成部分。资源监控算法既要保证网格系统中资源信息高保真度又要考虑资源信息在网络传输中的负担最低。ACTC算法就是为实现以上目的而被提出,但是算法中对资源信息更新量的动态门槛值(d_threshold)计算方式不合理,有可能导致算法演变成低级的单纯依靠时间敏感机制(TSM)来发送资源更新通知,并且算法中遗漏了一些极端情况的考虑。提出了新的d_threshold计算公式和限制条件,进行性能改进和完善,并对改进前后两算法进行实验对比。实验表明,改进后算法提高了资源信息准确性,并使监控系统     

Application of open-pit and underground mining technology for residual coal of end slopes

Given the conditions of residual coal from the boundary of a flat dipping open-pit mine,which uses strip areas mining and inner dumping with slope-covering,we propose an open-pit and underground integrated mining technology for residual coal of end slopes.In the proposal a conveyance road and ventilation conveyance near the slope are built,corresponding to the pit mining area and the surface coal mine dump,as well as an interval haulage tunnel and air-inlet tunnel.The outcome shows that such mining method may reduce the effect to slope stability from underground mining,it does not affect the dumping advance and has a high recovery rate of residual coal resources.The working face is timbered by single hydraulic props,transported by a scraper conveyor and supported by coal walls.This method of mining is one of layered top coal caving,with high resource recovery,low production cost where positive economic benefit can be realized.     

Application of structural curvature of coalbed floor on CBM development in the Zaoyuan block of the southern Qinshui Basin

Based on controls of structural style and the position in coalbed methane(CBM)development,we used a method of curvatures to study its relations with CBM development parameters.We calculated structural curvatures of contours of the No.3coal seam floor of the Shanxi Formation in the Zaoyuan block of the Qinshui Basin and analyzed its relations with development parameters of coalbed methane wells.The results show that structural curvature is negatively related to coal reservoir pressure,while positively related to permeability.With an increase in structural curvature,the average production of coalbed methane wells increases at first and then decreases,reaching the highest production at 0.02 m-1 of structural curvature.Therefore,structural curvature can be an important index for potential evaluation of coalbed methane development and provide a basis for siting coalbed methane wells.     

6-PRRS并联机器人的动力学建模研究

为解决并联机器人动力学模型的计算复杂性与实时准确控制之间的矛盾,采用虚功原理建立6-PRRS并联机器人各构件随参数变化的完整动力学方程,对6-PRRS并联机器人动力学模型在各种工作情况下进行仿真分析,对机器人各部分质量和转动惯量对驱动力的影响进行研究,提出动力学模型简化策略,减小了动力学计算量,提高并联机器人动力学的计算速度,为并联机器人的控制和参数识别奠定了基础.     

集中供热系统适量供热调节技术

集中供热的采暖用户实行计量收费并且具有自调节能力以后,必须要有与用户调节相匹配的运行调节手段,才能实现系统的适量供热.结合集中供热常用的系统形式,分别分析用户、热网及热源在各种运行方式下的调节特性及节能潜力,得出室内系统变流量、循环水泵变转速运行时节能量最高,并给出循环水泵定转速运行及变转速运行下的控制系统方框图.最后指出,应该针对新型供热系统和旧有供热系统的特点,制定相应的整体综合调节策略,才能实现节能最佳.     

压电双晶片型旋转精密驱动器动态特性和控制

提出了以自由端带有集中质量的悬臂式压电双晶片为驱动单元的新型冲击式旋转精密驱动器.制作了驱动器样机,建立了基于Lugre摩擦模型的驱动器动力学模型.对驱动器动态特性进行了仿真分析和实验对比研究.根据驱动器的动态特性,提出了冲击式压电双晶片型精密驱动器特定的定频调压控制方法.仿真分析结果和实验结果吻合较好,表明该动力学模型符合驱动器的动态特性,可用于对冲击式压电双晶片型旋转精密驱动器的理论分析.     

变电站远程监控系统研究

研究了分布式Web计算技术开发远程监控系统的关键技术,就基于IP网络实现变电站远程监控的主要思路和技术问题进行说明和分析讨论.从信道带宽、网络机制、远动协议、信息安全等多方面讨论了IP网络传输时保证远动QoS的措施方法以及IP网络传输对信息安全的防护措施.     

环境镉致肾损伤与槲皮素应用时间的研究

实验研究了镉致急性肾损伤及槲皮素对肾损伤的保护作用.将雄性Wistar大鼠随机分成对照组、镉组、槲皮素治疗组,分别对各组大鼠进行生理盐水注射、氯化镉注射、氯化镉注射加槲皮素灌胃,然后测定镉致肾损伤指标:尿蛋白含量、血尿素氮(BUN)、尿乙酰氨基葡糖苷酶(NAG)、尿γ-L-谷氨酰转肽酶(γ-GT)、尿金属硫蛋白(UMT).研究结果表明:镉组与对照组相比,肾损伤指标含量显著增高;槲皮素治疗组与镉组相比,肾损伤指标含量显著降低,且随着应用槲皮素时间的增加,肾损伤指标含量逐渐恢复.因此,镉能够导致肾损伤,而槲皮素对镉致大鼠急性肾损伤具有保护作用,且其保护作用具有时间依赖性.