305酯在船用PVC电缆料中应用研究

用305酯（双季戊四醇酯）增塑剂与其他添加剂配合使用，部分取代TOTM（偏苯三酸三辛酯）生产船用105℃PVC（聚氯乙烯）电线电缆料，并对其电性能，浸水后电性能等进行测试分析。结果表明，305酯为主增塑剂剂时，与4～5份的TCP（磷酸三甲酚酯）并用可以显著改善电缆料浸水电性能。在配方中应用二盐基性苯二甲酸铅和二盐基硬脂酸铅作稳定系统，更能保证电线电缆料浸水电性能的稳定。     

水中苯胺类化合物检测8-羟基喹啉试剂盒的研制

本文提出一种能方便、快速、灵敏地检测水中苯胺类化合物的试剂盒。该方法是以N -氯代丁二酰亚胺和 8-羟基喹啉与苯胺的显色反应为基础。显色反庆所得的蓝绿色化合物的最大吸收波长为 6 1 0nm ,在苯胺为 0 .2～ 8mg/L的浓度范围内符合比尔定率 ,最低检出限为 0 .0 1mg/L ,测定的重现性在± 5 %以内。本方法已成功地用于环境水样的分析测定     

水中苯胺类化合物检测1—萘酚试剂盒的研制

本文提出一种能快速灵敏地检测地面水和污水中苯胺类化合物的试剂盒。该方法是以 N-氯代丁二酰亚胺氧化苯胺 ,在 p H9- 1 1的碱性介质中 〔1〕,以 1 -萘酚偶联显色。显色反应所得的蓝色化合物的最大吸收波长为 61 0 nm,在苯胺浓度为 0 .2～ 8mg/L的浓度范围内符合比尔定律 ,最低检出限为 0 .0 2 mg/L ,测定的重现性在± 5 %以内。该试剂盒用于合成水样和环境水样的分析 ,回收率在 94.9～ 98.2之间。这种试剂盒可以成功地用于合成水样和环境水样的分析     

Preparation and rheology of polyamide-6/attapulgite nanocomposites and studies on their percolated structure

The polyamide-6/attapulgite nanocomposites were prepared via an in situ polymerization route with attapulgites pre-modified with cetyltrimethylammonium bromide (CTAB) and toluene-2,4-diisocyanate (TDI). Morphology observation showed that the exfoliated attapulgite fibers were well dispersed in the polyamide-6 matrix on a nanometer scale and formed a percolation network structure. The rheological behaviors of such polymer/fibrous clay nanocompostie samples were investigated by an ARES rheometer with parallel plate geometry. The storage moduli (G′), loss moduli (G″), and dynamic viscosities of these samples increased monotonically with attapulgite content at low frequencies. The presence of attapulgites caused these nanocomposite melts to have solid-like behaviors and slower relaxation. This behavior can be explained in terms of the development of a grafting-percolated fibrous-silicate network structure. Monte Carlo simulations were performed to determine the critical threshold for attapulgites fibers in 3D. The calculated critical threshold from simulations fitted the results of our rheological experiments very well.     

On the oxidative coupling of methane with carbon dioxide over CeO2/ZnO nanocatalysts

The nano-CeO₂/ZnO catalysts were prepared using a novel combination of homogeneous precipitation with micro-emulsion for oxidative coupling of methane with CO₂ as an oxidant. The prepared catalysts were compared with those prepared using the conventional impregnation. The catalysts prepared in two ways were characterized with FTIR, TEM, XRD and CO₂-TPD. The effects of the reaction temperature, the amount of ZnO doped in the catalysts and the average size were investigated. The experimental investigation demonstrated that methane conversion over the nano-CeO₂/ZnO catalysts prepared by the combined technique was higher than that obtained over catalysts prepared by the conventional impregnation. A better low-temperature activity has also been achieved over the nanocatalysts. There was no clear trend between the average size of nano-CeO₂/ZnO catalysts and their catalytic performance but methane conversion increased with increasing fractal dimension of nanocatalysts.     

航空胶片显影液调整的计算机处理方法

为解决航空胶片显影液调整问题，采用了Visual Basic6.0开发了“显影液化学分析调整软件，该系统具有一定的应用价值。     

低温快烧无铅精陶釉的研制

采用高温熔融法制备了适用精陶的低温无铅熔块，并应用热膨胀分析仪、SEM等方法研究了精陶釉的光泽度、热稳定性、热膨胀系数等性能。结果表明：采用Li2O，SrO，B2O3等复合熔剂，可以制备出光泽度高，热稳定好，坯釉膨胀系数匹配，结合良好，适于低温快烧工艺的无铅精陶釉。     

Synthesis and characterization of superabsorbent hydrogels composites based on polysuccinimide

A kind of novel superabsorbent hydrogel with high swelling ratio property that could be used for the development of water absorbing resin, soil water retention agent, and chemical sand‐fixing material was synthesized in this study. The hydrogels were prepared by the crosslinking reaction of polysuccinimide (PSI). The relationships between swelling ratio and volume of solvent as well as the concentration of crosslinking agent were investigated in detail. Several composites, such as starch, carrageenan, and polyacrylamide, were added into hydrogels to enhance the swelling ratio. It was found that the swelling ratio was significantly increased, which the maximum water absorbency was enhanced 2.46 times when the composite polyacrylamide (PAM) was added compared to the control. The effects of ionic strength and sensitivity of pH on hydrogels were also studied. The modified hydrogels products with swelling ratio less sensitivity to the salinity as well as relative high swelling ration in salinity system were also obtained by adding PAM. Through the Fourier transform infrared spectroscopy (FTIR) characterizations, the crosslinking reaction mechanism and the structure of composite were proposed. In addition, the transmission electron microscopy (TEM) examinations showed that some composite materials elevated the physical crosslinked and connected channels density substantially. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 550–557, 2006     

Decane reforming reaction over Pt,Ir, Pt-Ir and Pt-Ni bimetallic catalysts supported on Y-zeolite

Pt, Ir, Pt-Ir and Pt-Ni bimetallic catalysts supported on NaY- and HY-zeolite were examined as a catalyst for producing gasoline from n-decane via simultaneous reforming and cracking. The catalysts were prepared by calcining and reducing metal-ion-exchanged Y-zeolite with O₂ and H₂ at 300°C., respectively. Thus prepared catalysts were characterized by hydrogen chemisorption and temperature programmed desorption of ammonia. Pt-Ni/NaY and Pt-Ir/NaY bimetallic catalysts offered the improved activity maintenance compared to Pt/NaY monometallic catalyst. The catalysts supported on HY-zeolite showed higher selectivity toward C₅–C₇ and skeletal isomers of C₅–C₇- and C₈–C₁₀ than those of the catalysts supported on NaY-zeolite, which is a desired characteristic for increasing octane value of gasoline these days. However, deactivation with reaction time was much more pronounced on HY-zeolite-supported catalyst. When the catalyst was prcsulfided with H,S, the stability with time on stream was enhanced and the selectivity was quite different from that of the catalyst before presulfiding. The acidity of Y-zeolite and presulfiding of catalyst greatly influenced the activny, selectivity and stability of Pt, Ir, Pt-Ir and Pt-Ni bimetallic catalysts supported on Y-zeolite in n-decane reforming reaction.     

Role of La2O3 in Pd-Supported Catalysts for Methanol Decomposition

Systems of Pd supported on various La₂O₃-modified -Al₂O₃ and CeO₂–Al₂O₃ catalysts were tested for catalytic methanol decomposition and characterized by means of XRD, BET, TPR, H₂-chemisorption and CO–FTIR. The addition of lanthanum significantly improved the selectivity of CO and H₂ for all the catalysts but showed a different influence on the catalytic activity in two systems. Methanol conversion decreased on La₂O₃-modified Pd/-Al₂O₃ catalysts, in line with the reduction of Pd dispersion, while the addition of La₂O₃ improved the dispersion of Pd and reinforced Pd–CeO₂ interaction for La₂O₃-modified Pd/CeO₂–Al₂O₃ catalysts, which resulted in a high production rate of CO and H₂. Thus, a synergistic effect between CeO₂ and La₂O₃ was observed on -Al₂O₃-supported Pd catalyst for methanol decomposition.